电磁的

For the analysis of both static and dynamic characteristics, the additional moments, axial/radial coupled stiffness coefficients and the radial/radial coupled stiffness coefficients are taken into account Based on it, the influences of the bearing angle, the ratio of width to diameter, and the ration of magnetic polar angle on the static and dynamic characteristics conical magnetic bearing are analyzed, and the corresponding numerical results are presented.

在圆锥电磁轴承基础解的计算模型中，增加了轴承附加力矩、力矩刚度系数以及轴向/径向、径向/径向耦合刚度系数的计算。在此基础上，本文详细讨论了圆锥电磁轴承锥角、宽径比以及磁极角比对轴承静、动特性的影响，并给出了数值结果。

Based on the above results, the problems of the electromagnetic interaction between a perfect conducting plate and 1-D/2-D conducting slightly random rough surface and the problems of the electromagnetic interaction between a dielectric spherical particle and dielectric slightly random rough surface are investigated. By using the reciprocity theorem, Small Perturbation Method and Physical Optics approximation, the solution for the composite scattering field from the composite target is derived and evaluated, and the numerical results are discussed and analyzed.

在此基础上，用互易性原理分别研究了一维、二维导体微粗糙面与其上方金属导体平板目标的复合电磁散射及介质粗糙面与其上方球形粒子的复合电磁散射，结合互易性原理和粗糙面散射微扰法及物理光学近似导出了复合散射场的计算公式并进行了数值计算，对计算结果进行了讨论和分析。

The influence of the photon with non-zero rest mass was calculated on the motion equations of electromagnetic wave.

这些检验大多数是在平直时空下，以重电磁理论为理论基础的，而重电磁理论最直接的结论之一就是重光子在真空中的色散效应[1]。

To develop a new electromagnetic riveter, the author have comprehended the development of electromagnetic riveting technology EMR...

围绕研制新型电磁铆接设备的思路，详细了解了国内外电磁铆接技术的发展状况，对现有铆接设备存在的问题进行了分析。

To develop a new electromagnetic riveter, the author have comprehended the development of electromagnetic riveting technology , theoretical and experimental analyses have been made on the problems of existing electromagnetic riveter.

围绕研制新型电磁铆接设备的思路，详细了解了国内外电磁铆接技术的发展状况，对现有铆接设备存在的问题进行了分析。

It is of great significance to study the electromagnetic coupling of the transient electromagnetic field to shielded cable for improving the electromagnetic anti-interference ability of the secondary equipments in substation.

研究变电站瞬态电磁场对屏蔽电缆的电磁耦合问题，对于提高变电站内二次设备的抗电磁干扰能力具有极为重要的意义。

Analysis on the major structure and control parameters affecting the performance of the solenoid valve, so as to provide theoretical basis for working out its structure design and control method.

3对影响高速电磁阀性能的主要结构参数和控制参数进行了分析，为电磁阀的结构设计和控制方法的拟定提供了理论依据。

The structure of electromagnetic stirrer applied in steel refine and continuous casting will be changed due to the working condition.

应用于钢精炼与连铸工艺中的电磁搅拌器，因场合与条件的不同，搅拌器结构也有所变化，利用商业软件 ANSYS10.0软件对异型结构电磁搅拌器的电磁场和电磁力进行了模拟分析。

And the materiality, experimental test and deductions of them are discussed in the framework of the π-shape three kinds of wave-particle duality.

本文基于电磁场按光子对应分解，找到了经典电磁场的基本单元"电磁基波"，并在"π型三重波粒二象性"的框架下探讨了"电磁基波"的物质性、有关推论以及实验验证。

The simulation showed that without EMBr, the floating-up probability was nearly zero for the inclusions less than 50μm, and 6% for the inclusions larger than 200μm. With EMBr, the floating-up probability was 25% for the inclusions less than 50μm, and 38% for the inclusions larger than 200μm.

数值模拟表明，无电磁制动时，粒径在50μm以下的夹杂物颗粒其上浮概率几乎为零，200μm夹杂物颗粒上浮概率为6%；有电磁制动时，粒径在50μm以下的夹杂物颗粒的上浮概率为25%， 200μm夹杂物颗粒上浮概率为38%。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。