电路

A superimposed circuit derived from two suitably arranged pairs of wires called side circuits, with each pair of wires being a circuit itself and at the same time acting as one conductor of the phantom circuit .

一种由称作半边电路的两对线路经适当安排形成的叠加电路。每一对线本身既作为电路，同时又充当幻象电路的一个导体。

The hardware includes four parts: preposed circuit, sampling circuit, DSP circuit and display circuit. The software includes four parts: main program, FFT program, power algorithm program.

硬件分为四个部分，前置电路、采样电路、DSP电路和显示电路；软件也分四部分，分为主程序、采样子程序、FFT子程序和功率电能计算子程序。

The system consists of power supply circuit, circuit-level preamp, power amplifier circuit, output stage components.

该系统由电源电路、前置放大级电路、功率放大电路电路、输出级组成。

Also, we select the signal collecting circuit of three output polars, the coupling circuit using capacitance and resistance, the alternating amplify processing circuit, the positive feedback retardation comparsion, the driving circuit of output current and the stabilization voltage supply circuit.

选择了InSb磁阻三端输出型信号采集电路，阻容耦合型交流放大电路，正反馈迟滞型电压比较器和大电流推挽驱动电路及稳压电源电路。

Put forward an algorithm called PPSCRIPT (Parallel Pseudo Sequential Critical Path Tracing) for sequential circuit fault simulation, and implemented the algorithm in C language to improve the efficiency of sequential circuit fault simulation.

在时序电路的故障模拟方面作者提出了并行时序电路伪临界路径跟踪算法PPSCRIPT，并用C语言编程实现了该算法，使时序电路的故障模拟效率提高，时序电路的故障模拟是测试中期的问题。

The circuit system for the portable sealed tube neutron generator with neutron yield more than 1010n/s is described in this thesis. The ion source circuit, the reservoir circuit and the target high voltage circuit of this neutron generator are studied in detail.

论文对所研制的新一代便携式1010n/s中子发生器电路进行了全面的介绍，对离子源电路，存储器电路，特别靶极高压电路结构进行深入剖析。

The hardware of intelligent temperature controller based on ARM single-chip microcomputer was designed with the K-type thermocouple and MAX6675 as a temperature detection circuit, and a solid-state relay as a temperature control element. The main circuit was controlled using the switching characteristics of the solid-state relay t.

以ARM单片机为核心，设计并分析了电阻炉智能温度控制系统硬件电路，由K型热电偶和数字转换芯片MAX6675组成温度检测电路，采用固态继电器来作为温控元件，利用开关特性来控制电路的断开和接通炉温控制主电路。

In this paper, we present a low phase-noise oscillator circuit. The circuit of an inductor-capacitor tank oscillator is made on the chip. The 0.25μm complementary metal-oxide-semiconductor process parameter of Taiwan Semiconductor Manufacturing Company are entered into Advanced Design System software to simulate an LC tank oscillator circuit. Some circuit technology and an improved method for phasing noise are introduced.

此文提出一个低相位杂讯振荡电路，这电路完全实现於晶片上的电感电容压控振荡器，我们是把台湾积体电路的0.25μm的CMOS（互补式金属氧化物半导体）制程参数放入Advanced Design System模拟软体中模拟，在本文中我们介绍了一些电路技术和改善相位杂讯的方法。

A method to generate the bias voltage of infrared focal plane array is proposed,which use cascade weighted-capacitor network to scale charge on them.

以上研究证实了这种可集成在红外焦平面读出电路上的偏置电压产生电路是可行的，为下一步直接设计并制造包含偏置电压产生电路的焦平面读出电路芯片打下了坚实的基础。

In order to increase the occupating coefficient and reliability of digital experimental box,we improve its power supply by designing a simple,reliable overcurrent protecting circuit base on the analysis of its working principle .

设计了一个简单可靠的电源过流保护电路，分析了过流保护电路的工作原理，在此基础上改进了数字电路实验箱中稳压电源电路，提高了仪器的使用效率，增强了可靠性。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。