电阻分量

The investigation shows that data of tipper and apparent tipper obviously reflect the inhomogeneity of horizontal direction of medium-electric resistivity, particularly the fault. So the data of frequency range apparent tipper calculated by high-quality four-component observation data can be used in identifying the position, inclination and scale of fault.

研究结果表明：倾子和视倾子资料对介质电阻率水平方向的不均匀性，特别是对断裂反映明显；应用质量较好的四分量观测数据计算出高频段（频率大于1Hz）的视倾子资料，可以用来判断断裂的位置、倾向和规模。

The results show that in subsynchronous frequencies range the transmission line compensated by the SSSC causes a resonant impedance effect similar to that caused by the fixed capacitors. But the value of the capacitive reactance exhibited by SSSC is smaller than that of the fixed capacitors and the additional resistance component is exhibited by SSSC.

研究表明：次同步频率下串有SSSC支路的阻抗特性与串有等值电容支路的阻抗特性相似，但SSSC所呈现的容抗小于固定电容的容抗，且SSSC还呈现较大的电阻分量。

This paper shows the mathematic models and the calculation methods of the transient simulation in port equation form with full consideration of the periodic part and the nonperiodic part of the short circuit current and put the transformer, transmission line and the infinite power source in consideration. In resistance style fault it has perfect flexibility.

本文在充分考虑到短路电流的周期分量、非周期分量及带有变压器、线路和无穷大电源的情况下，给出了端口方程方法的机网暂态仿真研究数学模型和求解方法，结合电阻型故障模型，使故障仿真具有很强的灵活性。

MATLAB language is used to develop the computer simulation program by means of the dynamic mathematical model of three - phase induction motors in phase quantities, The program is applied to series asymmetrical resistance starting operation process of three - phase cage - type induction motors in one phases or two phases of the stator circuit.

为了得到起动特性，根据三相异步电动机在相坐标系下的瞬态数学模型，编写计算机仿真程序，通过实例对三相笼型异步电动机的定子电路一相串联电阻以及两相串联电阻时的起动过程进行仿真计算，对仿真结果进行比较分析；用对称分量法分析定子电路一相串联电阻以及两相串联电阻时的不对称系统，初步计算起动电阻的数值，然后通过计算机仿真的调整来较准确地加以确定。

As to concrete treating method, the thesis adds the components in third dimension to the original 2D MHD code, and inward flows are embedded along the side of the current sheet, through changes of certain flow's scale, its distance to the current sheet, the viscosity coefficient and the resistivity in the plasma, the magnetic field figure, the velocity vector figure and the density distribution figure with different situations would be showed and observed, the reconnection growth rate figure is to be presented also, and the physical explanation involved will be made consequently.

在具体的处理方法上，文章在原有二维MHD流体理论基础上加入第三方向的分量，并且在电流片两侧加入入流扰动，通过改变其大小，距离电流片的位置，等离子体中的粘滞系数和等离子体电阻率，从而观察不同扰动情况下磁场重联的磁场位形、流场位形或者密度分布，绘制出磁场重联增长率在不同入流扰动下的图像，并分析其中的物理过程。

Based on an analysis of the frequency sounding curve of the CSAMT method (controlled source audio-frequency electromagnetic method), the authors have found that the curve intersects the curve in the transition region.

通过对卡尼亚视电阻率法频率测深曲线的分析，发现卡尼亚视电阻率与远区电场分量E的视电阻率曲线在过渡区出现相交的现象。

Compared with the conventional electric methods,the Controlled source audio-frequency magnetotellurics method is featured of large prospecting depth,portable equipment and high lateral resolution.

上世纪五十年代，在卡尼亚(L Cagn-iard)论文[1]的基础上，发展形成了基于观测天然场大地电场和磁场正交分量，计算视电阻率的大地电磁测深方法。

On the basis of studying EH-4 data processing, we ase a menthod to read time-sires file correctly, adopt periodogram means to recalculate auto-power spectrum, cross-power spectrum and tensor impedance component, and recalculate resistivity depend on tensor impedance component. We compile proprietary softwareEH-4 Data Processing Program.

本文在剖析EH-4系统数据处理流程的基础上，正确地读取了EH-4系统原始时间序列文件，采用周期图方法重新计算了自功率谱、互功率谱和张量阻抗分量，以及由阻抗定义的视电阻率，编制了专用软件EH4 Data Processing Program。

According to the characteristics of field dis tribution, a method to abstract quadrature component and amplitude of vertical magnetic field in near-field zone is proposed. Based on the dual-fre. quency combi nation wave theory, apparent resistivities with various forms at center and any point in near-field zone of current loop on stratified earth are defined.

根据场分布的特征，提出了在近区提取磁场垂直分量的正交部分和磁场垂直分量的振幅作为研究对象的方案；根据双频组合波理论，利用它们所对应的双频差，给出了载流回线中心点和近区任意点的视电阻率不同形式的表达式。

According to the characteristics of fault current sequence component on six-phase transmission lines, the paper proposes a novel fault phase selection scheme. The scheme can accurately distinguish the faulted phases under various fault conditions, and can be free from the influences of the transition resistance and system parameters.

2综合六相输电线路故障电流序分量的幅值和相位特征，提出了一种适用于六相输电线路的故障选相方案，该方案在各种故障情况下都能做到准确选出故障相，并且还有不受线路参数变化和接地电阻影响的优点。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。