电极的

Until now, no general principle is offered for a systematic search over the number and positions of aperiodic phase-reversal boundaries and no improvement is made in the phase frequency response of modulator.

直到现在，在调制器的纵向优化中，对非周期倒相电极的节数和位置的选取还没有一般性的准则，也没有对调制器的相频特性作任何改善。

The challenges of these material are screen printing and sintering process. Many long fine patterned lines should be printed on a large piece of glass and sustain a smooth, continuous and uniform line pattern; on the other hand, the sintering process is rapidly increasing sintering temperature to a peak in a short time, then cooling the glass substrate to low temperature under a short time shock.

汽车钢化玻璃除霜加热线，是采用在玻璃基板上印刷银浆，在玻璃的钢化热处理过程中完成银导体膜的烧结附着，由于烧结时间短(总时间250sec)和温度骤变条件相当苛刻，要求导电细线无脱落断线，在功率满足要求的情况下，与外蓄电池连接的电极的焊接及附着强度也有具体要求，另外耐候性及耐擦洗等后步要求也较苛刻。

The purpose of this paper is to find the proper character of cooling water and the ways of it pass in and out the jet, which make sure that the anode of plasma ignition jet will not be ruined, to prolong the useful life of the pole, by using the numerical analyze in plasma ignition torch against heat transfer of anode and cooling-water against convection current heat transfer, and process the simulation calculation by using FLUENT soft.

本文通过对等离子体点火炬与阳极传热以及冷却水与对流湍流传热的数值分析，运用FLUENT软件进行模拟计算，找出满足使等离子点火器阳极不被烧蚀的冷却水的合理参数及冷却水进出水方式，来延长电极的使用寿命。

We have analyzed the interaction between lightwave and microwave in polymeric electrooptic modulators. Local poling structure was suggested to apply to the waveguide modulators, which will enhance the interaction between lightwave and microwave and improve the modulation efficiency considerably. In addition, instead of the coplanar electrode, the microstrip line was proposed to be the modulating electrode.

对有机聚合物电光波导调制器中光波与微波的相互作用进行了分析，提出利用局域极化结构可使在光波导中传播的光波与调制微波间的相互作用明显增强，与传统的使用平面电极的电光波导调制器进行了比较，调制效率增强一倍以上。

Micro-computer monitors work inside the electron gun emits electronic Xiang, after high-voltage electrode of the acceleration, adjust shooting at the screen, the screen of fluorescent material by high-speed electronic flow impact, resulting in X-ray.

微电脑显示器工作时，内部的电子枪发射出电子襄，经过高压电极的加速，调整射向荧光屏，屏幕上的荧光物质受到高速电子流的撞击，产生X射线。

The experimental robots,(which don''t do anything else except make copies of themselves,) are powered (through contacts on the surface of the table) and transfer data through their faces.

美国日前公布了的一项试验研究成果：4个试验者戴上布满电极的&思考帽子&后，可以运用他们的思想来直接控制电脑。

The mechanical construction of the rotor is that the inner surface is com- posed of the equator ring, smothing circle and sphere, and the outward surface is formed by ellipsoid.

按支承电极的实际情况，推导了全姿态读取时离心变形中高次谐波产生的电场干扰力矩的表达式。

Experimental results indicate that because of the compatibility of the technologies, the in situ fabrication of wire electrode can improve the machining accuracy of WEMM, and the micrometer scale structures can be fabricated.

试验结果表明：线电极的原位制作技术能提高微细电解线切割的加工精度，工艺兼容性好，能满足微米尺度微细结构的加工要求。

Four people were able to control a computer using their thoughts and an electrode-studded thinking cap, U.S. resea

美国日前公布了的一项试验研究成果：4个试验者戴上布满电极的&思考帽子&后，可以运用他们的思想来直接控制电脑。

The equivalent circuit of these electrode system was provided and the parameter of the elements were also given.

提出了膜内电子传输的机理，给出了此电极的等效电路图及图中各元件的参数值。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。