电路

One high-speed buffer circuit is added to the volume potentiometer to eliminate its influence on frequency bandwidth of the bridge circuit.

1，在音量电位器后增加一级高速缓冲电路，杜绝由于音量电位器对后级电路的频率带宽影响，音量控制方式使用并联型，有效提升音质，也降低了对电位器的要求，降低成本。

A combinational circuit that has three inputs that are an augend, D, an addend, E, and carry digit transferred from another digit place, F, and two outputs that are a sum without carry, T, and a new carry digit, R, and in which the outputs are related to the inputs according to the following table.

一种组合电路，有三个输入端和两个输出端；三个输入端是：被加数d、加数e以及从另一个数位传来的进位数f；两个输出端是：无进位和数t及新的进位数r。电路的输出和输入的关系如下表所示

Core saturation and the rotor bar skin effects were directly taken into account in the field calculation. The adopted circuit equations are suitable for describing the stator windings and the special rotor-bar connections of BDFM. The waveform of supplied voltage source may be an arbitrary. Three-dimensional end effects were considered in the circuit parameter corrected by classical formulas. In addition, the coupling and constraint equations were used to handle rotor rotation without any process of remeshing.

其特点是：铁心饱和以及转子导条集肤效应可以直接在场的计算过程中加以考虑；采用的电路方程可以方便地处理无刷双馈电机定子绕组和转子端环的各种特殊连接方式，电压源可以是任意电压波型；三维端部效应可以通过传统的方法在电路参数中加以修正；采用耦合与约束方程来处理转子转动问题，而无须不断地对转子重新进行刨分。

The additional error in measuring the slope of C~(-2)- V curve is further discussed.

在Q表上用四种小讯号频率测量了TTL电路和某些线性电路外延片的C~(-2)-V曲线。

First it produces the pulse signal by the multivibratorwhich is consisted of 555 timer and send in the detecting coil to form the alternating magnetic field, then it asopts UGN3503 linear half-effect as prode to the magnetic field change into the voltage signal change,after enlargement electric circuit and peak value examination electric circuit,the signal be treated to send into ADC0809 modulus converter change moduluses, then the digital signal after the modulus converter is changed is sent into AT89C51one-chip computers afterwards, after the digital filter, AT89C51one-chip computers afterwards compares the data to the reference voltage and judges whether to have detected the metal and alarm.

这个系统是以AT89C51单片机为核心，首先由555定时器构成多谐振荡器产生脉冲信号送入探测线圈以形成交变磁场，然后经过线性霍尔器件UGN3503将磁场变化转换为电压信号的变化，经过放大电路和峰值检测电路，经数模转换之后输入到单片机中，由单片机对数据进行软件滤波之后，与基准值比较之后，判断是否存在金属和报警显示。

To start with, you need to break the circuit so that the ammeter can be connected in series.

考虑到更改，为了串联入电流表你必须有一个实验电路；开始时，你需要断开电路，以让电流表可以串入。

For this reason, the analog circuits of the data driver are the focus in my works.

也由於这个原因，在本论文中将著重於资料驱动电路中的类比电路设计。

For this reason, the analog circuits of the data driver are focused in my works.

也由於这个原因，在本论文中将著重於资料驱动电路中的类比电路设计。

Analog to Digital Converter is the interface of analog and digital circuit, its use is very extensive.

模数转换器是模拟电路和数字电路的接口，其用途非常广泛。

All these analyzation are useful to guide the circuit design and help to optimize the circuit design and save power.

这些分析指导了后续电路的设计，并优化了整体调制器电路的性能和功耗。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。