电极的

Finally, a two-mask process was attempted to extend the same concept of the chip process. Here the mask of the contact aperture was replaced by the mask of the LED pad. After etching the SiO2 and ITO in the aperture region, a lateral etch of SiO2 was made to increase the ITO contact area. Although the forward voltage of the GaN LED shows a normal value, the process yield is still low and requires further study.

二道光罩制程延伸了三道光制程的理念，只是因为透明导电层的圆孔图形，是用电极的光罩去开的，所以蚀刻完二氧化矽膜及氧化铟锡膜后，必须再做二氧化矽膜的回蚀刻，让二氧化矽再内缩进去，以增加氧化铟锡和电极的接触面积，不会造成发光二极体的顺向电压提高，但因制程良率太低，所以还须要继续研究改善。

It is the most powerful means of eradicating schistosomiasis. Current method of elimination cercaria is mainly the chemical method which has many disadvantages such as drug resistance, drug dilutedness, environmental pollution and poisoning the other biology, etc. For these reasons, this paper poposed a new method of elimination through high-voltage pulsed electric field, discussed the feasibility of the new method, studied the elimination mechanisms of using different forms of electrodes, analyzed various factors which influences the effect of elimination and introduced the structure of high-voltage pulsed electric field system at the stage of laboratory. Moreover, this paper showed the security problems that should be considered during the research and experiment.

针对常用的化学药物杀灭法存在的易使尾蚴产生抗药性、水域宽广致使药效降低、污染环境、毒杀其它生物等弊端，本文提出了一种利用高压脉冲电场杀灭血吸虫尾蚴的新方法，探讨了这种电子杀灭方法的可行性，分别研究了采用锐形电极和平板电极的血吸虫尾蚴杀灭机理，分析了影响尾蚴杀灭效果的各种因素，介绍了实验阶段血吸虫尾蚴高压脉冲电场杀灭系统的构成，指出了系统研制和试验过程中需要充分考虑的安全性问题。

The formation of SEI is related to the structure and BET surface of the carbonous materials. This causes the main irreversible capacity of carbonous electrode at the first charge and discharge cycle. It will play an active ...

初始的充放电循环中在碳材料的表面会形成SEI膜，其形成与碳材料的结构和比表面积有关，并造成碳电极在首次充放电循环时的不可逆容量；稳定的SEI膜一旦形成，在随后的充放电循环中将对电极的循环稳定性产生积极作用。

They have some other patients who have electrodes implanted in the same location and may approach them about participating in a further study of this effect, he said. The institutional review board approval for the first patient was to look at side effects and complications of auditory cortex stimulation, so this study was technically covered by that approval, Dr. De Ridder noted. To study this effect in other patients will require a new application.

他表示，仍有许多植入电极于同样位置的病患，可能可以邀请他们加入往后的研究；De Ridder医师表示，机构的伦理委员会核准第一位病患的原因在于要检验植入电极的副作用、以及听觉皮质刺激的并发症，因此这项研究是技术上由该核准案涵盖的；若要在其它病患身上研究此种效应，则需要新的核准案。

They have some other patients who have electrodes implanted in the same location and may approach them about participating in a further study of this effect, he said. The institutional review board approval for the first patient was to look at side effects and complications of auditory cortex stimulation, so this study was technically covered by that approval, Dr. De Ridder noted. To study this effect in other patients will require a new application.

他表示，仍有许多植入电极於同样位置的病患，可能可以邀请他们加入往后的研究；De Ridder医师表示，机构的伦理委员会核准第一位病患的原因在於要检验植入电极的副作用、以及听觉皮质刺激的并发症，因此这项研究是技术上由该核准案涵盖的；若要在其他病患身上研究此种效应，则需要新的核准案。

The detection is based on the change of electrode potential before and after the antigen-antibody reaction.

蛋白A为抗原和抗体的反应提供了合理的基础，纳米金的存在提高了抗体在电极表面的固定量，多壁碳纳米管促进了电子的传递，从而缩短电极的响应时间。

The experiment results showed that the potential of reversible hydrogen electrode, acting as the reference electrode of DMFC, decreased with increasing degree of electrolyte humidification.It was found that the potential stability of RHE was mainly determined by the stability of its surface state.

结果表明：在可逆氢电极作为参比电极的DMFC中，RHE的电位随电解质润湿程度的增加而降低，其电位的稳定性主要取决于其表面状态的稳定性。

Comprehensive range analysis on all the used factors and their levels showed that the best technological conditions to make nickel electrode with best performance is specified as stoving temperature 50 ℃, rolling thickness 0.6～0.7 cm and rolling-mode rolling, and the relative influence degree of the technology factors is rolling mode＞stoving temperature＞rolling thickness.

用极差法对文中所用的所有因素水平的综合分析表明，制作性能优良的镍电极的最佳工艺条件为烘干温度50 ℃、厚度0.6～0.7 cm、轧压，各工艺因素对镍电极性能影响的显著性顺序为轧压方式＞烘干温度＞轧制厚度。

Aiming at solving the problem in the electrochemical oxidation of ammonia wastewater,the tin and antimony electrodes based on titanium were manufactured,the effect of different manufacturing condition to the impact of electrochemical oxidating ammonia wastewater was researched. After researching the influential factor and optimizing the manufacturing condition,the appearance analysis and the electrochemical analysis was hold on, the electroactivated character of the electrodes was studied to provide warrant to its application in the ammonia wastewater.

本论文从电化学氧化法处理含氨氮废水的问题出发，对钛基锡锑电极材料进行研制，考察了不同的制备条件对含氨氮废水的电化学氧化去除的影响，研究了各影响因素并优化了制备条件，并对其进行了表面形貌分析、电化学分析的研究，微观地研究了电极的电催化性能，为其应用于实际氨氮废水处理中提供了依据。

The distribution of spark locations corresponding to certain potential differences are simulated numerically, which shows that it is unable to detect the definite spark location with two inputs.

四点输入情况下理论和仿真研究了放电点位置与电位差对V〓-V〓和V〓-V〓的关系，从而证明了四点输入可以唯一地检测出放电点位置；通过研究四点输入和三点输入的圆电极的情况，首次提出可以将放电点位置检测的电位差法推广到其它形状规则对称的电极上。

The concept of equivalent rotationally rigidity is offered and the formula of rotationally rigidity is obtained.

主要做了如下几个方面的工作：对伸臂位于顶部的单层框架—筒体模型进行分析，提出了等效转动约束的概念和转动约束刚度的表达式。

Male cats normally do not need aftercare with the exception of the night after the anesthetic.

男猫通常不需要善后除了晚上的麻醉。