电路的

Due to the scale-down of the process technologies, the operating frequency and circuit complexity of CMOS VLSI increase significantly.

由於制程技术的进步，CMOS积体电路的操作频率及电路复杂度也随著增加。

The fundamental configuration of the main circuit of series power quality compensator is proposed and its design scheme of the main circuit is analyzed based on the development of an experimental prototype.

文中介绍了串联型电能质量补偿器主电路的基本结构，结合实验样机的研制对主电路各部分设计方案进行了分析比较。

Based on the analysis of some configurations of the lossless snubber circuit, a lossless snubber circuit topology is proposed, corresponding theoretical analysis, simulation and experiment on IGBT is carried out.

在对已有的无损耗缓冲电路分析基础上提出了一种适用于IGBT的谐振无损耗缓冲电路的拓扑结构，并进行了理论分析和实验研究。

The difference amplifier is the complement of the summing amplifier and allows the subtraction of two voltages or, as a special case, the cancellation of a signal common to the two inputs.

差分放大器是对求和电路的发展，这种电路可以减小甚至去处两个输入信号中的共模成分。

The application of tensor analysis techniques leads to an efficient and easy method of dealing with the varying topology of the circuits.

介绍用张量分析法对机车主电路进行的仿真，应用张量分析技术易于处理电路的变拓扑结构。

Related technology is also researched.Finally,the thermobattery and the booster and steady voltage circuit module are tested by experiments,the result shows that the charging start-up voltage of booster and steady voltage circuit is0.911V,current is70mA.Output power reaches the maximum when equivalent internal resistance of semiconductor thermobattery series-parallel connection matches with load resistance.

并研究了工艺，最后通过试验测试温差电池组和升压稳压电路，结果显示升压稳压电路的充电启动电压为0.911V，电流为70mA，当半导体温差电池串并联的等效内阻和负载电阻匹配时输出功率达到最大。

By rational configuration of the low voltage solid circuits and hydrogen thyratron circuits,long precise delay and low jitter of high voltage output can be obtained.

采取低压固体电路与大小氢闸管电路的合理配置，较好地解决了精密长延迟和高压脉冲输出时低延迟时间晃动的难点。

Optimization of transconductance pair and proper DC bias of input stage are key problems in the design.

本文中对前级电路加以改进，实现了混频器输入级的直流偏置，完成了电路的设计和仿真。

The technology principle and circuit realization are introduced for pulse signal transmission through single cable .

介绍了用单芯电缆传输脉冲信号的技术原理和电路实现，分析了实现电路的耐压性能和传输性能。

Design and optimization methods of low dropout voltage regulator are studied through the analysis of their topology and operational process.

研究了电容式电荷泵电路的基本类型和动作原理，建立了一个理论模型，给出了电荷泵电路的性能评估方法。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。