电路

The delay of a circuit depends not only on its topological structure, but also on its functionality and the inputs.

电路的延时不仅与电路的拓扑结构有关，而且还与电路的逻辑功能及输入都有密切的关系。

Including the low-pass filter circuit and Operation Transconductance Amplifier circuit design.

包括低通滤波电路，跨导运算放大电路电路的设计。

Working process of BOOST circuit contains transient and stable working state.

BOOST电路的工作过程包括电路启动时的瞬态工作过程和电路稳定后的稳态工作过程。

Adopting discrete time-domain method to set up the mathematical model of high-voltage conversion circuit, and analyzing the influence of frequency, duty cycle, primary inductance, different turns ratio parameters how to affect high-voltage convertion circuit charging time.

采用离散时域方法建立高压转换电路数学模型，分析了高压转换电路频率、占空比、原边电感量以及匝比等设计参数对高压转换电路充电时间的影响，并进行了仿真和实验验证。

The quantum effect of mesoscopic inductance-capacitance coupled circuit with mutual inductance was investigated by canonical transformation and unitary transformation.

利用正则变换和幺正变换的方法研究了有互感的介观电感电容耦合电路的量子效应，并把介观电感电容耦合电路和另外几种耦合电路进行了比较。

Why audio buffer needs only one stage while video buffer needs two stages for amplification?

为何音频电路仅需要单级放大电路，而影像电路必须两级反向。

Elect hardware, and design current to voltage translation circuit, voltage amplification circuit and acoustic-optic alarming circuit.

对硬件进行了选择，对电流/电压转换电路？电压放大电路和声光报警电路进行了具体设计？

Mainly by the design of infrared sensors, signal amplification circuit, voltage comparator, delay circuit and the audio alarm circuit.

本设计主要由红外线传感器，信号放大电路，电压比较器，延时电路和音响报警电路组成。

First of all, the circuit output waveform in the case of losing it by measuring the input voltage and output voltage in order to detect amplification of analog circuits, and then by adjusting the frequency of AC voltage source to reduce the output gain make 3db analog circuits in order to measure the maximum cut-off frequency, pass band can be obtained.

本电路首先在输出波形不失真的情况下通过测量输入电压和输出电压从而测出模拟电路的放大倍数，然后通过调节交流电压源的频率使得输出增益减少3db从而测量出模拟电路的上限截止频率，即可求出通频带。

Circuit system used varistor constitute the Wheatstone bridge to collect small changes in voltage, After amplification circuit amplified into A / D converter circuit, the input voltage digital signal after the conversion output AT89S52 conducted by the control and data processing and results in the LCD display.

系统电路采用压敏电阻构成惠斯登电桥来采集电压的微小变化，经过放大电路放大后送入A/D转换电路，对输入电压信号进行数字量的转换后输出，由AT89S52进行系统的控制和对数据的处理并将结果显示在液晶显示器上。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。