电路的

The circuit possesses many properties of current-mode circuit. Its sensitivity is lower, and its pole angular frequency and quality factor can be tuned accurately and independently, and the circuit is very easy in this process.

该电路不仅具有电流模电路的特点，而且其无源灵敏度低，电路简单；品质因素、极点角频率取决于电容比值和电阻比值，从而可实现二者的独立、精确调节。

The experimental results have shown that the impact of TFT threshold-voltage variation on the biasing circuit can be reduced from 30% to 5% under biasing voltage of 3 V.

因此，在第六章中，本论文提出具有临界电压补偿功能之偏压电路设计技术，此技术可以大幅降低元件的变动对偏压电路的影响，提高类比电路在玻璃基板上之可行性。

In the analysis of combinational logic circuit, should take into account gate delay time of the impact on the circuit.

在分析组合数字逻辑电路时，应该考虑门电路的延迟时间对电路产生的影响。

The main circuit is made up of compounding of Boost and the full-bridge circuit.

其主电路构成采用的是Boost电路和全桥电路的组合。

A novel circuit with a narrow pulse driving structure is proposed for enhancing the noise immunity and improving the performance of wide fan-in dynamic circuits.

提出了一种利用窄脉冲发生器驱动输出级，以提高电路抗噪声能力，同时保持动态电路的高速特性的多输入动态逻辑电路。

There are some problems or indistinctness in some textbooks, so students often make mistake s in understanding and experiment.

RLC串联谐振电路是电工学的基本电路之一，由于一些教材或讲义存在问题或讲述不清，使学生常常会在实验时出现一些错误，导致实验结果不正确或不准确，严重时还将造成仪器设备和实验电路的损坏。

Then, the transfer characteristic of the input unit cell is simulated and the testing results of an IRFPA interconnected with this ROIC are given at last.

首先对该电路结构及工作原理进行分析，并对输入级等电路的传输特性进行仿真验证，最后给出探测器阵列与读出电路芯片互连后的测试结果。

During the design process of low voltage equipments using flow chart and state matrix , the distributing control functions using Karnaugh map can satisfy the demand for the design of sequential circuits with/without intermediate states.

用流图法和状态矩阵设计低压电器电路时，卡诺图法分配控制函数能较好满足无过渡态和有过渡态的时序电路设计。本文分别给出了两种电路的设计实

Base on the principle, the main circuit and control circuit of 2-phase hybrid stepping motor systems are designed. The system can realize many functions such as fix-frequency pulse width modulation, current sampling, power magnifying, ring distribution, producing control signal, and so on.

完成了对二相混合式步进电动机微步驱动系统主电路及控制电路的具体设计，实现了恒频斩波、信号检测、环形分配、微步信号的产生等功能，并搭制了实验电路进行实验验证。

Optimizations on the circuit design of the existing parallel manipulator and the translation of signs between the modules are executed.

优化了现有并联机器人控制电路的设计，使得电路模块布局布线更加合理，也优化了信号在电路各模块之间的传递。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。