环氧树脂

Epoxies – made by complex chemical reaction.

环氧树脂——通过负载的化学反应制成。

Polyesters are less brittle than epoxies, but not as flexible or tough as urethanes.

聚酯没有环氧树脂发脆，但也没有聚氨酯的坚韧性。

Applied Nanotech has developed CNT reinforced epoxies for carbon fiber reinforced polymers and glass fiber reinforced polymers.

应用纳米技术公司研制出一种碳纳米管环氧树脂碳纤维增强聚合物和玻璃纤维增强聚合物。

Two component epoxies and polyurethane potting materials are used in electronic device housings to improve vibration, shock, and water resistance of assemblies, increase mechanical strength, and provide electrical insulation.

双组分环氧树脂和聚氨酯封装材料，使用在电子设备的封装，防止震动，冲撞，水分的接触；提高机械强度，起到绝缘的效果。

A disadvantage that has prohibited cationic epoxies from more uses in wood coating is their sensitivity to humidity and the fact that some woods are alkaline in nature.

阻碍阳离子环氧树脂在木材涂料当中应用的是因为它们对水分很敏感，以及一些天然的木材是碱性的。

A modest clamping pressure is recomm ded for the epoxies during the cure period.

有人 建议在治疗期内对环氧树脂施加中等的夹持压力。

High strength epoxies are used to construct rotor blades of helicopters, attach aluminum skins to the struts of aircraft winds and tail sections.

高强度环氧树脂用于构建直升机的旋转叶片，将铝合金蒙皮粘附到飞机机翼和机尾部分的支柱上。

Polyesters exhibit better non-yellowing properties than epoxies, but not as good as aliphatic urethanes.

聚酯的耐黄性优于环氧树脂，但弱于脂肪族聚氨酯。

Thermoset epoxies have many good properties but a lack of toughness can cause catastrophic failures caused by crack propagation.

虽然热固性环氧树脂具备很多优良的性能，但是，由于缺乏韧性，会导致部件受损处裂纹不断延伸，最终酿成重大事故。

Vinyl ethers in combination with cationic epoxies cure extremely fast, producing very hard, high-gloss coatings.

乙烯醚同阳离子环氧树脂组合后，固化特别快，形成非常坚硬，高光泽的涂层。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。