电流

Based on integral formula, discrete second electrical field is expressed as a sum of elementary contributions coming from charges accumulated on the surfaces of resistivity discontinuity.

基于地下电流场的积分公式，离散化的二次电流场被分解为电性不连续界面上的一系列点电荷电场的代数和。

According to the electric field integral equation of the surface, the recursive solution for the induced current on the slight rough surface is derived using the perturbation expansion of the surface, and the method for computing the interaction field is given.

根据粗糙表面电流积分方程并利用表面微扰展开，得到了微粗糙面表面极化电流的迭代解，给出了耦合电场的计算方法。

The high-power system including main circuit, the charging and discharging circuit of synthetic circuit test system, and the principle of charging and discharging for current supply using electrolytic capacitor is presented. At the aspect of circuit breaker control, the advanced permanent magnetic actuator is used and analyzed in this paper, including the precision computation and using in synthetic circuit. The trigger circuit of voltage supply is designed, and the intelligent control is used to trigger the igniting gap. And the integraph based Rogowski coil is designed and employed the intelligent detection of breaking current.

强电系统介绍了合成回路试验系统的主电路及其充放电电路，讲述了电流源采用电解电容器的充放电原理；断路器控制方面，采用当前比较先进的永磁操动机构，并对永磁机构的原理、精度计算和在合成回路中的应用做了详细地分析；设计并制作了电压源点火回路，对球隙点火进行智能控制；在智能检测开断电流方面，设计并制作了与Rogowski线圈相配合的积分器。

The methods for the determination of the impulse intensity of voltage and current are introduced.

分析了电容电压和电感电流发生跃变的情况，介绍了确定电流和电压冲激量的方法。

To remedy this situation, some people used to increase the number of magnet and coil, and a slight stagger to change with the current approach leads to changes in the intensity of output current control in a certain range.

为改变这种情况，人们采用增加一些磁铁和线圈数量，并稍微错开地将变化的电流一起引出的办法，使输出电流的强度变化控制在一定的范围内。

The purpose of these experiments is to discovery the influence that some factors made on IBC. These factors are frequency and intensity of current, electrode size, distance between sender and receiver, et al.

实验研究了电流的频率和强度，电极的种类和大小以及收发的距离等因素对电流耦合型人体通信的影响。

Find that when the intensity of driving current is not much smaller, action potential of the cell oscillates in mode-lock style.

另外还研究了在周期电流驱动下系统的运动，发现在驱动电流振幅不是很小时，系统作锁模运动。

This paper find that the force on the surface of the cathode, which is led by the electrolyte, will become larger while the interelectrode gap decrease through test,and so do the current. This relationship can be used to predict the interelectrode gap.

本文通过采集真实电解加工中阴极表面上来自电解液的平行于机床主轴的力和加工电流，利用小波变换对采集的信号进行处理，提取趋势项，发现：随着间隙减小力和加工电流都增大，可以据此间接实现间隙的测量。

Based on 6-dimision forces and machining currents, intelligent on-line monitoring and controlling the interelectrode gap is realized on the dissertation. The relation among 6-dimision forces received by cathode, machining currents and interelectrode gap is investigated widely and deeply.

本课题从电解液作用在阴极上的六维力及加工电流信号两个全新的角度入手，以平面、斜面、叶片型面三种工件的电解加工为对象，进行了电解加工间隙在线检测及智能控制的研究，对六维力、加工电流与加工间隙之间的关系进行了广泛而深入的探索。

Main research results are as follows:The distribution of electromagnetic field in inductor goes sameness when imposing high frequency magnetic field and intermediate frequency magnetic field where the magnetic flux density is symmetry along the center of inductor height and in which the distance from the center of inductor is further, the magnetic flux density is stronger.

主要结论如下：感应器通入高频电流和中频电流两种情况下，感应器内部的磁场分布趋势相同，感应器内部的磁感应强度沿感应器高度中心对称，半径越大的位置，磁感应强度越强。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。