电纳

There are mutual impedance and mutual admittance in zero sequence network of double circuit that makes it difficult to calculate fault circuits by symmetry component method.

用对称分量法进行超高压同杆双回线故障计算时将遇到零序分量间存在零序互阻抗和零序互电纳的问题。

The authors research the algorithm for power system static voltage stability. Taking the modulus minimum eigenvalue of power flow Jacobian matrix as the criteria to weigh the weakness of power system, the active power injected into nodes equivalent is substituted by equivalent conductance to ground as well as the reactive power injected into nodes is substituted by equivalent susceptance to ground.

研究了电力系统静态电压稳定性算法，以潮流雅可比矩阵最小模特征值的大小作为衡量电网薄弱程度的标准，以等效对地电导代替节点注入有功功率，以等效对地电纳来代替节点注入无功功率。

The frequency response transformation from a lowpass to a band pass filter is given, the change of the filter susceptance with frequency being taken into account.

给出了低通到带通的频响变换式，这个变换式考虑了滤波器电纳随频率改变。

This paper presents an analysis through theoretical computation on the electrical parameters of three-core brindle insulation conductors, and through the methods of the design of conventional aerial lines and magnetic field theory. The reactance and susceptance of the new wire materials are 0.23 and 9 times as ouch as that of the conventional ones respectively.

应用电磁场理论和电力架空线路设计的理论，针对三芯绝缘导线束进行电气参数理论计算和分析，结果表明：与常规裸导线相比，其电抗和电纳分别为0.23倍和10倍。

ABSTRACT : Based on the general circuit model of inter-phase power controller, the basic relationship of steady-state voltage of IPC is analyzed in this paper. Consequently a new concept is proposed to describe the basic feasible region of steady-state voltage of tuned IPC and its basic forms is defined under the conditions of tuned parameters. On the basis of aforementioned work, the respective regions in case of equivalent load in receiving end, susceptance of inductor and capacitor and parameters of phase shifter meeting the requirements of basic feasible region of voltage is mainly analyzed. Finally, the differences of feasible region of various TIPC with simulations are given.

首先，基于相间功率控制器的通用电路模型，分析了IPC稳态电压的基本关系；其次，针对参数共轭条件，提出并定义了调谐型IPC正常稳态运行电压基本可行域的概念及其基本形式，并在此基础上，重点解析了受端等效负荷、电容和电感的电纳、移相环节参数在满足电压基本可行域的前提下各自应该界定的基本可行域；最后，通过典型TIPC的仿真分析，说明了不同TIPC在基本可行域方面存在的差异。

The invention ensures that the SVC can not only complete the unbalanced load equalization compensation but also control the stabilization, thereby raising the precision of the susceptance computation of the SVC, guaranteeing the balance compensation of the charge, improving the performance in the stabilization control of the SVC voltage and maintaining the voltage stabilization of a common connection joint.

本发明能让其中SVC既能进行不平衡负荷平衡化补偿，又能对稳定控制，提高了静止无功补偿器电纳计算的精度，确保负荷的平衡补偿，改善了SVC电压稳定控制时的性能，维持公共连接点的电压稳定，具有较高的鲁棒性和响应速度。

The method is based on a variable structure to control the SVC, wherein, the variable structure control method comprises two aspects of the unbalanced load equalization compensation and the parameter control of a PI controller, wherein, the unbalanced load equalization compensation adopts the SVC compensation susceptance computational method which is based on the synchronous rotation reference coordinate transformation of a virtual symmetrical three-phase system; meanwhile, in the stabilization control of the system voltage, the ant colony algorithm optimization method is adopted to real time adjust and to optimize the parameter kp and ki of the PI controller.

