电流

Moreover, the pre-treatment and post-treatment processes for the steel sheet subject to continuous zinc plating were also discussed. Results showed that the alkaline zincate plating process had many advantages over conventional alkaline cyanide zinc plating process, including high current efficiency, good throwing power, and strung adhesion strength of the coating.

结果表明，该工艺电流效率高（锌离子含量16~24g/L时，电流效率可提高约20%，镀液均镀能力好（宽度为1m的镀锌薄板，中心点厚度与边缘厚度差不大于10%，镀层结合力优良（将试片180°任意弯曲，镀层无起皮、剥落现象；在烘箱中加热至180-200℃，保温60min，冷水中急剧冷却，镀层无突起、鼓泡、剥落现象），所镀得的镀锌薄钢板适合于钝化和彩涂等后处理。

This simulation takes into account of the plasma bootstrap current ,ion cyclotron resonance heating and fast wave current drive.

模拟中考虑了自举电流，并加入了离子回旋共振加热ICRH和快波电流驱动FWCD，得到了中心电子温度4。

Based on the current-rising-rate protection and current increment protection, the principle of DDL protection as well as its action equation is presented.

以电流上升率保护和电流增量保护为基础，提出了一种新型的DDL保护方法及整定原则，并推导出了完整的动作方程。

From the junction temperature-varied optical properties measurement, we find that the luminous efficiency will decay more quickly at low current operation. However, when the current density increases to the saturation capacity of the quantum well, the decay ratio will reach a constant.

在变温的光学特性量测上，由实验结果发现，发光效率在较低电流时会衰减的较快，然而在注入电流达到量子井的饱和量后，其发光效率随接面温度升高衰减的现象则会趋近於固定的比例。

The results that the ultrasonic intensity have a direct ratio to the currents at electrode, when using this methods in the reduction of 〓 at Pt microelectrode, shown the manner of ultrasonic effect on the mass transfer on the electrode surface. And the inverse ratio relationship of current amplitudes to the separation of horn-electrode shown the decay law of ultrasonic intensity with distance.

将这一方法应用于铂电极上铁氰化钾还原反应体系中的研究结果表明，超声功率与电极反应电流幅值信号呈正比的关系，反映了超声能量对电极表面传质过程的影响程度的对应关系；电流信号幅值与超声作用距离的反比例关系则反映了超声振动能量随其辐射距离增大而衰减的规律性。

The current decouple control of direct current control strategy is selected as the control way.

确定了直接电流控制中的电流解耦控制作为本课题的控制方案。

This paper presented the research and exploration of mechanism and technics as well as the design of the magnetic circuit of this new compound machining, based on above, establishing the parameter model, meantime, analyzing influential effects on productivity of magnetic and EDM compound machining the holes through large numbers of experiments, including velcoity contrast experiments of pre-compound and after-compound machining with the change of current, velcoity contrast experiments of pre-compound and after-compound machining with the change of magnetic induction, velcoity contrast experiments of pre-compound and after-compound machining with the change of impulse width, experiments of the superficial roughness, experiments of the Electrode wastage, and intersectant experiments analysis as well as the change experiments of current waveforms. Through a number of experiments we analysed the influential effects of magnetic and EDM compound machining, compared the factors with EDM by oneself. A large of experiment records and deducibility have demonstrated that the productivity of magnetic and EDM compound machining is developed by 20%～400% than traditional EDM.

本论文对磁场电火花复合加工这种新的复合加工的机理、工艺和复合加工的磁路设计进行了研究和探索，在此基础上，建立了磁场电火花复合加工的参数模型，同时通过大量的随着电流变化磁场电火花复合前后加工速度对比实验、磁感应强度变化时的加工速度变化实验、随脉冲宽度变化的加工速度实验、表面粗糙度实验、电极损耗量实验、磁场电火花复合加工正交实验分析、电流波形变化等实验，实验分析了影响磁场电火花小孔加工效率的因素，并且跟单一的电火花加工中的影响因数进行了比较，大量的实验数据和理论推导证明磁场电火花复合加工比传统的单一电火花加工的效率提高了20％～400％左右。

The effects of the dehydration parameter such as temperature, electric field, demulsifier, the concentration of the iron sulfide, polymer, and water in crude oil on the dehydration current was investigated in this experiment. The reasons that the Electric field of the dehydrator is collapsed were analyzed. And some methods could decrease the dehydration current were put forward.

利用该套小型静态模拟电脱水器试验装置考察了在直流电场下，脱水温度、脱水场强、破乳剂、Fe含量、聚合物含量、碱含量表活剂含量和原油含水量等因素对脱水电流的影响，分析了电脱水器垮电场的原因，并提出了降低原油乳状液脱水电流的方法。

The new technique to diagnose transformer aging by polarization and depolarization current method is discussed.

介绍了变压器老化诊断的高性能液相色谱分析法，论述了用极化电流/去极化电流法诊断变压器老化的新技术，并列举了实例。

SN75LBC184 series is high withstand voltage, low noise stabilized power supply with reduced reactive current at low input voltage and small input / output differential voltage 0.2V at 40mA output current.

1第1页，本页显示记录1-19，共19条记录分1页显示SN75LBC184系列高耐压，低噪音稳定在四十○毫安输出电源电流，降低无功电流，低输入电压和小的输入/输出电压0.2V的差分。

And discuss some key point of integrated management system design, include hazard identification and risk assessment and risk control in the occupational health and safety management, the measure of satisfaction target of customer, the flawlessness of law system, the integration of the integrated management system and enterprise standardization system, unify lead institution and work orgnization, integreted internal audit and integrated management review.

同时，论述了一体化管理体系构建中的几个主要问题，包括职业健康安全管理中的危险源辨识、风险评价和风险控制、顾客满意度的科学监测、法律、法规体系的完善、一体化管理体系与企业标准化体系的有机结合、统一的领导机构和工作机构、一体化的内部审核和管理评审。

Deepwater Taranaki is investigated for its petroleum potential, using all available seismic data tied to shallow-water wells.

运用与浅水井相关的现有全部震波探测数据考察了深海区塔拉纳基盆地的油藏前景。