电压放大

First it produces the pulse signal by the multivibratorwhich is consisted of 555 timer and send in the detecting coil to form the alternating magnetic field, then it asopts UGN3503 linear half-effect as prode to the magnetic field change into the voltage signal change,after enlargement electric circuit and peak value examination electric circuit,the signal be treated to send into ADC0809 modulus converter change moduluses, then the digital signal after the modulus converter is changed is sent into AT89C51one-chip computers afterwards, after the digital filter, AT89C51one-chip computers afterwards compares the data to the reference voltage and judges whether to have detected the metal and alarm.

这个系统是以AT89C51单片机为核心，首先由555定时器构成多谐振荡器产生脉冲信号送入探测线圈以形成交变磁场，然后经过线性霍尔器件UGN3503将磁场变化转换为电压信号的变化，经过放大电路和峰值检测电路，经数模转换之后输入到单片机中，由单片机对数据进行软件滤波之后，与基准值比较之后，判断是否存在金属和报警显示。

AMPLIFIER input bias current, a function of TRANSISTOR current gain, is also a function of the applied input common-mode voltage.

放大器的输入偏置电流，晶体管的电流放大作用，也具有加到输入共模电压的作用。

A novel current supply for middleandlow power LD has been designed, which operates on the principles of voltagetocurrent conversion, current amplification,and current negative feedback.

本文作者设计了一种用于中、小功率LD的新型电流源，它的工作原理是电压／电流转换、电流放大和电流负反馈。

A novel current supply for middle-and-low power LD has been designed, which operates on the principles of voltage-to-current conversion, current amplification,and current negative feedback.

本文作者设计了一种用于中、小功率LD的新型电流源，它的工作原理是电压/电流转换、电流放大和电流负反馈。

A photodiode current is amplified and converted into a differential voltage.A common-gate topology is adopted to reduce input resistance.

前置放大器将光电二极管产生的电流信号放大并转换为差分电压信号。

Issues added: GTO below the opening of the process and shutdown process: Located GTO anode forward voltage electric pressure, when the increase in positive gate trigger current IG, through N1P2N2 transistors amplification makes its collector current IC2 and emitter current IK increase.

问题补充：下面分析GTO的开通过程和关断过程：设GTO阳极电压力正向电压，当在门极加正向触发电流IG后，通过N1P2N2晶体管的放大作用使得其集电极电流IC2和发射极电流IK增加。

The paper applies the block diagram for simulation analysis and theoretical calculations of series negative voltage feedback amplifier circuit which is designed by operational amplifier.

采用方框图分析法，对所设计的由运算放大器构成的电压串联负反馈放大电路进行了仿真分析和理论计算。

The capacitance capacitors and inductors of power grid form parallel resonance circuit .It's frequency may be related to the existing power grid close to the harmonic frequencies, If there is power grid harmonic current sources, harmonic resonance caused by enlarged so that the voltage and current waveform distortion even more serious.

电容器的电容和电网的电感形成并联谐振回路，其频率可能与电网中存在的谐波频率接近，如果电网存在谐波电流源，谐振引起的谐波放大使电压和电流波形畸变更为严重。

The system consists of signal acquisition systems, signal processing, show circuit and control circuits, and other components, through the acquisition by Hall sensor voltage signal to the amplifier will signal amplification, and then in the A / D converter after the digital signal into the microcontroller , Through the SCM software programming by the magnetic field signal, the final adoption of LED display to the magnetic field strength.

该系统由信号采集系统、信号处理、显示电路和控制电路等组成，通过霍尔传感器采集得到电压信号，再经放大器将信号放大，然后在A/D转换后将数字信号送入单片机，通过单片机软件编程得到磁场信号，最后通过LED显示出磁场强度。

First it changed the variety of capacitive into the variety of voltage by charge amplifier ,then demodulates the carrier wave signal modulated by the accelerometer signal and passed thought the low pass filter ,at last ,output a direct current signal which is directly proportional the accelerometer signal ,the circuit has the function of measuring the variety of capacitive and the specialties of higher sensitive and better linearity.

介绍一种可用于微机械电容式加速度计检测的接口电路，该电路利用电荷放大器把电容变化转变成电压变化，再对被加速度信号调制的载波信号进行解调，经过低通放大滤波，最后得到与加速度信号成正比的直流电压信号，具有测量差分电容变化的功能和灵敏度高、线性好的特点。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。