电压

The wave shape of the high frequence recovery voltage determines the unsuccessful choppings. It is also found that putting some magnetic rings on the main circuit connecting wire can limit the chopping current increase caused by the load capacitance.

本论文发现了恢复电压起始部分存在陡度很大的高频波峰，它是由回路连线电感中的截断电流对触头间电容充电引起的，它导致了截流前的不成功截断，增大触头并联电容将显著减小恢复电压的高频波峰，使截流显著增大。

Voltage Source and Current Source, Thevenin Theory, Trouble Shooting, Characteristic Curve of Diode, Diode Models, Rectifier Circuits, Input Filtering Capacitor, Voltage Multiplier Circuits, Limiter and Clipper Circuits, DC Clampers and Peak-to-peak Detectors, Zener Diode, Zener Diode Rectifier, Photoelectric Devices, Collector-Emitter Junction, Transistor Characteristics of common-emitter, Base Bias, LED Dirver, Establishing a Stable Q-point, PNP Transistor Biasing, Transistor Biasing, Coupling and By-Pass Capacitors, AC Emitter Resistance, Common-Emitter Amplifier, Other Common-Emitter Amplifiers, Cascaded Common-Emitter Amplifiers, AC Load Line, Emitter Follower, Class B Push-pull Amplifiers, JFET Characteristic Curve, JFET Biasing, JFET Amplifier, VMOS Circuit, Differential Amplifier, Operational Amplifier, Non-inverting Feedback, Negative Feedback.

电子学实验( S0704)(1，1)/应用电子学实验( S0472)(1，1)电压源和电流源、戴维宁定理、故障排除、二极体特性曲线、二极体近似模型、整流电路、电容-输入型滤波器、倍压电路、限制器电路和峰值检测电路、直流定位器与峰对峰检测器、齐纳二极体、齐纳二极体整流器、光电元件、集射极接面、集极特性曲线、基极偏压、LED驱动器、建立一个稳定的工作点 Q 、 PNP 电晶体偏压、电晶体偏压、耦合及旁路电容、交流射极电阻、共射极放大器、其他 CE 放大器、串接共射极放大器、交流负载线、射极随耦器、 B 类推挽式放大器、 JFET 特性曲线、 JFET 偏压、 JFET 放大器、 VMOS 电路、差动放大器、运算放大器、非反向电压回授、负回授。

The radiation by non-thermal plasma can accelerate formaldehyde thansform and make an increase of 29.61% in depurated efficiency. The surface modification makes no obvious difference in depurated efficiency. The chemical modification avails formaldehyde reduction and ACF coated with nano- TiO2 is the best of all that can enhand the depurated efficiency to 94%. The great influence of parameters on depurated efficiency , such as applied voltage and reaction time , shows that an increase in either applied voltage or reaction time enhance formaldehyde conversion.

研究结果表明：低温等离子体辐射能促进甲醛净化，可使其净化效率提高29.61%；表面改性对净化效率没有明显影响；化学改性有利于甲醛净化，其中负载纳米TiO2改性方案最佳，其净化效率高达94%；电源电压和反应时间等参数对净化效率也有较大影响，电压越大，时间越长就越有利于甲醛的去除。

Citing the classical thermodynamics formulae that measured the velocity of airflow using resistance temperature under the force convection condition, the equations are detruded following the measuring principle.

