电解的

In this paper, titanium ethoxide was synthesized by the direct electrochemical method. The production was characterized by Raman spectra. The effects of different factors on the voltage, current efficiency, material yield and space-time yield were investigated.

采用直接电化学法合成乙醇钛，采用激光拉曼光谱对产物进行了表征，详细探讨了电解时间、电流密度、支持电解质浓度、电解液温度以及电极间距对槽电压、电流效率、产物收率和时空产率的影响。

Effects of water,low-concentration calcium lignosulphonate and nitric acid pretreatments on electrokinetic processes of electroplating sludge were investigated.

以风干电镀污泥为电动处理试验材料，水为阳极电解液，柠檬酸-柠檬酸铵缓冲液为阴极电解液，施加25 V直流电压条件下电动运行5 d，研究了水、低浓度木钙和硝酸等预处理对电镀污泥电动过程的影响。

The said new technology will raise the Zinc concentration in the teated liquid to be higher than 30 g/L,and therefore the treated liquid can be reused as a process solution in a Zinc plant.The liquid permeating the membrane,with Zinc less than 0.1 g/L,is neutralis...

电解废水经膜分离处理后，浓缩液中锌浓度可达30 g/L以上，回收后全部进锌冶炼系统，透过液中锌浓度在0.1 g/L以下，用碱调节pH 5~6后可回用于电解工序洗板，实现了废水资源化和车间废水零排放目标，具有显著的经济效益和环境效益。

The results show that the oxide cathode can be deoxidized to pure Ni3Sn2 at the voltage range of

结果表明，当电解电压在2.8~3.2V之间时，可制备出纯相的Ni3Sn2合金粉末，且电解电压越高，电脱氧反应速率越快。

In order to solve chromium waste water by means of electrolyzed deoxidation, we apply polyacrylonitrile carbon blanket as pole, graphite as bipolar plate, positive ion film as diaphragm, to an oxidation-reduction system, in which negative pole electrolyzes and reduces chromium waste water; meanwhile, oxides Fe~{2+} into Fe~{3+} in positive pole.

为了电解还原处理含铬废水，以聚丙烯腈碳毡作电极，石墨板作双极板，以阳离子交换膜为隔膜，组装出氧化还原电池系统。此系统阴极电解还原处理含铬废水，同时阳极氧化Fe2+为Fe3+。电池系统的平均电流效率达92.29%，处理后废水中铬含量小于10-5mol/L，达到国家排放标准

And the results show that the electrolyzing time is a important determinant factor.

这表明电解时间不易过长，否则可能造成产物的分解，当电流明显减小时，应及时停止电解。

The reduced product was TiFe with an oxygen content of 0.43% in mass fraction after electrolyzing for 10 h.

在1173 K和3.1 V电解条件下，电解10 h后可制得含氧量为0.43%的TiFe。

In chapter 5, electrolytic graphite power was obtained by anodic electrolyzing artificial graphite block in H〓SO〓 solution, as a way to improve the performance of graphite electrode in Li-ion batteries.

3第五章中，在H〓SO〓溶液中用阳极电解石墨块的方法得到了电解石墨粉。

The anodization utilizes an electrolytic solution which etches out oxidized portion as soon as it is formed as a result of the anodization, to thereby develop a porous layer in a pattern in match with the anode pattern.

阳极化利用了电解液，一旦由于阳极化而形成氧化部分，电解液即蚀刻掉氧化部分，由此以与阳极图案相匹配的图案产生多孔层。

The company has unitized equipment for mechanical processing, electrolysis polishing and heat treatment.

有成套的机械加工、电解抛光、机械抛光和热处理设备，对精铸件可进行模具设计与制造、机加工、电解抛光、机械抛光及热处理等。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。