电路

Detailly,signals of background magnetic field is filtered by fixed frequency of sample and hold circuit which is supplied by logic circuit,and the signals before objects appear are tracked dynamically which are then compared with the ones after objects appear by comparator circuit,in order to furthest obtain the signals of target magnetic field on the basis of background magnetic field compensation.

运用逻辑脉冲电路为采样保持电路提供固定频率滤除背景磁场信号，并对目标未出现时的信号进行动态跟踪，运用比较电路将目标出现前后的信号进行比较，从而在补偿背景磁场的基础上最大限度地获得目标磁场的信号。

In the system, a finepositioning window signal generating circuit redundant, sample and hold circuit of positioning error signal using no traditional charge/discharge method but high-speed switches and operational amplifier integrators, and cross-zero detector with threshold for higher reliability, is originated by the author in this paper.

综合面伺服和扇区伺服的各自优点，设计完成了4000 TPI光刻伺服解调系统：在设计中，首创了带冗余的精定位窗口信号生成电路，采用高速模拟开关和运放积分电路代替传统的电容充放电法，以完成精定位位置误差信号的平均与采样保持，使用带阈值的过零检测电路提高过道脉冲的可靠性。

A charge pump phase locked loop based on self biased technique is presented. In this technique, the operating bias levels are essentially established by the operating frequency of the voltage controlled oscillator, namely, all bias voltages and currents are determined by VCO controlling voltage. Thus, a fixed damping factor and a fixed ratio of the bandwidth to operating frequency are obtained, which are defined by th...

给出了基于自偏置技术的电荷泵锁相环电路，压控振荡器的工作频率动态地建立了电路内部所有的偏置电压和电流，从而实现了固定衰减因子，固定环路带宽与工作频率之比，这二者由电容的比率决定，极大地实现了电路设计的工艺无关性，同时也得到了小的相位抖动，最后，对这种锁相环的稳定性进行了一定的分析。

According to the start-up problem,the two soft start-up circuit structure and theory are introduced in detail in the paper,such as self-excitation soft start-up circuit and based on CD4046 soft start-up circuit.

针对中频电源启动问题，介绍了两种软启动电路——自激软启动电路和基于CD4046的软启动电路的构成和原理。

And design of all these modules was successfully fulfilled seriatim These modules can be reused in power management ICs as well as the power modules' in SoC. The inner circuits and applied circuits were optimized.

这些模块可在各种电源管理IC中复用，亦为电源管理IC和各种SOC电源模块设计积累了一定的基础；论文由芯片内部电路到外部应用电路，完成了电路设计的优化和系统的完善。

This paper has simply introduced the series resonance circuit principle of work and the electric circuit characteristic, and has used simulation teaching software Multisim carries on the analysis it.

本文简要地介绍了串联谐振电路工作原理和电路特点，并使用仿真教学软件Multisim对其进行分析，仿真结果与理论计算结果基本一致，说明了Multisim在电路分析教学中具有非常重要的意义。

We further perfected hardware interface designs such as system main controlling circuit, signal measuring circuit and control box. Also, we have simplified system circuit and improved precision of adding water and controlling, simplifying operation and maintenance of system and increasing possibility of mass production.

进一步完善系统主控电路和信号测量电路以及控制箱的改造等硬件接口设计，精简系统电路布局结构，提高系统的加水控制精度和操作的方便性，同时提高了系统的可维护性、批量生产的可能性。

In this paper, the design of a simple, low-cost walkie-talkie circuit and main circuit of the key components of the circuit is introduced

本文设计了一种简易、低成本的对讲机电路，对关键电路及主要的电路元件做了介绍。

By using the measure and research of the emulating two-port network parameters of using direct-current analysis and figure value output function of sinusoidal steady state circuit in circuit emulating sofeware PSPICE8.0,the measune and reseavch have solved the problem of the measuring purely resistive network of simple and odd one in traditional experimient,and also brought about the analysis of alternating current and direct-current for two-port network of any one complex and measure and research of Y、Z、T、...

利用电路仿真软件PSPICE8.0中直流分析及正弦稳态电路的数值输出功能仿真二端口网络参数的测量与研究，解决了传统实验中只能测量简单、单一的纯电阻网络问题，实现了对任一复杂二端口网络交、直流的分析及Y、Z、T、H等参数的测量与研究，为更多的不易完成的传统实验以及复杂电路的分析研究开辟了一条新路。

The debugging and simulation of sphygmograph circuit are carried based on Electronic Workbench.

利用电子工作平台对电子脉搏测量仪电路进行了调试和仿真，仿真结果表明：该电路设计达到了预期效果，证明了电路设计的合理性。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。