由强迫对流条件下热电阻检测气流速度的经典热力学公式，根据传感器检测原理推导得到Iw恒定时气流速度-热电阻丝电阻关系式、惠斯登电桥输出电压-气流速度关系式、热电阻的温度-气流速度关系式和惠斯登电桥输出电压-热电阻检测温度关系式。

We adopted DCJTB and TBPe to make two homochrom OLEDs as the red and blue dyes, the configurations are respectively as follows: ITO/CuPc(15nm)/NPB(50nm)/Alq3(30 nm):rubrene: DCJTB(6.1)/Alq3(30nm)/LiF(1nm)/Al(100nm),(x=2,3.7,4.2,5 nm,the dopped concentration is 1.1%,2.1%,2.3% and 2.8% respective -ly) for red OLEDs and ITO/CuPc(150 nm)/NPB(500 nm)/ADN(300 nm):TBPe(30 nm)/Alq3(350 nm)/RbF(20 nm)/Al(1,000 nm)for blue OLED. We discussed the electroluminescent mechanism and the infection of the dopped concentration of rubrene on the perform -ances of red OLEDs; And after a lot of designments and manufactures we found an integrated and reasonable scheme,and carried out some test -ings and discussions on the characteristics of current -voltage curve, efficiency- voltage curve and luminescence-spectrum curve and so on. Subsequently,we made two kinds of WOLEDs.

然后分别采用以DCJTB和TBPe作为红色、蓝色发光染料制作了两种单色OLED器件，制备了器件结构为ATO/CuPc(15nm)/NPB(50nm)/Alq3(30 nm)：rubrene：DCJTB(6.1 nm)/Alq3(30nm)/LiF(1nm)/ Al(100nm)，(其中x=2、3.7、4.2、5nm，rubrene的掺杂比例为1.1%、2.1%、2.3%、2.8%)的红光OLED器件和结构为ITO/CuPc(150 nm)/NPB(500 nm)/ADN(300 nm)：TBPe(30 nm)/Alq3(350 nm)/RbF(20 nm)/Al(1，000 nm)的蓝光OLED器件；讨论了红光OLED器件的发光机理，以及rubrene的掺杂浓度对发光效率等性能的影响；从蓝光器件的设计和制备入手，摸索出了一套完整而可行的制作方案，分别对器件的电压-亮度特性、电压-发光效率特性及发光光谱等特性进行了测试与讨论。

On the basis of simulation, the effects of the thickness of gate oxide and the dopping dose in the LDD region on the the electric field are studied.

论文采取对称的方法研究了漏电压VD和栅电压VG对GIDL隧穿电流的不同影响。

Electrons are accelerated by making the voltage of each successive dynode of the tube more positive than the previous one.

使每个连续的光电倍增管电极的电压都比它前面一个电极的电压更高，这样电子就得到加速。

At this point, you should check the oscillation manifold circuit, the voltage should be the normal 10 or so (Special reminder: because the test should be carried out in the electrized, and has high-voltage power supply, and therefore pay special attention to personal safety, do not try to touch any part of the power supply).

这时，应先检查振荡集成块的供电电路，其正常的电压应该在10V左右（特别提醒：由于测试电压应在通电情况下进行，而电源板上有高压电，因此要特别注意人身安全，不可尝试直接触摸电源的任何部分）。

This voltage is higher than the supply voltage and energises the panel into emitting light.

这个电压是电压高于供应和energises发光的面板为。

Digital simulation results show that when a step change in firing angle occurs, the first positive half-cycle time of VC will change suddenly and the subsequent electromagnetic transients appearing in the TCSC circuit will lead to overshoot and oscillations in the TCSC impedance. The range and duration of the oscillation will depend on the synchronization modes used and the manner in which the step change is introduced.

发现脉冲触发角阶跃变小时，电容电压的周期时间也突然变小，使得TCSC的导通角不会随着触发角的阶跃变化而发生突变，而是经过一个振荡过程逐渐达到稳态值，进一步揭示了电容电压同步方式下阻抗阶跃特性会出现过冲和振荡现象的原因。

Finally, according to market conditions and market products this article paper analyzes the trends in the development of camera technology, and designs a color night vision camera.

最后根据市场情况和市面上产品的情况分析了摄像机技术的发展趋势，并设计了一款彩色夜视摄像机。

Only person height weeds and the fierce looks stone idles were there.

只有半人深的荒草和龇牙咧嘴的神像。