球化

The results show that high energy ball milling refines and homogenizes the mixed powders, accelerates the sintering process, and with the increase of milling time, the grain is finer and the alloy is denser. HIP and forging is beneficial to decrease or remove the pole formed during the sinter course, and as the last process, forging breaks the junctions between TiC particles, the microstructure and mechanical properties of alloy are improved.

研究结果表明：高能球磨使粉末细化和成分均匀化，促进烧结进程，随球磨时间的延长，合金组织细化且致密；热等静压和锻造工艺可进一步减小和消除合金中烧结后残留的孔洞等缺陷；锻造作为最后工艺，可使TiC颗粒之间的连接破碎，促使硬质相颗粒弥散分布，从而改善烧结组织，提高合金的致密性及力学性能。

The plasmid pcDNA3.1-3-1E and pcDNA3.1 was respectively used to immunize SPF chicks by injection intra-muscularly in thigh muscle at 14 and 21 days of age.Chicks in each group except that in the unchallenged control group were challenged with 5×104 E.acervulina sporulated oocysts at 28 days post-inoculation,and the immune protective efficacy was observed.

将构建的重组质粒以及空载体质粒分别于14、21日龄分2次经腿部肌肉注射免疫SPF雏鸡，28日龄除非免疫非感染对照组外各组攻击性感染5×104个堆形艾美球虫孢子化卵囊，观察真核表达质粒对球虫感染鸡的免疫保护作用并探讨其免疫保护机理。

To analyze effect of diclazuril and maduramycin on 18S rDNA of Eimeria tenella, the 18S rDNA of sporulated oocyst of the E. tenella anti-diclazuril strain, the E. tenellaanti-maduramycin strain and the E. tenella drug-sensitive strain were cloned and sequenced, and were compared by using DNAStar 5.0 and RNADraw 1.1, respectively.

为探讨抗球虫药物地克珠利和马杜拉霉素对柔嫩艾美球虫18S rDNA的影响，分别对人工诱导的柔嫩艾美球虫地克珠利抗药株、马杜拉霉素抗药株和药物敏感株孢子化卵囊的18S rDNA基因进行了克隆测序，并通过生物信息软件进行对比差异分析。

Ten 10-day-old artificially-reared coccidian-free goslings were inoculated orally with 2.0×105-6.5×105 of sporulated oocysts of Eimeria stigmosa,respectively, and killed at intervals from 48th h to 180th h post-inoculation.

给10只10日龄雏鹅分别经口接种2.0×105~6.5×105个多斑艾美球虫孢子化卵囊，在接种后48~180h分期剖杀，对多斑艾美球虫的生活史和致病性进行了动态观察。

Study the result makes clear, normal temperature ball grinds a condition to fall, cu-Cr mixed powder end realizes alloy to change; to grind the temperature inside coal tub when the ball hard under 10 ℃ when, cu-Cr mixed powder end forms Cr the solid solution in Cu.

探究结果表明，常温球磨条件下，Cu-Cr混合粉末难以实现合金化；当球磨罐内温度低于10℃时，Cu-Cr混合粉末形成Cr在Cu中的固溶体。

Friday, rubber, plastics, rubber adhesive tape test series grinding test machine, wear test machine, wear testing machine, folding machine, foam compression stress test machine, foam plastic repeated compression test machines, test material removed machine, Determination of the plastic melt index machine, impact testing machine, heating distortion temperature testing machine, falling ball impact test machine, rigid plastic drop hammer impact test machine, plastic film drop hammer impact testing machine, high temperature ashing furnace, temperature testing machine tape retention, Tape retention test machine, the beginning of sticky tape ball test machine, color device, industrial projectors, coordinate measuring instrument.

五、橡胶、塑胶、胶带试验系列橡胶胶磨试验机、磨耗试验机、耐磨试验机、耐折试验机、泡棉压缩应力试验机、发泡塑反复压缩试验机、试料磨平机、塑胶熔融指数测定机、冲击试验机、加热变形温度试验机、落球冲击试验机、硬质塑胶落锤冲击试验机、塑胶膜落锤冲击试验机、高温灰化炉、恒温胶带保持力试验机、胶带保持力试验机、胶带初粘性滚球试验机、色差仪、工业投影仪、三座标测量仪。

The mainly conclusions in our research are as flowing: tungsten trioxide powders with 100 nm primary particle are obtained by spray drying,calcination and wet milling process, and an average size of quadric particle composed of agglomerated particles is 0.64 μm; tungtsen powders with 39 nm grain size and 60 -100 nm primary particle are produced directly from previous tungsten trioxide using one step reduction in hydrogen at 700℃, and an average size of quadric particle of tungsten powder is 2.91 μm; tungsten trioxide and copper tungstate compound powders with 100 nm - 200 nm primary particle are produced using ammonia metatungsten and copper nitrate as raw materials by spray drying,calcination and wet milling process;the compound powders are transformed completely into tungsten and copper compound powders by reduction in hydrogen at 700℃,in which tungsten grain size is 59 nm and copper grain size is 51 nm; primary particle size of compound powders is 80 - 120 nm,and an average size of agglomerated quadric particle is 1.86 μm; tungsten nitride powders with 35 nm grain size are prepared from tungsten trioxide powders by nitrogen treatment thoroughly in pure ammonia at 650℃, and an average size of agglomerated quadric particle is 0.64 μm in normal temperature.

