电路的

Firstly, convergence condition of a binomial is discussed, and along with the calculating formula of region of convergence, the matching band of fractance circuit attained by binomial expansion method is indicated definitely.

首先讨论了二项式的收敛条件，并结合收敛域的计算公式，明确指出使用二项展开法所得到的分抗电路的逼近带范围。

The use of engineering workstations in the design and simulation of digital hardware circuitry have,in many cases,removed the need for the breadboard phases of the design process,especially where ASlCs are concerned.

The利用工程工作站的设计与仿真的数字电路的硬件，在许多情况下，取消了需要breadboard各阶段的设计过程中，尤其是在ASlCs是concerned。

This paper gives out the principles and improving schemes of transformer discharge equipment and resonance booster discharge equipment. By detecting the current in the main circuit, the gap's breaking-down can be identified, and the single chip micro-computer will send out corresponding control signal to make the IGBTs to switch off or cut off the input voltage, by this mean, we can make sure that every time of the experiment, the sample will discharge only once. The paper also introduces the principle of the protection circuit. At last, the experimental waveforms were listed, which prove the feasibility of the high voltage discharge fast switch-off device.

该文给出了变压器和谐振升压器2种高压放电试验装置的原理以及改进方案，通过检测主回路电流大小判断间隙是否被击穿，由单片机发出相应控制信号，采用IGBT等开关器件控制试验电压的通断，保证了试品每次试验只进行一次放电，介绍了保护电路的原理，给出了试验波形，证明了此高压放电速断装置的可行性。

In such circuits control of the output current is required and this is sometimes achieved by replacing some of the diodes in bridge rectifier with thyristor s, whose voltage output can be regulated by means of phase fired controllers .

在这种电路的输出电流控制是需要和这有时通过一些在桥式整流二极管的替换的晶闸管，可以触发相位控制器的方式规管其电压输出。

It is important to buffer the output of this circuit to assure that switching spikes from the first counter or prescaler do not end up in the oscillator spectrum.

电路的输出端确保从第一个计数器或分频器来的开关尖峰，不会扰乱振荡器的波形，这对缓冲器来说是很重要的。

During the design, Cadence CAD tools are used throughout the project.

在电路的设计中，使用的是Cadence中的一系列的CAD工具。

Then it recommends the refrigeration principle, basis of controlling circuit model, calculating formulation of air conditioning state parameter.

然后文章介绍了制冷基本原理、基本控制电路的模型、空调系统状态参数的计算公式和应用、空调系统的概述和分类，从理论研究上为设计工作做好了充分的准备。

Measurement results have successfully confirmed the correct functions and performance of the semi-cylindrical capacitive sensor with interface circuit using for flow rate measurement on the LCD panel coating machine.

量测的结果已经成功地验证了半柱状电容感测器与其界面电路的功能与成果於液晶面板的涂胶机器的流量量测上。

Actually ,signals are processed from low frequency domain to high one by modulation firstly and alternating current amplification secondly.It can also improve anti-interference抗干扰 ability of circuit and signal to noise ratio of signals.

实际中往往采用更有效的先调制而后交流放大，将信号从低频区推移到高频区，也可以提高电路的抗干扰能力和信实际中往往采用更有效的先调制而后交流放大，将信号从低频区推移到高频区，号的信噪比。

This adds another degree of freedom and complexity to the design process as well as speed and area.

低功耗技术对提高VLSI的可靠性、降低封装成本及提高产品的市场竞争力都有着重要意义，功耗对电路的影响使它成为了集成电路设计中的第三维目标。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。