甲基丙烯酸树脂

Methacrylic resin in ethylene dichloride ...

二氯化乙烯中的甲基丙烯酸树脂。

The family of clear , colour and translucent thermo plastic resins such as Plexiglas or Lucite, Perspec.

透明的、色彩的和半透明的暖塑料性塑料树脂及其同系物，例如Plexiglas或Lucite，Perspec。2－甲基丙烯酸树脂。

The family of clear , colour and translucent thermo – plastic resins such as Plexiglas or Lucite, Perspec.

透明的、色彩的和半透明的热塑料性塑料树脂及其同系物，例如Plexiglas或Lucite，Perspec。2－甲基丙烯酸树脂。

Methacrylate photoresist was one of the tradition photoresist s and it had high transparent and resolution.

甲基丙烯酸树脂光刻胶是传统的光刻胶之一，具有高度的透明性及分辨率。

Methacrylate photoresist was one of the tradition photoresists and it had high transparent and resolution.

甲基丙烯酸树脂光刻胶是传统的光刻胶之一，具有高度的透明性及分辨率。

An acrylic resin was synthesized by the radical copolymerization with methyl methacrylate, butyl acrylate and methacrylic acid monomers in solution using benzoperoxide as initiator. Appropriate parameters of monomer ratio, monomer concentration, solvent, and reaction temperature were found by experiment.

以过氧化二苯甲酰为引发剂，采用溶液聚合合成了甲基丙烯酸甲酯-丙烯酸丁酯-甲基丙烯酸树脂，通过实验确定了自由基共聚合适宜的单体配比、单体浓度、引发剂浓度、溶剂以及反应的升温速度。

The methacrylic/acrylic membranes were introduced to the potentiometric sensor technology because of certain advantageous properties.

的甲基/丙烯酸树脂膜介绍了电位传感器技术，因为某些有利属性。

Two series of polyurethane acrylate grafted acrylic resins (Acr-g-TPU-PETA and Acr-gPPU-PETA) self-emulsifying systems are obtained by grafting -NCO group modified polyurethane acrylates with acrylic copolymer prepared from n-butyl acrylate, styrene,βhydroxyethyl methacrylate and acrylic acid The self-emulsifying systems showed Newtonian fluidity with viscosity closed to that of water, the solid contents were around 30% The T〓 of 15～4℃ for dried film before photocuring favored film formation at room temperature DSC and DMA results showed that PU-PETA is compatible with acrylic resin in the grafted resin The TG and dTG curves for Acr-g-PU-PETA samples were substantially different from the corresponding blends, and the brodened dTG peaks for photocured grafted resin suggest that there might be multiple interactions among chain segments The photocued film of the grafted resins self-emulsifying system exhibited good overall properties with polyurethane acrylate grafts ranging from 30% to 50%, and Acr-g-TPU-PETA series showed better properties than Acr-gPPU-PETA series The adhesion of the photocured film was 1～2 grade, impact strength was 50kg-cm and flexibility was 1mm The Shore hardness and the adhesion of the film decreased markedly if PETA was replaced by HEMA as photoactive group due to the lower C=C double bond content in the grafted resin The polyhydroxy amine-linked thioxanthones photoinitiators can be evenly dispersed in self-emulsifying system without color spot appearing in the dried film The films photocured with IV〓～IV〓 generally exhibited higher Shore hardness, gloss and solventresistance than that cured with Irgacure 2959 and did not induce the rusting of the iron substrate Pigmenting with titanium oxide had no effect on the photocuring The polyhydroxy amine-linked thioxanthone IV〓 and IV〓 can be new candidates for the formulation of titanium oxide pigmented photocurable water-borne coatings for their pale-yellow appearance and slight interference with the color of the coatings WB 4759 with high water-solubility coalesced and separated from the dried resin film, and even induced the rusting of iron substrate.

以丙烯酸丁酯，甲基丙烯酸-β-羟乙酯，丙烯酸及苯乙烯合成厂丙烯酸共聚树脂，并与含-NCO端基的聚氨酯丙烯酸酯接枝反应，经水性化后，得到两个系列（Acr-g-TPU-PETA和Acr-g-PPU-PETA）各5个不同配比的丙烯酸树脂接枝聚氨酯丙烯酸酯自乳化体系，粘度与水相近，为牛顿流体，固含量30％左右。光固化前干燥涂膜的玻璃化转变温度在-15℃～4℃之间，有利于室温下成膜。DSC及DMA谱表明两种树脂基本相容。Acr-g-PU-PETA的热失重行为明显不同于共混材料，接枝样dTG峰明显宽化，表明接枝样中链段之间的相互作刚有多重性，丙烯酸树脂与聚氨酯之间有一定的相容性。接枝树脂自乳化体系光固化涂层的综合性能以聚氨酯丙烯酸酯成分为50％～30％者相对较好，且以Acr-g-TPU-PETA系列更理想。光固化膜的附着力为1～2级，冲击强度为50kg·cm，柔软性多为1mm。以HEMA代替PETA作为接枝树脂的活性基团，碳—碳双键密度太低，光固化膜交联点太少，硬度和附着力均较差。多羟基胺连硫杂蒽酮光引发剂能均匀分散于树脂自乳化体系和接枝树脂干膜中，不出现色斑，光固化膜肖氏硬度一般高于以Irgacure 2959为光引发剂的光固化膜，光泽度及耐丁酮溶剂性能均有所提高，不会诱导铁基生锈，钛白着色对光固化结果几乎没有影响。本论文所合成的多羟基胺连硫杂蒽酮光引发剂IV〓与IV〓为浅黄色，对光固化涂层的颜色干扰较小，为配制钛白着色光固化水性涂料提供了新的光引发剂。水溶性太强的WB 4759在干膜中易聚结析出，且对所附着的铁基有诱导锈蚀作用。

The authors' laboratory once compared the effects of embeddings with the homemade paraffin and epon resin on the morphometric study of testicular structures, and, recently, also compared effects of embeddings with the internationally commonly-used Leica paraffin and methacrylate resin and magnifications on the morphometric study of renal structures.

笔者实验室以前对比过国产石蜡与环氧树脂包埋对睾丸组织形态定量研究的影响，最近又对比了国际上常用的Leica石蜡和甲基丙烯酸树脂包埋以及放大倍数对肾脏组织形态定量研究的影响。

Methods: Paraffin (7 μm in thickness) and methacrylate resin (25 μm) embedded renal sections were observed using 40× objective lens and 100× oil lens, respectively, and the volume fractions and diameters of the renal tubules and the tubule nuclei were estimated with stereological methods.

分别用高倍镜(40×物镜)和油镜(10 0×)观察石蜡(7μm厚)和甲基丙烯酸树脂(2 5 μm厚)包埋的肾脏切片，利用体视学方法测量肾小管的体积分数和直径以及肾小管细胞核的体积分数和直径。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。