研究结果表明：采用喷雾干燥—焙烧—球磨工艺可以制备出粒度约为100nm的WO_3粉体，它们在团聚后形成的二次颗粒平均粒度为0.64μm；采用一步直接氢还原方法可在700℃下从上述WO_3粉体制备出晶粒尺寸为39nm的、一次颗粒粒度为60-100nm的W粉体，其二次颗粒的平均粒度为2.91μm；以偏钨酸铵、硝酸铜为原料，采用喷雾干燥—焙烧—球磨工艺可制备出一次粒度为100-200nm的WO_3和CuWO_4混合粉体；采用氢还原工艺可在700℃下将这种粉体完全转变为W、Cu复合粉体，其中W的平均晶粒粒尺寸为59nm，Cu的平均晶粒尺寸为51nm；复合粉体的一次颗粒尺寸为80-120nm，在常温下团聚后形成的二次平均粒度为1.86μm；采用纯氨氮化工艺可以在650℃下由WO_3粉体制得WN，其晶粒尺度为35nm，在常温下团聚后的二次平均粒度为6.4μm。

Maximum likelihood detector is the optimal detector and has the best performance. The challenge of MLD is the high computational complexity. K-Best decoding algorithm has been proposed to reduce the computational complexity. K-Best decoder algorithm computes Partial Euclidean Distance and only keeps the best K nodes that have the smallest accumulated PEDs. After completing breadth-first tree search, we will have K leaves with the smallest PEDs.

最大相似度侦测法是公认最佳化的演算法，有著最好的侦测效能，但运算复杂度将会随著调变群集和传送天线数目大小而呈指数型增加。K-Best球型解码演算法因而被提出来，得到近似最大相似度侦测法的结果，解决最大相似度侦测法运算复杂度过高的问题。K-Best球型解码演算法在计算完部份欧几里德距离后，需要取最小K个值做为候选点，再往下层去找候选点。

Mats; Elevator mats; cleaning Agent Series: air fresheners;§à; hand sanitizer; disinfectants; surface wax; at the end of wax; maintenance wax; furniture wax; wood floor wax; free throw wax; from wax water; low foam carpet water; carpet stains in addition to agent; of foam agent; electrostatic dust lead agent; Degreaser; derusting agent; In addition to gel; wall cleaning agent; acidic, alkaline cleaning agents; stone wash water; bathroom cleaners; cement ash agent;àagent; aromatic ball; Bi Livzon; hundred Livzon; rub silver paste; rubbed copper water; stainless steel brightener; aluminum brightener; crystal hard powder; K2, K3 powder; Stone derusting agent; stone care agent; daily sundry goods series: indoor and outdoor environmental dustbin; the garbage bin; debris barrels; buckets; radius wastepaper basket; trash bag; folding ladder; Human word ladder; one meter Benchmarking Block; peracetic acid; 84 fluid; alcohol; to Su water; hydrochloride; thin materials; cleaning Ling; detergent; floor brush; Dunbur;ó; broom; dustpan;§°brush; Paper Chuai son; push snow shovel; towel; toilet paper; gloves; scouring pad; Tan Shannon; clean ball; wire cotton; labor supplies; cleaning service

空气清新剂；玻璃清洁剂；洗手液；消毒剂；面蜡；底蜡；保养蜡；家私蜡；木地板蜡；免抛蜡；起蜡水；高低泡地毯水；地毯除渍剂；化泡剂；静电牵尘剂；除油剂；除锈剂；除胶剂；外墙清洁剂；酸性、碱性清洁剂；洗石水；浴室清洁剂；水泥除灰剂；洁厕剂；芳香球；碧丽珠；百丽珠；擦银膏；擦铜水；不锈钢光亮剂；铝品光亮剂；晶硬粉；K2、K3粉；石材除锈剂；石材护理剂；室内、外环保垃圾桶；果皮箱；杂物桶；水桶；方圆纸篓；垃圾袋；折叠梯；人字梯；1米线标杆座；过氧乙酸；84液；酒精；来苏水；盐酸；稀料；洗洁灵；洗衣粉；地板刷；墩布；笤帚；扫帚；簸箕；恭桶刷；皮揣子；推雪铲；毛巾；卫生纸；手套；百洁布；檀香；清洁球；钢丝棉；劳保用品；保洁服

Traditionally ellipsoids and hyperboloids are modeled as implicit surfaces or through the use of rational surface schemes. The existing methods for generating spheres or quadrics have shortcoming such as the rational parameterizations for these surfaces are non-uniform, the resulting scheme cannot represent these surfaces in their natural acr-length parameterization and the implementation of the scheme is complex.

长久以来，Subdivision方法对一些看似简单却又在计算机图形学中有着重要作用的曲线曲面的造型非常困难，即使是对简单的圆和球的生成也很困难，已有的一些生成球或二次曲面的Subdivision方法一般都有太复杂、不能自然弧长参数化或者计算量太大等缺点。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。