电解的

So, it is very important to apply computer automatic control technology in the production of aluminum electrolysis.

因此，计算机自动控制技术在铝电解生产过程中的应用具有重要的意义。

Two methods for the determination of magnesium in rare earth-magnesium middle alloy by EDTA titrimetry, i. e. oxalic acid precipitation and ammonium hydroxide precipitation, were studied.

研究了分别采用草酸和氢氧化铵沉淀分离稀土镁中间合金中的稀土，EDTA络合滴定法快速测定电解稀土镁中间合金中镁的两种方法。

Finally the ammonium phosphate obtained is used to aluminum electrolytic capacitor to test its effect. The results indicate that the ammonium hypophosphite can meet the requirement of condensers.

最后将实验制得的次磷酸铵用于铝电解电容器，考察其作用效果，结果表明所得产品能达到电容器试剂的要求标准。

By extending the concept of MBE technique and employing the uniform buffers to separating the sample electrophoresis, the zone electrophoresis was developed. The isotachoporesis technique is based on the separation in a discontinuity form between two buffer solutions and results in separation of samples. The isoelectric focusing is a method that concentrates the ampholyte sample by the pH gradient introduced in the background ampholytes.

区间电泳法以移动边界电泳法作为基础的技术，其在系统环境充满均匀的缓冲液进行分离；等速电泳法则利用两缓冲液进行不连续分离之技术；等电点聚焦电泳法则利用背景溶液建立出pH值梯度，双性电解液样品因其位於等电点所受库伦力为零而聚焦於此。

Corrosion caused by a reaction of an amphoteric metal with the alkaline products of electrolysis.

由于两性金属与电解碱性物质的反应而引起的腐蚀。

Testing media for 'Mother of Vinegar' in Anolyte systems is not commercially available.

测试媒介为'醋的母亲' 在阳极电解液系统不是通商上可得到的。

Current density, anolyte acid and concentration of SO42 in anolyte are notable factors influencing the current efficiency, oxidation rate and cell potential.

通过均匀设计的电解条件试验得出：电流密度、阳极液酸度和阳极液硫酸根浓度为影响电流效率、氧化率和槽电压的显著因素。

Depending on the characteristics of the low grade oxidized ore on the surface in Woxi,and by small scaled column leaching tests and commercially scaled heap leaching tests,a flowsheet of heap leaching-carbon adsorption-disadsorption and electrowinning was applied,where masking agent was used to reduce the influence of Arsenic and antimonial on cyanidation.

根据沃溪区低品位地表氧化矿矿石的性质特点，通过小型柱浸试验和堆浸工业试验，采用堆浸—活性炭吸附—解吸电解工艺处理该矿石，工艺中采用隐蔽剂以消除砷、锑矿物对氰化的影响，金回收指标较好，经济效益可观。

The pattern of the holes in the ribbon determines the pattern electrochemically machined on the surface of the metal bearing component.

条带孔的形状决定在金属轴承件表面上电解加工的图形。

Shunde factory is a professional production of high-frequency mold, plastic mold heat, blister forming electrolytic copper mold, cartons, carton forming, such as various types of wood-like knife mold mold packaging manufacturer and to take the size of carton processing, customization, our advanced equipment and skilled design.

本厂是顺德一家专业生产高周波模具、吸塑热合模具、吸塑成型的电解铜模、纸盒、纸箱成型的木样刀模等各类包装模具生产厂家，并承接大小纸盒加工、定制，本厂设备先进，技术熟练，集设计。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。