环电流

In this paper, state-space averaging method is used to establish the small signal model of current regulator.

本文用状态空间平均法建立了电流调节器的充放电小信号数学模型，并在此基础上分别设计了电流调节器的充放电控制器，其中充电控制器采用滞环＋PI调节的方式。

By using these equtions, a vector control scheme of motor that is realized on EV under the d-q coordinates, and current loop and speed loop are included.

控制系统为电流环和速度环的双闭环系统。

Transmit Softclipping Time Constant Receiving Input Sidetone Network Input Line Current Regulation Stop Value Microphone Input Microphone Input Transmit Gain Adjustment Transmit and Receive Part Power Supply Ground Line Current Source Power Supply Voltage Stabilizer Positive Line Unregulated Microcontroller Power Supply Receive Gain Adjustment Negative Earphone Output Positive Earphone Output Ringer Buzzer Output Ring Power Supply Reset Power On Ring Indicator Oscillator Input Mask, Ring Melody Input Data Input Data Clock Input Microcontroller Stabilized Power Supply Reference Voltage (VCC/2) DTMF Filter

1第1页，本页显示记录1-8，共8条记录分1页显示发送Softclipping时间常数接收输入侧音网络输入线电流调节停止价值麦克风输入麦克风输入发射增益调整发送和接收部分电源地线电流源电源稳压器的正电源线无管制的单片机接收增益调整负耳机输出耳机输出正林格蜂鸣器输出电源供应环环指标振荡器输入掩码电复位，环旋律输入数据输入数据时钟输入单片机的稳定电源参考电压（Vcc / 2）双音多频滤波器

This paper designed a double close loop control system based on current and voltage.

摘 要：本文设计了电流闭环和电压闭环的双闭环控制系统。

The pulse power supply consists of three-phase half-wave thyristor rectifier and IGBT chopping circuit.

该电源采用三相半波晶闸管整流电路，IGBT进行直流斩波；根据电流电压反馈信号计算偏差，进行数字PI调节获得恒流、恒压输出特性；控制系统通过20mA电流环异步串行通讯接口与人机界面交换数据。

One ohm of resistance causes current flow of one a AMPLITUDE, The size or magnitude of a voltage or

环 物体周围的空电流的单位。1伏电压在1欧姆的电阻上所产生的电流为

The composition voltage, the electric current double closed loop voltage-stabilized source, used the integrated phase shifting crystal thyratron module to do for the electrical energy transformation component, in detail has calculated the rectification main circuit main component parameter; In the pulse-duration modulation part, used the special-purpose integrated circuit to realize the frequency modulation to adjust the pressure, did take IGBT as the power transformation component, realized the output voltage frequency modulation to adjust the pressure, and has calculated the related parameter.

在调压稳压电压源设计中采用二阶工程设计法设计了电压和电流调节器，组成电压、电流双闭环稳压电源，采用集成移相晶闸管模块做为电能变换器件，详细计算了整流主电路主要器件的参数；在脉宽调制部分，采用专用集成电路实现了调频调压，以 IGBT 做为功率变换器件，实现了输出电压的调频调压，并计算了有关参数。

Its software uses system self-detecting algorithm to assure measurement channel .It uses softening hardware technique software synchronic data sampling to trace the frequency of exterior signal, in other words , it gives sampling control signals 128 times of power net's frequency .It uses Direct Digital Frequency Synthetics algorithm to transform radical sine waveform parameter table into needed current. It uses FFT algorithm to get radical waveform altitude of current ,voltage and resistor .

整个系统在软件设计上采用系统自检验算法保证测量通道可用，采用硬件软化技术--软件锁相环技术，达到对外部信号频率的跟踪，给出频率为电网工频128倍的采样控制信号：直接数字频率合成技术将基波参数表转换成需要的电流信号，采用FFT变换及基波幅度的计算方法得到被测电流、电压基波幅度和电阻大小。

I put some current in side the surface and use two planes to cut the surface, then made two Amperian loops, then do integral on Theta.

里面是电流分布，然后我是用两个面把那一堆电流切开，做两个安培环，然后在THETA角上做积分。

Procedure for the three-ring servo system PID control algorithm simulation, which tricyclic ring for position, velocity and current loop Central.

此程序为三环伺服系统的PID控制算法仿真，其中三环为位置环、速度环和电流环。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。