英语人>网络例句>玻璃化 相关的搜索结果
网络例句

玻璃化

与 玻璃化 相关的网络例句 [注:此内容来源于网络,仅供参考]

With increasing in wood flour loading, the storage modulus and the glass transition temperature of the composite were decreased.

随着木粉含量的增加,复合材料的存储模量和玻璃化温度都有所降低。

According to the results of differential thermal analysis and thermogravimetry of a zein film, its glass transition temPerature is 171℃ and the decomposition temperature is 262℃.

醇溶玉米蛋白膜的差热分析结果表明其玻璃化转变温度为171℃,热分解温度为262℃。根据热重分析,温度为81℃时,失重率为2.3%,主要是乙醇及水分子的蒸发。262~355℃为产品急剧分解阶段,与差热分析结果相吻合。

Hrough copolymerization of styrene with few quantity of methacrylic acid, maleic anhydrate or 4-vinyl pyridine respectively and of butyl methacrylate with maleic anhydrate, the functional groups carboxyl, simple anhydride and pyridyl have been introduced respectively to the chain of PS or PBma.

通过苯乙烯与少量的甲基丙烯酸、马来酸酐或4—乙烯基吡啶的共聚及甲基丙烯酸正丁酯与马来酸酐的共聚,可在聚苯乙烯及聚甲基丙烯酸丁酯链上分别引入功能基因羧基、酸酐基和吡啶基对共聚物进行了红外光谱、酸碱滴定、元素分析、玻璃化转变温度、粘度及紫外光谱的测定。

The subject of this study is mainly to investigate the effect of improving the property of common asphaltic mixture when an appropriate amount of waste rubber powders are added on resisting low temperature cracking with the split cylinder test, the little beam bending test, the bhringkage test and unconfined compressive stress test of laboratory-compacted specimens.

本研究主要应用劈裂试验,小梁弯曲试验,收缩试验和无侧限抗压试验考察了在普通沥青混合料中掺适量废胶粉后对低温抗裂性能的改善效果。试验结果表明:掺3—5%的废胶粉,可以降低沥青混凝土的低温弹性模最和增大其变形均达1—3倍,玻璃化转变温度也比普通沥青乱凝土的低10℃以上。

Only a single glass transition temperature appeared in the dynamic mechanical spectra indicating atactic copolymers were obtained.

三元共聚物在动态粘弹谱图上只出现单一的玻璃化转变温度峰,是完全的无规共聚物,拉伸强度明显大于常规乳液聚合方法得到的聚合物,耐水性也得到显著提高。

Only a single glass transition temperature appeared in the dynamic mechanical spectra indicating atactic copolymers were obtained.The tensile strength and water resistance are higher than those of samples parpared by conventional emulsion polymerization method.

三元共聚物在动态粘弹谱图上只出现单一的玻璃化转变温度峰,是完全的无规共聚物,拉伸强度明显大于常规乳液聚合方法得到的聚合物,耐水性也得到显著提高。

According to the intrinsic viscosity in dichloroacetic acid at 25℃, the molecular weight of polymers were estimated to be 20, 000~50, 000.Because of the thermal instability of the urea bond in molecular chain, all synthetic polymers began to degrade around 220℃, and had no melting point.

由于模拟聚合物中所含的脲键存在着热不稳定性,所有聚合物的热分解温度都在220℃附近(低于天然动物丝蛋白分解温度),并且所有聚合物样品在熔融之前已开始分解;另外只有分子量比较大的模拟聚合物P4有明显的玻璃化转变(T〓=107℃)。

After that , the comparison of the fertilizable competences of ICSI and IVF on cryopreservated oocytes was studied in this article , in order to establish an optimized method to improve the fertilizable competences of oocytes up to the level of embryos .

和胞浆内单精子注射两种方法对玻璃化冷冻卵母细胞的受精能力进行了比较研究,旨在建立能够进一步提高牛冷冻卵母细胞受精能力的改进方案,使卵母细胞冷冻技术上升到与胚胎冷冻同样成熟的水平。

After that, the comparison of the fertilizable competences of ICSI and IVF on cryopreservated oocytes was studied in this article, in order to establish an optimized method to improve the fertilizable competences of oocytes up to the level of embryos.1 Effects of the reducing injury methods on IVF of cryopreservated oocytesThe result of the three methods, choosing the right time oocytes, using minimum size sample vitrification and culturing after thawing, showed that these ways could partly maintained the fertilizable competences of cryopreservated bovine oocytes.

减轻损伤方案对冷冻卵母细胞IVF的影响使用选择合适时期的卵母细胞进行冷冻;采用最小样本量玻璃化冷冻方法进行冷冻;在解冻后先孵育再进行体外受精等三种方案能够部分维持或恢复冷冻牛卵母细胞IVF受精能力。

With the percent of calcium chloride rises, the way of brittle rupture changes into flexile rupture.

DMTA测试结果为CaCl2和SEBS在共混体系中对尼龙6的玻璃化转变都产生作用。

第15/39页 首页 < ... 11 12 13 14 15 16 17 18 19 ... > 尾页
推荐网络例句

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应,而且减少跟风的可能性。

The new PS20 solar power tower collected sunlight through mirrors known as "heliostats" to produce steam that is converted into electricity by a turbine in Sanlucar la Mayor, Spain, Wednesday.

聚光:照片上是建在西班牙桑路卡拉马尤城的一座新型PS20塔式太阳能电站。被称为&日光反射装置&的镜子将太阳光反射到主塔,然后用聚集的热量产生蒸汽进而通过涡轮机转化为电力