电压

The results showed that the higher thedischarge voltage or charge capacitor was, the higher the temperature of the plasma was,and the longer plasma discharge time was. There was a late discharge when the inputenergy reached the critical value. The greater the capacitance or voltage was, the earlier thelate discharge of the plasma was. The temperature changes of plasma at the beginning of alate discharge were not significant under different discharge conditions. Each SCB had itstemperature range respectively.

结果表明：放电电压或充电电容越大，等离子体温度越高，等离子体的放电时间也越长；对于不同的SCB，当输入能量超过一定的临界值后，将产生等离子体后期放电；电压或电容越大，后期放电开始的时间越早，而后期放电开始时的等离子体温度，在不同的放电条件下变化并不大，不同的SCB均有其各自的温度变化范围。

In this paper, we use a computer sound card to replace the data acquisition card in the industrial, applicate LabVIEW based graphical programming language to develop a voltage signal acquisition system to collect voltage signal, the method is simple, high cost-effective.

本文采用计算机声卡来代替工业用的数据采集卡，应用基于图形化的编程语言LabVIEW开发一个电压信号采集系统实现电压信号的采集，该方法实现简单、性价比高。

The influences of electrolyte composition and concentration,as well as process condition on arcing voltage were measured.

针对目前微弧氧化技术中存在的电能消耗高的问题，对影响铝合金微弧氧化起弧电压的因素进行了研究，分析溶液成分和含量、工艺条件等因素对起弧电压的影响。

Place when three-phase loads are not balanceable on the running occasion of motor energy-saving, which canattaint appliances.

应用中，由于负载的不对称，容易产生三相不对称交流电压，甚至是直流电压，严重时会损坏电气设备。

BAW is used to on-line monitor the effluent from IC column.

在实际中，以SPQC-BAW技术对离子色谱流出物进行在线监测，可得到响应信号为频率的色谱图，具有很高的灵敏度；利用本室设计的频率/电压转换电路可将频率数字信号转化为模拟电压信号，从而为常用的色谱工作站或色谱数据处理设备接收、利用和处理，实现IC-BAW自动化分析。

To ensure the length of buncher , maximum voltage of beam bunching , the maximum amplitude of the scan voltage amplitude with bunch method of sine wave bunching klystron .

采用正弦波速调管聚束理论计算确定聚束筒长度、聚束电压最大幅值、扫描电压最大幅值等主要特性参数。

Preparation of the cathode includes:shaping under the press of 40Mpa, sintering at 550℃for 1 hour and at 900℃for 8 hours and threading with molybdenum bar; Considering the literatures we choose CaCl2 as salt for preparation titanium. Pretreatment of salt is for 1 hour at 100℃and for 2 hours at 300℃. Partial pressure of oxygen which need lower than 5.11×10-7Pa to reduct titanium oxides and hygroscopic property of salt need a sealed equipment to electrolyse. And finally successfully designed a satisfied one and the results show that the equipment can be satisfied the requirment of the experiment. Flow of the inert gas is 1.5L/min, the voltage is 2.8 V, temperature is 850℃and time is 2 hours during pre-electrolysis. Flow of the inert gas is 0.2L/min, the voltage is 3.1 V, temperature is 900℃and time changes with the mass of TiO2 during electrolysis, namely the greater need the longer time; To eliminate influence of salt and other impurities, the products need to wash with distilled water and dilute chlorhydric acid , then wash with dilute hydrochloric acid under supersonic wave assistant. Finally, electrometical properties of the electrolysis of TiO2 is researched by cyclic voltammetry and chronoamperometry, and results show that there are two main reodox steps, namely from TiO2 to TiO and from TiO to Ti.

阴极制备主要包括40MPa压力下模压成型、两段式烧结(1小时内升至550℃保温1小时，再1小时升温至900℃保温8小时)及烧结后TiO2块打孔用钼棒串接三个主要环节；实验中选用CaCl2作为电解熔盐，并对其进行预处理(100℃，保温1小时； 300℃，保温2小时)；经热力学计算，还原钛氧化物的氧分压至少要低于5.11×10-7Pa，结合电解过程中所用熔盐CaCl2有极强的吸水性的特点，电解装置应有较高的密封性，自行设计了一套密封性可靠的电解装置，便于实验过程中熔盐预处理和氧分压的控制；通过干燥处理预电解过程中Ar流量大约为1.5L/min、电压为2.8 V、温度为850℃、时间为2小时，电解过程中Ar流量大约为0.2L/min、电压为3.1V、温度为900℃，实验结果表明电解时间与TiO2质量密切相关，质量越大需要电解的时间越长；通过自来水冲洗—稀盐酸浸泡、洗涤—在超声波辅助作用下稀盐酸洗涤，可减少熔盐及其它杂质对电解产物检测结果的影响；最后，通过循环伏安法、计时电流法对电解机理的研究，确定电解还原TiO2制备金属钛主要经历了TiO2-TiO-Ti的过程。

Based on situation of teaching and learning of coreless transformer and structure study of coreless transformer,the equivalent circuit of coreless transform based on CCVS is constructed.

结合空心变压器的电气分析在教学中的特点，分析了空心变压器的基本结构和基本特点，运用电流控制电压源 CCVS对之进行了等效变换，然后将空心变压器的输入电路和输出电路看成一端口，运用戴维南定理分别对其输入端口和输出端口等效成一个电压源与一个电阻的串联形式，并进行了详细的讨论

The micro actuator's static state characteristic by static electric force is analyzed in detail. The steady balance position's existing condition is educed while the moving pole move with linear displacement, and the relationship between driving voltage and the moving pole's line displacement is presented. The adsorption voltage by which the moving pole is adsorbed to fixed pole is exported. The resolution method of the pole cornual displacement's static state characteristic is opened out.

以应用RP技术制作三自由度电容式微型激励器为例，阐明了这种制造工艺的主要特点，探索了复杂微机械结构制作的新方法；详细分析了所设计微驱动器在静电力作用下的静态特性，推导出了可动极板线位移运动时存在稳定平衡位置的条件及驱动电压与可动极板线位移量之间的关系曲线；给出了可动极板吸合到固定电极上的吸合电压，指出了分析可动极板角位移静态特性的解析方法。

The value of voltage affects depositive thickness, depositive rate, depositive morphology, and field emission property of cold cathode.

电泳电压是电泳过程中的重要参数，不同电压会影响阴极沉积的厚度和效率、形貌结构及场发射特性。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。