甲醛

The resol phenol-formaldehyde adhesive could be prepared from liquefied wood (wood: phenol=1:2) in phenol at r(subscript F/P) 1.8, r(subscript NaOH/P) 0.7 and resinification temperature 80℃. The physical properties of the poplar three-layer plywood bonded with LWR were similar to those with normal PF resins and also satisfied the demands of I level. Free formaldehyde content of plywood (0.1 mg/L) was lower than the E0 level set by GB/T 9846-2004 Plywood.

结果表明，采用料液比为1：2的液化物，F1.8，r0.7，树脂化温度80℃条件下合成的杉木液化物树脂压制的杨木三层胶合板满足I类胶合板强度要求，各项物理力学性能与常规PF树脂压制的板材相当，板材的甲醛释放量为0.1mg/L，远低于GB/T 9846-2004《胶合板》中的E0级要求。

Copper and cobalt oxides catalyst supported on activecarbon showed specific selectivity for salicylaldehyde and realized74% conversion of o-cresol and 57% selectivity for salicylaldehyde.

论文在液相条件下采用多相催化剂和分子氧，首次实现了催化选择氧化邻甲酚和对甲酚合成相应的羟基苯甲醛。

A new fullerene derivative containing energy-producing groups was prepared, and the reaction conditions affecting the yield were studied by the kroenecker method. The optimal reaction conditions with a 53.5% yield (based on consumed C60) are: 1:3:6 of molar ratio of C60 , o–nitrobenzaldehyde and sarcosine , 55℃ of reaction temperature, 12 h of reaction time, 40mL of toluene solvent.

利用N-甲基甘氨酸、邻-硝基苯甲醛和C60反应，合成分离出了含有硝基的新型富勒烯吡咯烷衍生物，通过正交试验对其工艺条件进行了研究，探讨了反应物剂量比、温度、时间和溶剂体积对产物产率的影响，得到了合成产物的最佳工艺条件：反应物剂量比为1：3：6、温度为55℃、反应时间为12h、溶剂甲苯体积为40mL，此时产物产率可达到53.5%（以消耗的C60计）。

Results Six compounds were isolated and identified as:5α,8α-epidioxy-(22E,24R)-ergosta-6,22-dien-3β-ol,scopoletin,isofraxidin,p-hydroxy benzaldehyde,3,4,5-trimethoxy benzoic acid,protocatechuic acid ethyl ester...

结果得到6个化合物，分别鉴定为：5α，8α表二氧(22E，24R)麦角甾6，22二烯3β醇、东莨菪素、异秦皮啶、对羟基苯甲醛、3，4，5三甲氧基苯甲酸、原儿茶酸乙酯。结论化合物Ⅰ～Ⅵ均为首次从该属植物中分离得到。

A series of SiW_(12)/AC catalysts with different silicotungstic acid loadings supported on acti- vated carbon which was treated with 10% HNO_3 solution were prepared by an impregnation method and the catalytic performance of SiW_(12)/AC for the synthesis of trioxane were investigated.

以10%硝酸溶液处理过的活性炭为载体，采用不同质量分数的硅钨酸SiW_(12溶液为浸渍液，制备了不同负载量的SiW_(12)/AC催化剂，考察了催化剂在合成三聚甲醛中的催化性能，并用XRD、FT-IR、NH_3- TPD、BET、TG-DSC等手段对SiW_(12)/AC催化剂晶粒大小、催化剂表面的酸量及酸强度、比表面积及热稳定性等微观特性进行了表征。

Objective:To study the effects of formaldehyde on Bcl-2, Bax expression in spermatogenic cell of mice and ultrastructural changes in spermatogenic cell.

目的：研究甲醛对小鼠睾丸生精细胞Bcl-2、Bax蛋白表达及超微结构的改变。

Thiobarbituric acid was synthesized by sulfourea and diethyl malonate in sodium alcohol and 5-Arylidene thiobarbituric acid was prepared by the Knoevenagel condensation reaction from benzaldehyde and thiobarbituric acid.

采用丙二酸二乙酯和硫脲在乙醇钠存在下合成了硫代巴比妥酸，再分别采用固相反应和水相反应，由硫代巴比妥酸和苯甲醛经Knoevenagel缩合反应，制备了5-亚苄基硫代巴比妥酸。

It can meet the measurement requirements of general food samples for formaldehyde and sodium formaldehyde sulfoxylate.

可满足一般食品样品中甲醛和吊白块测定的要求。

OBJECTIVE To investigate the degradation kinetics of sodium formaldehyde sulfoxylate.

中文摘要：目的研究药用抗氧剂甲醛合次硫酸氢钠在水溶液中氧化反应的反应速率常数。

While four sample treatments tested for different samples formaldehyde or formaldehyde sodium sulfoxylate content measured.

同时试验了四种样品处理方法，可用于不同样品中甲醛或吊白块含量的测定。

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里，举止就文雅一些，因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计，这件高贵的制服是香港本土制造，是我们第一套不配帽子的制服。