球形的
- 与 球形的 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
The basic worm helicoid surface of sphericity hob was deduced, and the coordinate systems for cutting face gears were established.
推导了球形滚刀基本蜗杆螺旋面方程,建立了滚切面齿轮的坐标系统。
-
CT examination is very helpfully to the correct diagnosis of spherical pneumonia.
CT检查有助于球形肺炎的正确诊断和鉴别诊断。
-
Seed 1 and globose or rarely 2 and hemispheric; cotyledons fleshy.
种子1 和球状的或很少2 和半球形;子叶肉质。
-
Experimental research for viscous pressure forming of hemispherical part is presented in this paper.
本文对半球形件的粘性介质胀形进行了实验研究。
-
Good agreement is found between the theoretical predictions and the experimental results in the springback of hemispherical parts.
利用该算法对半球形零件的拉深回弹进行了预测,所得结果与实验结果吻合较好。
-
In the upper part the vertebral body is hemispherical whereas in the lower part it is triangular.
上半部的椎体外形为半球形,而下半部为三角形。
-
Development of Hemispherical Instrument for Sky Brightness.
一种半球形天空亮度测量仪器的研制。
-
Small, hemispherical domains of the aggregation of rod-blocks are formed at low temperature.
在温度低时,会出现由硬杆所聚集而成的半圆球形聚集结构。
-
Dimensional analysis was constructed to derive the dimensionless functions of a spherical indenter with 1 mm in diameter.
采用量纲分析法,建立了直径1 mm球形压头的无量纲函数。
-
Therefore, the stress and strain of a half infinite plane indented by a sliding spheric tip were calculated based on an elastic-linear strengthened plastic deformation model, making use of a commercial software.
选用20#钢、45#钢、T8钢3种材料作为研究对象,利用三维有限元法动态模拟刚性球形磨粒在弹-线塑性平板上的压入-划动过程,所用磨粒半径为0.15mm,试样尺寸为1.2mm×1.2mm×3.0mm,划动距离1.2mm;采用ANSYS/LS-DYNA软件对每种材料在压入深度0.01~0.10mm范围内进行10次动态模拟。
- 推荐网络例句
-
The split between the two groups can hardly be papered over.
这两个团体间的分歧难以掩饰。
-
This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.
这种做法不仅鼓励了更多的反应,而且减少跟风的可能性。
-
The new PS20 solar power tower collected sunlight through mirrors known as "heliostats" to produce steam that is converted into electricity by a turbine in Sanlucar la Mayor, Spain, Wednesday.
聚光:照片上是建在西班牙桑路卡拉马尤城的一座新型PS20塔式太阳能电站。被称为&日光反射装置&的镜子将太阳光反射到主塔,然后用聚集的热量产生蒸汽进而通过涡轮机转化为电力