电弧焊

The short circuiting transfer pulses in the CO_2 arc welding have a great interference to the signals processing of the arc sensor.

CO2气体保护焊的短路过渡脉冲对电弧传感器信号处理存在较大的干扰。

The research on TIG welding arc ultraviolet spectrum has been completed by using this system.

利用此系统对TIG焊电弧紫外光谱进行了研究，成功地获得了不同焊接规范下。。。韩国明吴钊柳刚李俊岳

The laser- plasma hybrid welding of stainless steel was conducted to investigate the hybrid arc,light induced metal vapor and plasma arc spectrum features in this paper.

利用所研制的YAG激光等离子弧复合热源，进行了不锈钢激光等离子弧复合焊过程的电弧、光致金属蒸气成像观察和光谱分析。

On the basis of cognition of the potential significance of welding arc spectrum dynamic characteristics and with the destination to find out new sensoring method of metal transfer,this paper provided the parasynchronous principle and in turn verified the relationship between the pulses in the waveform of arc spectrum signals and metal droplet transfer with para high speed photography apparatus.

基于对熔化极气体保护焊电弧光谱信号动态特征重要意义的认识，以发现新的熔滴过渡传感方法为目的，本文提出准同步高速摄影法，设计了准同步光谱信号-高速摄影检测装置，验证了光谱信号波形中的脉冲是熔滴过渡所为，它们之间存在着确定的对应关系。

The effect of external AC magnetic field on arc shape and weld quality of magnesium alloy TIG welding were analyzed.

中文摘要：采用组织分析和性能检测的方法，研究了外加纵向交流磁场对镁合金TIG焊电弧形态及焊缝质量的影响。

Now in A-TIG welding, the coefficient of arc shrinking and the weld pool surface tension result in penetration increased.

目前认为A- TIG 焊使熔深增加的机理是电弧收缩和表面张力共同作用的结果。

Use alternating transverse magnetic-field to control dragged arc , overcome weld undercut, and improve the appearance of weld.

所以控制电弧后拖是高速焊改善焊缝成形的关键。

Behavior of welding arc plasma,characteristic of welding voltage,local changes of electron temperature and electron density were investigated respectively with high speed camera,inductance gauge of current and voltage,spectrometer in low power YAG laser-gas metal arc welding hybrid welding process comparing with simple GMAW welding case.

采用高速摄像机、电流电压采集仪及光谱分析仪分别研究低功率YAG激光-熔化极气体弧焊复合焊接过程中的电弧形态、电压特点及局部电子温度、密度变化。

Eventually, the W C-Co cemented carbide has favorable fusion welding of arc welding on study condition.

最终证明：在本研究条件下，WC-Co硬质合金有良好的电弧熔焊的焊接性。

The secondary variables include the angle of the electrode to the work, the angle of the work itself, the thickness of the flux layer, and, most important , the distance between the current pickup tip and the arc also called electrode stickout.

次要变量包括电极相对于工作台的角度、工作台角度、焊剂层的厚度以及导电嘴和电弧的间距。其中电极干伸长是最重要的变量。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。