电路

This paper then compares three kinds of power conversion circuit applied in it and advances a main circuit which is based on IGBT's power grade nowadays and is applied in high power direct-driven grid-connected wind turbine. It is made up of a six-phase rectifier, two paralleled BOOST chopper circuits and two paralleled SPWM inverters.

文章在比较此种风力发电机的三种类型变流电路拓扑结构的基础上，提出了一种在考虑现有开关器件功率水平的情况下符合大功率直驱并网型风力发电机要求的变流电路拓扑结构，即采用&六相不控整流+两个并联的升压斩波+两个并联的三相SPWM逆变&的电路结构，并对其各部分电路的工作原理进行了分析。

This design is used for the control of the core SCM STC89C51 automatic drying rack, the system increases from SCM software PWM DC electromechanical drive L298 Road, humidity and photoelectric sensor signal acquisition circuit, LED display circuit, remote control receiver circuit, a power supply module .

本设计是采用STC89C51单片机为控制核心的自动晾衣架，系统由单片机PWM软件加 L298驱动直流电机电路，湿度和光电传感器信号采集电路，LED显示电路，遥控接收电路，电源模块构成。

This design is used for the control of the core SCM STC89C51 automatic drying rack, the system increases from SCM software PWM DC electromechanical drive L298 Road, humidity and photoelectric sensor signal acquisition circuit, LED display circuit, remote control receiver circuit, a power supply module .

本设计是采用STC89C51单片机为控制核心旳自动晾衣架，系统由单片机PWM软件加 L298驱动直流电机电路，湿度和光电传感器信号采集电路，LED显示电路，遥控接收电路，电源模块构成。

The paper discuss the main circuit and control circuit structure of the active power filter, according to the main circuit divided into two different kinds of structure that are four-phase convertor and three-phase convertor, this paper do deep research on each work theory and control circuit, provide each control method and DC side voltage control method.

论文讨论了在三相四线制系统中有源电力滤波器主电路及控制电路的构成，就主电路分别为四相变流器和三相变流器两种不同结构方式的工作原理和相应的控制电路进行了深入的研究，提出了各自的控制方法以及相应的直流侧电压控制方法。

PYX1-S type signal power supply panel is a special equipment for eight in formation automatic block with audio frequency shift modulated track circuits.It can supply power for signal lighting,track circuit,audio frequency shift relay circuit,approaching circuit,audio frequency shift control and detecting circuit.

PYX1-S型八信息移频电源屏是八信息自动闭塞的配套设备，可为信号点灯、轨道电路、移频继电器电路、接近电路移频控制检测电路提供电源。

By comparison and Fourier analysis of the waveshapes of the input current with different values of the inductor in the experiment, the valuable references are attained in the same type circuit design.

所以对电感值的计算就显得尤为必要。Boost型APFC电路中的升压电路部分不同于传统的Boost电路。传统Boost型电路的输入电压是直流电，在设计电感值时比较容易。

The proposed designs are realized using TSMC 0.18 um 1P6M CMOS process. The voltage supply is 1.8 V. The simulation tool used is HSPICE. According to our comparison, the proposed designs possess the advantages of lower power consumption and lower power-delay product.

电路是使用TSMC 0.18μm 1P6M制程来实作，电路的供应电压为1.8V，并用HSPICE 来进行模拟与分析，而实验结果证明本文所提出的新的低功率Compressor电路，跟相同性质的电路架构相比较后，有较低的功率消耗，以及较低的功率与延迟的乘积。

On the basis of the existing sieving method of sieving thyratrons, serving the typical fuze detonating circuit as the circuit of sieving thyratrons, and applying the operation conditions of the typical fuze detonating circuit in the sieving circuit, we can measure more accurately the turn on voltage, trigger voltage, turn on time, and leak of electricity of the thyratrons.

在现有闸流管检测方法的基础上，将实际的引信起爆电路作为闸流管的检测电路，将起爆电路的工作条件施加于检验电路，可以更准确地给出闸流管的导通电压、触发电压，同时测量出闸流管的导通时间以及闸流管在关断状态下的漏电流。

Nowadays the snubbers in IGBT inverters are traditional clamp RCD snubbers yet, which can convert some energy back to power supply so that the dissipation is low.

目前，在实际IGBT逆变桥电路中，缓冲电路大多还是传统的钳位式RCD缓冲电路，这种电路可以把能量部分回馈电源，故损耗相对较小。

A superimpose d circuit derived from two suitably arranged pairs of wires called side circuits,with each pair of wires being a circuit itself and at the same time acting as one conductor of the phantom circuit.

一种由称作半边电路的两对线路经适当安排形成的叠加电路。每一对线本身既作为电路，同时又充当幻象电路的一个导体。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。