用量

Dosage is not to had been jumped over more more when using, must right amount, because cassia bark, clove, fennel, ginger and peppery wait makings, although they belong to natural dressing, but if dosage is excessive, the secondary action with be had particular likewise and even noxiousness and lure denaturation, when be being used so, answer with " peace is little not much " advisable.

使用时并非用量越多越好，一定要适量，因为桂皮。丁香。茴香。生姜以及胡椒等料，它们虽然属于天然调味品，但假如用量过度，同样具有一定的副作用乃至毒性和诱变性，所以使用时应以"宁少勿多"为宜。

The influence of acrylic acid and cetane alcohol,amount of catalyst and inhibitor,reaction temperature,reaction time were investigated.

实验结果表明，合成的最佳反应条件为：丙烯酸与十六酯的物质的量之比为1.2∶1，对甲苯磺酸的用量为0.6%，对苯二酚的用量为0.4%，反应温度为110℃，反应时间为5 h。

The effect of acetic acid and its consumption, chloranil and its consumption on the preparation of TAMD by means of dioxygen liquid-phase oxidation of TMAL was probed into, and the results showed that both of them had great influence on the yield of TAMD.

探讨了冰乙酸及其用量、四氯苯醌及其用量对氧气液相催化氧化孔雀绿隐色体制取孔雀绿醇色体的影响，发现二者对醇色体的收率和纯度均有很大影响。

CH2Cl2 was a proper solvent for most of free cinchona alkaloids to achieve higher enantioselectivities, while THF was a better solvent for all the 1,4-dichlorophthalazine derivatives.

使用5mol%的催化剂获得了最佳的反应结果，3mol%的用量使ee值降低了5%，1mol%的用量则降低15%，但是当催化剂增至10mol%或20mol%，ee值也没有提高。

The preparation technology of Artemisia oil microcapsule was studied by complex coacervation method with gelatin and acacia .

采用复合凝聚法对艾蒿油的明胶/阿拉伯胶微胶囊抗菌防霉剂的制备工艺进行了研究，考察了乳化转速、表面活性剂用量比例、交联剂用量等因素对微胶囊形态的影响。

When the sodium lauryl sulfate and p-octyl polyethylene glycol phenyl ether is used and its level in 3% and 6: 4 ratio, the polymerization process has the lowest coagulum and the highest monomer conversion. Higher reaction temperature and more level hydroxyl value lead to more coagulum, the latter also lead to larger particle size. The acid value has larger influence on viscosity and coagulum, there exist a best range. The emulsion particle size is larger for its hydrophilicity, most of its particles are connected together.

在含较高亲水单体的乳液聚合体系中，难以制得稳定的预乳化液，不能采用工业生产中常用的预乳化工艺，而只能采用混合单体直接滴加的方法；由于单体混合物的亲水亲油值较高，用阴离子型乳化剂十二烷基硫酸钠和非离子型乳化剂聚乙二醇辛基苯基醚混合，用量为单体总量的3％，且比例在6：4时，乳液聚合时具有最低的凝聚物含量和最高的单体转化率；乳液聚合反应温度升高，可以提高单体转化率，增加反应速度，但凝聚率相应提高；随着羟基单体含量的增加，聚合过程中凝聚率增加，聚合物乳胶粒平均直径增加；羧基单体有一个最佳的用量（2.6％），过高或过低凝聚率均提高；羧基含量对乳液的粘度有较大的影响，当羧基含量较低时，羧基含量增加，乳液粘度增加明显；含羟基乳液粒子由于含亲水基团较多，使得乳胶粒径增大，乳胶粒子大多数互相凝聚在一起，处于凝聚态。

The effect of process parameters such as complex temperature,quantity of urea,stirring rotation rate,reaction time,washing times and the quantity of washing agent on product quality and yield is studied, the suitable production conditions are gained.

研究络合反应温度、尿素用量、搅拌器转速、反应时间、络合物洗涤次数和洗涤剂用量等工艺参数对产品质量和收率的影响，得出适宜的生产条件。

It is shown that beams of reinforced average strain distributing accord with flat section assume; The method of strengthening intension of concrete structure with reinforced materials is a feasible way. The strength of beam can be increased with the number of reinforcement materials be added; The strength of beam is affected by percentage of flexural reinforcement and the compound proportion and fashion of reinforcement materials and the number of reinforcement materials; The capability of bend and stretch and price of inner hybrid fiber is better than sole fiber and exterior hybrid fiber.

通过分析可知：加固后的梁，其平均应变的分布符合平截面假定；使用加固材料来提高混凝土受弯构件承载力的补强加固方法是有效的；构件受弯承载力随加固材料用量的增加而提高；纵筋配筋率、加固材料混杂比例及混杂方式、加固材料用量均对受弯承载力有一定的影响；层内混杂纤维的抗弯性能、延伸性能以及经济性均优于单一纤维和层间混杂纤维。

The conductibility and mechanical properties of SGB/VMQ composites were good when fillers of SGB were 41 μm and 300 phr.

SGB的粒径越大，用量越多，SGB／VMQ复合材料的导电性能越好，当其粒径为41μm、用量300份时，填充的VMQ具有优良的力学性能和导电性能。

In the process of MgO preparation, the amount of solvent, reaction temperature and the amount of citric acid have varying effects on gel time and crystallite size.

在制备纳米MgO过程中，溶剂用量、反应温度和柠檬酸用量对凝胶时间和晶粒都有不同程度的影响。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。