电弧

With the Pockels device, the field strength distributions of the two kinds of insulators are measured imitatively and practically.

揭示了染污绝缘子在污闪过程各阶段中表面电场的分布规律和变化规律，以及表面电场分布与局部电弧发展的关系。

The sheet possesses good heat, cold and water resistance and incombustibility. Besides, excellent dielectric properties including proof tracking and arc resistance.

该板具有耐热性，耐寒性，不燃性，耐水性，电气绝缘性好等特征，此外，电气特性(由温度而产生的抵抗值的变化很小)，耐漏电起痕性，耐电弧特性方面也非常优秀。

Kurt reflexively let go, and arcs played across the alloy—radiation inducing a charge.

库尔特条件反射般松开手，电弧穿过合金——放射性感应电荷。

We are use vacuum arc remelting of special steels, we can manufacture Ingot of up to 10 tons.

制造高温合金特别严格的质量要求是使用真空电弧重熔，可以制造钢锭最大可达5吨。

This paper presents synthetic detecting fault feeder method based on the method of summation of mutual integral of transient current for intermittent arc earth fault and the method of summation of admittance mutual difference and fused current method for steady earth fault.

提出了基于电弧接地故障的暂态电流互积求和选线法和针对稳态接地故障的导纳互差求和选线法和融合电流选线法的综合选线方法。

To improve the reliability of low-voltage electrical products, we must study various factors affecting the process of arc movement, and from the burning arc interrupter to the whole process of dynamic change.

要提高低压电器产品的可靠性，就必须研究各种因素对电弧运动过程的影响，以及从燃弧到灭弧整个过程的动态变化。

Vacuum interrupter is the most important part of vacuum circuit breaker where the arc extinguishes.

灭弧室是真空断路器的重要组成部分，电弧就是在灭弧室内分断的。

The use of off-current magnetic field generated by itself, will be blowing arc interrupter chip to make it out.

利用断电流本身产生的磁场，将电弧吹入灭弧片内，使之熄灭。

With this data, we can calculate the resistance, conductivity, ionization voltage and discharge current parameters. This may help us to comprehend more about the electric discharge phenomena.

经由此研究，不但可得碳棒电极间距大小与电压之关系为非直线性，进而获得控制维持电弧持续放电之距离，可应用於金银等电极间或以水等介质作放电的研究。

About the Calculation of Arc length of the Oriented Smoth Curve or Jordan;2. The experimental results show that the optimum melting voltage is 35～36 V,the reasonable arc length is 25～29 mm.

以海绵钛和中间合金压制的电极经两次熔化得到的TC11合金铸锭为原材料，采用真空自耗电弧炉，在不同的电压下熔炼3次TC11合金铸锭，研究熔化电压、弧长与TC11合金铸锭扒皮深度和扒皮量的关系。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。