本发明公开了一种静止无功补偿器的不平衡补偿和蚁群优化方法，基于变结构对静止无功补偿器SVC进行控制，其中变结构控制方法包括不平衡负荷平衡化补偿和PI控制器的参数控制两个方面，其中不平衡负荷平衡化补偿采用基于虚拟对称三相系统的同步旋转参考坐标变换的SVC补偿电纳计算方法；同时在系统电压稳定控制时，采用蚁群算法优化方法，对PI控制器的参数kp、ki进行实时调整、寻优。

Most conventional methods for the extraction of substrate network were based on the use of frequency behavior of Y22 + Y21. However, we found that the feedback signal through the internal circuit elements makes the conductance of the substrate network underestimated while makes the susceptance of the substrate network overestimated. If conventional methods are directly performed on large area SiGe HBTs, a negative effective substrate resistance will be extracted. In the first part of the thesis, a new extraction method for the substrate network parameters of SiGe HBTs is proposed. When extracting the substrate network parameters, the feedback signal through internal circuit elements is considered. All the circuit elements of substrate network are extracted from Ysub instead of Y22 + Y21. The extracted substrate network parameters show a different bias dependence as compared to the conventional methods. By using a simple n+-p junction, we successfully explained the extracted bias dependent substrate network parameters. We developed a series linear regression equation to extracted the intrinsic circuit elements from the ABCD parameters. Compared with the conventional methods which extracted the circuit elements from Y-parameters or Z-parameters, the proposed method is much simple and easy to implement in the computer programs.

传统方法在萃取基板网路参数时，常常由所量得的Y22 + Y21来著手，但我们的研究发现，利用Y22 + Y21的频率关系来萃取基板参数时，基板网路的电导会被低估而基板网路的电纳则会被高估，另外传统基板网路参数萃取方法在萃取大尺寸元件基板网路参数时会得到负值基板等效电阻，以上的非理想效应皆因忽略部份信号会经由本质参数对基板网路做回授的影响，因此本论文中提出一个新的基板网路参数萃取方法，在萃取基板网路参数时考虑了由本质参数所回授的信号，并且由Ysub而非Y22 + Y21萃取基板等效电阻、基板等效电容及基板与集极空乏电容，成功的解决上述的一些非理想效应，所得到的基板网路参数与集极偏压的关系与传统方法所得的趋势相异，经由一个简单的模型成功的解释了所萃取得到的基板网路参数与偏压的关系，在萃取本质参数时，我们舍弃传统萃取方法中常用的Y参数或Z参数萃取方程式，而改用ABCD参数，并提出一系列的线性回归方程式，萃取所有的本质参数，与传统方法比较起来，比较简单而且容易建立在使用者的参数萃取软体中。

Three design schemes of compensation currents for D-STATCOM in delta connection used for unbalanced load compensation are introduced.

介绍了用于不平衡负荷补偿的三相三角形连接的配电网静止同步补偿器中补偿电流的3种设计方案，即电纳补偿原理、最大相电流最小化设计和无零序设计方案。

Voltage Source and Current Source, Thevenin Theory, Trouble Shooting, Characteristic Curve of Diode, Diode Models, Rectifier Circuits, Input Filtering Capacitor, Voltage Multiplier Circuits, Limiter and Clipper Circuits, DC Clampers and Peak-to-peak Detectors, Zener Diode, Zener Diode Rectifier, Photoelectric Devices, Collector-Emitter Junction, Transistor Characteristics of common-emitter, Base Bias, LED Dirver, Establishing a Stable Q-point, PNP Transistor Biasing, Transistor Biasing, Coupling and By-Pass Capacitors, AC Emitter Resistance, Common-Emitter Amplifier, Other Common-Emitter Amplifiers, Cascaded Common-Emitter Amplifiers, AC Load Line, Emitter Follower, Class B Push-pull Amplifiers, JFET Characteristic Curve, JFET Biasing, JFET Amplifier, VMOS Circuit, Differential Amplifier, Operational Amplifier, Non-inverting Feedback, Negative Feedback.

电子学实验( S0704)(1，1)/应用电子学实验( S0472)(1，1)电压源和电流源、戴维宁定理、故障排除、二极体特性曲线、二极体近似模型、整流电路、电容-输入型滤波器、倍压电路、限制器电路和峰值检测电路、直流定位器与峰对峰检测器、齐纳二极体、齐纳二极体整流器、光电元件、集射极接面、集极特性曲线、基极偏压、LED驱动器、建立一个稳定的工作点 Q 、 PNP 电晶体偏压、电晶体偏压、耦合及旁路电容、交流射极电阻、共射极放大器、其他 CE 放大器、串接共射极放大器、交流负载线、射极随耦器、 B 类推挽式放大器、 JFET 特性曲线、 JFET 偏压、 JFET 放大器、 VMOS 电路、差动放大器、运算放大器、非反向电压回授、负回授。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。