玻璃化的
- 与 玻璃化的 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
The viscosity of irradiated PP/SBS was lower than that of unirradiated PP/SBS, which implied that the irradiated blends could be easily processed by injection molding.
辐照一定剂量后,由于辐射交联和裂解的进行,使PP/SBS的流变性能和结构及内耗行为发生大的变化,PP与SBS两者玻璃化转变温度间距离变小,从而改善了PP/SBS的相容性。
-
Methods\ The 6 5mol/L glycerol and 6% BSA were used as the vitrification solution for the cryopreservation of morulae and blastocysts embryos of CBA,NOD,C 57 BL/6J,ICR and CD1 mouse.
采用 6 5mol L的甘油作为冷冻保护剂,采用二步法对CBA、NOD、C57BL 6J、ICR及CD1小鼠 3 5d的胚胎进行玻璃化冷冻,并比较了不同品系小鼠胚胎的复苏率及移植受孕率。
-
Porcelain: Vitrified pottery with a white, fine-grained body that is usually translucent.
瓷器:一种用白色细颗粒的材料制成的通常为不透明的玻璃化陶瓷。
-
The vanished streets could still be traced as faint marks in the vitrified ground, but of the houses, nothing remained.
消逝的街道,仍能在玻璃化后的地面上找到一点模糊的痕迹。但对于房屋,一丁点都没有留下。
-
The fast setting adhesive(HT-88)for GFRP was compounded from the prepolymer,low molecular polyamide,phenol aldehyde epoxy resin,bisphenol F type epoxy resin,liquid carboxylated butadieneacrylonitrile rubber,promotor,diluent and fillers.Its pot life,gelling time (at 60 ℃),glass transition temperature and shearing strength for bonding the unsaturated polyester GF...
该预聚物与低分子聚酰胺、酚醛环氧树脂、双酚F环氧树脂、液体羧基丁腈橡胶、促进剂、稀释剂、填料等复配的快固玻璃钢胶粘剂(HT - 88),在室温下的适用期为 30~ 4 0min ,6 0℃的凝胶时间为 10min ,玻璃化温度 16 0℃,粘接不饱和聚酯玻璃钢的剪切强度为 5~ 7MPa。
-
Two-phase structure of the ionomers was also demonstratedby the dual glass transition indicated in the dynamic mechanical spectra.
处于-40℃~-20℃之间的转变对应于富离子微区中的玻璃化转变,该转变温度与离子基团的含量有关。
-
The problems in the curmt methods of measuring glass transition are pointed out and the principle of cryoicroscope-DSC system in T'g measurement is analyzet.
指出了现有的测量T'g方法中存在的问题,分析了低温显微DSC系统测定T'g的原理,认为低温显微DSC系统是一种能准确测量玻璃化转变温度T'g的新型仪器
-
The non-isothermal decomposition kinetics of nylon 1010 and nylon 1010/POSS composites in nitrogen were investigated. POSS significantly increased the activation energy but had little effect on the reaction order.(5) Exploring research was carried out on the reaction between EVM and nylon 1010. The reaction between EVM and TsOH during melt mixing was also invesigated, and related reaction mechanisms were studied in terms of NMR, TGA-FTIR and etc.
五初步研究了乙烯-醋酸乙烯酯橡胶和尼龙1010在高温下的反应性,报道了EVM和TsOH在高温条件下的反应性,通过核磁共振、热重-红外联用等分析表征方法探索了相关的反应机理,EVM和TsOH反应后,EVM的耐溶剂性、玻璃化转变温度和力学性能均有所提高,而体积电阻率则显著下降。
-
The differential scanning calorimetry and thermal gravimetric analysis exhibited that the transition temperature and the temperature at which 5% mass loss occurred of PI-19 were 256 ℃ and 380 ℃, respectively.
示差扫描量热和热失重分析结果显示,PI-19的玻璃化转变温度为256 ℃,在5%的热失重温度为380 ℃,表明具有非常好的热稳定性。
-
The mechanical analysis showed that the effect of the DMSO was better than glycerol and glycerol/water.
动态力学和拉伸力学性能测试结果表明,经过DMSO的增塑,有效降低了淀粉的玻璃化转变温度,改善了材料的韧性,增塑效率要好于甘油及甘油/水复合增塑体系。
- 推荐网络例句
-
The split between the two groups can hardly be papered over.
这两个团体间的分歧难以掩饰。
-
This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.
这种做法不仅鼓励了更多的反应,而且减少跟风的可能性。
-
The new PS20 solar power tower collected sunlight through mirrors known as "heliostats" to produce steam that is converted into electricity by a turbine in Sanlucar la Mayor, Spain, Wednesday.
聚光:照片上是建在西班牙桑路卡拉马尤城的一座新型PS20塔式太阳能电站。被称为&日光反射装置&的镜子将太阳光反射到主塔,然后用聚集的热量产生蒸汽进而通过涡轮机转化为电力