电网

The study has focused on: 1 The research background and the current state of the power measurement were analyzed systematically, and then wavelet-based power measurement algorithm was certified feasible for astable signals; 2 We developed a new method of RMS and power measurement based on Dmeyer wavelet. After that three other wavelet measurement approaches were compared with Dmeyer wavelet-based measurement approach. Then the impact on measurement errors of amplitude frequency property and energy leakage of wavelet filter banks were deeply researched, and some measures were proposed to reduce it; 3 We developed a new strategy of power measurement algorithm based on lifting wavelet, which had calculation advantage compared with the first wavelet, so that it was more suitable for the realization of hardware; 4 The running system of wavelet-based power measurement algorithm based on DSP was proposed, and then it was realized on ICETEK-VC5416-A EVM board; 5 Existing problems and the further research direction of wavelet-based power sub-band measurement algorithm was discussed.

本文对基于小波变换的功率测量算法展开深入的分析研究，主要内容有：1）系统地分析了功率分解测量的研究背景、国内外的研究现状，并从能量守恒的角度验证了小波功率分频带测量算法在非平稳信号条件下的可行性；2）首次提出了Dmeyer小波变换有效值与功率的测量方法，进而通过对该方法与3种已经提出的小波测量方法的对比分析，深入研究了小波滤波器组的幅频特性和能量泄漏特性对测量误差的影响，并针对电网谐波的特点提出了减小影响的相关措施；3）首次提出了二代小波功率测量算法，对比一代小波功率分频带测量算法，它大大减少了算法实现的运算量及内存的需求量，从而更适合于硬件的实时实现；4）提出了小波功率分频带测量算法的DSP实现方案，并在ICETEK-VC5416-A EVM板上进行了实现；5）探讨了小波功率分频带测量算法目前仍存在的问题，并提出了进一步的研究方向。

A sufficient condition of the analytical solution of the system which is asymptotically stable is derived.

其中 ，中立型方程为电网的能量耗损等问题提供了有效的数学模型。

Now, full automation and non-attended substation have become the developing trend of the roboticized attemper of electrical network and atommatization of power system.

应该说，实现变电站综合自动化和无人值守，已经成为电网调度自动化和电力系统自动化发展的必然趋势。

Sparse eigenvalue analysis technique, which makes full use of sparsity of augmented state matrix during small disturbance stability analysis for large scale power system, can compute out concerned eigenvalue subset from all eigenvalues and can analysis power systems that have arbitrary scales.

论文的主要研究工作和创新性成果如下：1针对传统特征值分析方法仅适用于中小规模电力系统的局限性，结合Prony和稀疏特征值算法，提出了一种大规模互联电网区间低频振荡分析的实用方法。

Then put forward the LabVIEW-based line-Loss on-line automatic computation and analysis management system of 10kV distribution networks. Firstly, through numerous studies, we compared and summarized typical algorithms of distribution network energy losses calculation.

论文首先通过大量研究，在总结、对比各种常用的配电网线损计算方法的基础上，提出了基于SCADA系统遥测数据的等值电阻法。

Design of Automatic Voltage Control system for large-scale power network is presented in this paper.

对已有的大规模电网的自动电压控制模式进行了综述，总结了各种模式的优缺点。

Moreover, it's an important part of the distribution automation.

同时，它是配电网自动化的重要组成部分。

Operational features and load characteristics of autotransformer common winding under different work conditions are analyzed in detail.

针对电网内自耦变压器不同运行工况，详细分析了自耦变压器公共绕组的运行特性及其负载特性。

In order to study the negativesequence influence to regional power grid caused by autotransformer traction power supply system, formulas of NSeq current and threephase voltage imbalance were derived, based on current distribution analysis of AT traction power supply system and singlephase VVconfiguration train substation. Employing the "train diagram" method, the realtime voltageimbalance curve was obtained in a simulation study, as well as the factors that influence NSeq and some measures to restrain it.

为研究自耦变压器牵引供电系统对地区电网造成的负序影响，首先讨论了AT牵引供电系统、单相VV接线牵引变电站的电流分布，推导得出了负序电流、三相电压不平衡度的计算公式；然后结合"列车运行图法"开发了相应的仿真程序；最后通过一个实际算例，得到了实时电压不平衡度曲线，指出了负序大小的影响因素及相应措施。

It transfers the slip power to mechanical power and then feed the power back to the shaft of the motor, or directly feeds the slip power to the alternating current net, so as to ensure the speed regulation a higher performance and higher power utilization ratio.

它可以把转差率转变为机械功率反馈回电动机机械轴上，或把转差功率反馈至交流电网中，使得具有良好的调速性能和较好的功率利用性。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。