电路

Put-down , squelch circuit , squelcher , takedown

静噪电路，静噪电路，噪声抑制电路

Trigger circuit by adjusting the phase of the trigger pulse to control the on-off thyristor, which can be manually controlled to adjust the output voltage, and then, after step-down transformer can be used to obtain the magnetization of the magnetic low-voltage high-current power supply, mainly by the SCR the main voltage regulator circuit, trigger circuit, such as composition, is a broad application prospect of the exchange regulator controller.

通过调节触发电路的触发脉冲的相位来控制晶闸管的通断，从而控制输出得到可人工调整的电压，再经过降压变压器得到可用于磁化的低压大电流磁化电源，它主要由可控硅调压主电路、触发电路等组成，是一种具有广阔应用前景的交流调压控制器。

The novel UHV-FTRTPS is composed of uncontrolled rectifier, H bridge inverter, step-up transformer and series resonant circuit.

整个装置由不可控整流电路、H桥逆变电路、升压变压器及串联谐振电路组成。

And then, the contiunous current modeof this circuit is discussed, and the PWM circuit and over-current -protection circuit are designed. At the same time, the calculation methods of storage inductance, output capacitor and sampling resistor are given.

讨论电路的电流连续工作模式，设计了电源的脉宽调制电路和过流保护电路，并给出了蓄能电感、输出电容和输出电压取样电阻的确定方法。

Because of the great effect of the stray capacitance and stray inductance under the high frequency, both the analysis methods and design applications of the high frequency show different from the one of low frequency circuit.

在高频条件下，杂散电容和杂散电感对电路的影响非常大，所以射频电路无论是分析方法还是设计应用都与低频电路存在很大的不同。

The results already known show that if the constitutive relations of t he elements included in the circuits are strictly increasing and one to one mapp ing, then the circuits will have unique steady state under certai n conditions.

冯平目前已有的研究结果表明，如果电路中元件的成分关系是单值的并且是严格递增的，则对于不同的电路可以得到不同的保证电路具有唯一稳态的条件。

The Difference Amplifier 差分放大器: The difference amplifier is the complement of the summing amplifier and allows the subtraction of two voltages or, as a special case, the cancellation of a signal common to the two inputs.

电路见图5，这种电路在运算电路中相当有用，比如差分对单端的转换，抑制共模信号。

A double-T frame trap filter which contains a positive feedback is designed percolate syntonic of power frequency.Base on Butterworth function a high-pass and a low-pass filter...

通过Mu ltisim软件对所设计的陷波电路和滤波电路进行频响特性仿真，得到的频响特性曲线表明：所设计电路可成功滤掉工频干扰和母体噪音干扰。

Design DC/DC circuit using converter module. At last we give the accurate circuit using TL1451 and give the important testpoint's waveform.in term of the frame of the digital camera.

论文最后根据数码相机驱动电路的机构，设计出由具体芯片构成显示驱动电路和详细分析了所设计驱动电路的工作原理。

A new energy recovery logic style (ERTL: energy recovery threshold logic) based on threshold logic is presented.

2通过把阈值逻辑应用在能量回收电路中，提出了一种新的电路形式－能量回收阈值逻辑电路（ ERTL ： energy recovery threshold logic ）。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。