电路

The design for impedance converting circuit of input current,transistor amplifying circuit and converting circuit of output current is presented.The telegrapher equations are adopted to determine the impedance of transmission-line transformer,which is used to convert circuit impedance between signal source and transistor.

讨论了放大器输入回路阻抗变换电路、晶体管放大电路以及输出回路阻抗变换电路的设计思想，运用电报方程从理论上推导出用于信号源和晶体管之间阻抗变换的传输线变压器输入输出阻抗计算公式，由此设计出模拟信号处理电路中非常重要的AB类高功率放大器。

Finally, several MTNCs were designed for implementing the XOR operation and Literal, AND, OR operation in ternary logic at switch level. The result of simulation with PSPICE showed that the designed circuits had not only the correct logic function and small propagation delay but also had simple structure. Whats more, when achieving the same logic function, the MTNCs decreased large amount of hardware expense compared with the STN circuits.

对设计出的电路进行PSPICE模拟并测量相关参数，结果表明，该设计方法不但简便、规范，而且设计出的多阈值神经元电路具有速度快，结构简单的优点，并且，在实现相同逻辑功能时，采用多阈值神经元电路相对于单阈值神经元电路，大幅降低了硬件成本。

Focuses on a variety of magnetic starter circuit form, cabin air, the typical pump control circuits, refrigeration equipment, electrical control circuits, AC three-speed anchor machine control circuit.

着重介绍磁力启动器的各种电路形式，机舱风、泵的典型控制电路，冷藏设备的电气控制电路，交流三速锚机的控制电路。

Finally choose reduce wheel speed, acceleration and slip ratio control parameters of logic threshold for control methods, as the paper...

本文用Protel Dxp软件完成了以SPCE061A为核心的ABS控制器的硬件电路设计，包括电源电路、轮速信号调理电路，驱动及故障诊断电路等。

A time-shared control circuit points to multiplexer, applies the control signal and switches and repeats to output the input signal by the predetermined cycle order. A comparator compares the voltages of the output signal from the multiplexer and the reference voltage and outputs a dimorphic signal representing the comparative result. A time-share controlled circuit applies the control signals, controls the action of the multiplexer and the latch circuit to lead the respective voltage comparative result to be maintained in the latch circuits.

分时控制电路(5)对多路调制器(4)，使用控制信号(Sc1)，以所定周期顺序切换反复输出所输入的信号(St1)-(St4)，比较器(3)对从多路调制器(4)输出的信号的电压和基准电压进行电压比较，输出表示该比较结果的二态信号，分时控制电路(5)使用控制信号(Sc1)及(Sc2)，控制多路调制器(4)及闩锁电路(LT1)-(LT4)的动作，使得信号(St1)-(St4)的各电压比较结果分别保持在闩锁电路(LT1)-(LT4)中。

The invention discloses an ultrahigh frequency portable reader which is based on a self-adaptive antenna array and comprises a da vinci chip. The da Vinci chip is externally connected with a USB interface, a Bluetooth interface, a liquid crystal display and at least an AD circuit which is connected with an RF circuit. The RF circuit is connected with the antenna array.

本发明公开了一种基于自适应天线阵列的超高频便携式读写器，包括达芬奇芯片，达芬奇芯片外接USB接口、蓝牙接口、液晶显示器和至少一个AD电路，AD电路上连接有RF电路，RF电路上连接有天线阵列。

This text introduce a sort of new pattern soft switch PFC circuit .First, analyze the develop course of the on-off power supply. Second, relate the harm of humorous wave to the commonality electricity net. Third, present the topology and the principium chart of the soft switch PFC and analyze it .At last ,set the parameter and simulates the converter of with matlab simulation. more over ,get the hold of well voltage and current wave , minish the spoilage of the circuit, enhance the efficience of the circuit, meet the demand of the miniaturization and viridity.

本文引入了一种新型的软开关PFC电路，首先分析了开关电源的发展历程，然后讲了谐波给公共电网造成的危害，再给出了这种软开关PFC的电路拓扑及原理图并对其工作原理进行了分析，最后对其参数进行设置在MATLAB软件进行了仿真，并得到了良好的电压电流波形，而且减小了电路的损耗，提高了电路的效率，实现了小型化，绿色化的要求。

To get the problem solved, a protection circuit has been designed, which contains a micro-current amplifier, an absolute window voltage comparator, an ultra-range tips circuit, a UREF benchmark constant voltage source circuit, and an executive circuit.

针对这一问题，设计了一个保护电路，整个系统由微电流放大器、绝对值窗口电压比较器、超量程提示电路、UREF基准恒压源电路、执行电路构成。

This article introduced in detail does not have the electric cable to coordinate the controller the overall design and its hardware electric circuit, the software procedure: Voltage comparator, 2 frequency multipliers, synchronized clock electric circuit, 6 7SEDLED nixietube display circuit.

本文详细介绍了无电缆协调控制器的整体设计和其硬件电路软件程序其硬件电路组要有：电压比较器2倍频器同步时钟电路6位7SEDLED数码管显示电路系统软件包括：主程序子程序实现控制程序等实验表明：该无电缆协调控制器系统可以准确的对信号灯进行监控和教正，可以在一定程度上解决混合交通流的问题

This subject introduces a kind of nc dc voltage stabilizer, the power supply, by simulation showed circuit, control circuit and digital-to-analog circuit, amplifying circuit four parts, mainly is a set of singlechip intelligent dc power supply.

本课题将介绍一种数控直流稳压电源，该电源由模拟电源、显示电路、控制电路、数模转换电路、放大电路四部分组成，主要是一套以单片机为核心的智能化直流电源。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。