环氧树脂

Composite material regards epoxy resin as fundamental application domain, more and more show wide market perspective, and it is among them important that epoxy resin glass reinforced plastics is become, apply at a lot of domains of national economy.

复合材料作为环氧树脂重要应用领域，越来越显示出广阔的市场前景，而环氧树脂玻璃钢则成为其中的重要一支，应用于国民经济的许多领域。

The friction coefficient and wear coefficient of resin depended on the content of hardener and independent the content of active dilution.

实验中发现，线性酚醛环氧树脂固化物的摩擦磨损性能与固化剂的结构和用量紧密相关，低于理论计算用量的固化剂与线性酚醛环氧树脂生成的固化物具有更低的摩擦系数和更强的抵抗磨损的能力。

Dynamic Viscoelastic and Thermal Properties of Flame-Retardant Epoxy Encapsulants Owing to excellent heat, solvent and chemicalresistance, good adhesion and inexpensiveness, epoxy resin has been widely employed in the encapsulation of microelectronic devices.

viscoelastic动态特性和热火阻燃环氧树脂encapsulants 由于出色的热、溶剂和chemicalresistance、善意与廉、环氧树脂已广泛应用于微电子封装的装置。

Finally, the use of modified after the preparation of a new type of epoxy resin epoxy potting material, and its main targets were studied.

最后，利用改性后的环氧树脂制备出新型阻燃环氧树脂灌封材料，并对其主要指标进行了研究。

Propanol, on the other hand, can successfully break down epoxy.

然而乙醇和甲醇虽然能够有效溶解玻璃纤维复合材料中的聚酯树脂，但对环氧树脂的溶解效果欠佳，而丙醇则可成功地分解环氧树脂。

The crystallinity reach its peak when the content of epoxy is 1%, with the increase of epoxy resin content, the crystallinity of nylon 11 alloy decreases.

环氧树脂用量为1％时，尼龙11共混合金体系的结晶度最大，此后随着环氧树脂的加入，尼龙11结晶度随之降低。

Therefore, the toughness of epoxy resin has been developing one of the research hotspots.

因此，对环氧树脂的增韧改性成为环氧树脂的研究热点之一。

Adopting self-developed glycidyl amine-type high temperature resistant epoxy resin,MTHPA curing agent,toughener,active microsilica fillers and other additives as the basic materials,the high temperature resistant casting material s which have better mechanical strength,electrical insulating properties and capability of crack-resistant were prepared.

采用缩水甘油胺型耐高温环氧树脂、甲基四氢苯酐固化剂为主要原料，加入海岛型结构增韧剂与活性硅微粉填料及其他助剂，制备出具有良好力学、电气性能与耐开裂性能的耐高温环氧树脂浇注料。

Adopting self-developed glycidyl amine-type high temperature resistant epoxy resin ,MTHPA curing agent,toughener,active microsilica fillers and other additives as the basic materials,the high temperature resistant casting materials which have better mechanical strength,electrical insulating properties and capability of crack-resistant were prepared.

采用缩水甘油胺型耐高温环氧树脂、甲基四氢苯酐固化剂为主要原料，加入海岛型结构增韧剂与活性硅微粉填料及其他助剂，制备出具有良好力学、电气性能与耐开裂性能的耐高温环氧树脂浇注料。

So it is an important subject to improve its toughness with every kind of methods and has great significance.

因此用各种方法增韧环氧树脂是一个重要的课题，对环氧树脂的研究具有重大意义。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。