环氧树脂

Green color of the board, it indicates it is made of glass-epoxy which is naturally greenish in color.

如果你指的物理董事会绿色，这表明它是由玻璃环氧树脂这是自然的颜色绿色。

DongGuan WingOn Adhesive-Product Factory produces the PE protection film , BOPP protection film , PET heat protects film and Polyimide Film , PET , insulate the paper reunite the tape, Mala Adhesive Tape, the industry double- side tape, thin film beginning double- stick tape and oil water gum glues an oxygen resin AB gum.

东莞市永安胶粘制品厂生产PE保护膜、BOPP保护膜、PET高温保护膜、压纹保护膜、聚酰亚胺胶带，聚酯薄膜，绝缘纸复合胶带，玛拉胶带，工业双面胶，薄膜开关双面胶及油性水性胶粘剂、环氧树脂AB胶。

A series of interpenetrating polymer network materials, based on a rosin-based epoxy resin and a turpentine-based polyurethane were prepared from gum rosin and turpentine oil.

以同步法制备不同配比的松香基环氧树脂/松节油基聚氨酯互穿网络体系。

One, the epoxy itself which is in the form of a thick liquid, sometimes is called a "resin" and the other is an "accelerator" or "hardener".

一种是稠状液体的环氧树脂本身，有时称"树脂"，另一种是"加速剂"或"固化剂"。

In this work,a methodology was developed to investigate how glass transition temperature of cured epoxy resins varied with different hardener s.

提出了一个分子动态模拟方法研究环氧树脂玻璃化转变温度随固化剂结构变化。

Solid brass molded, ceramic headwork, PP knob, epoxy resin powder coating on the surface, strong acid and alkalis resistant and anti-rusty.

采用实验室专用化验龙头，阀体采用全铜铸模工艺制造，高强度陶瓷阀心，手柄为耐酸碱高强度聚炳烯材质，表面经环氧树脂粉末高温烧涂工艺处理，整体具备防酸碱及防锈特性。

This will hold it in place until you mix the epoxy.

这将举行它在的地方，直到你混用不同的环氧树脂。

Some epoxy must applied to hold the weight in place.

一些环氧树脂必须适用于持有的重量在的地方。

Provided is a liquid crystal sealant composition in which an aqueous solution obtained by admixing the epoxy resin composition with purified water has an ionic conductivity of 1 mS/m or less; the B stage-reduced product has a viscosity of 50 to 10000 Pa.s at 80 to 100 DEG C; the cured matter of the above composition has a linear expansion coefficient of 10x10-5 mm/mm/ DEG C or less and a glass transition temperature Tg of 100 DEG C or higher; and the above cured matter has a moisture permeability of 200 g/m2.24 hours or less at 80 DEG C and which can meet a liquid crystal display element produced by a single layer press hot bonding system and exhibits high adhesion reliability and makes it possible to produce a homogeneous liquid crystal display element having a high quality.

本发明提供一种液晶密封剂组合物，其中：通过将环氧树脂组合物与相同质量的净化水混合得到的水溶液具有离子电导率为1mS/m或更小；在80～100℃下半溶阶段折合产物的粘度为50～10000Pas；上述组合物的固化物具有线膨胀系数为10×10－5mm/mm/℃或更小，热形变温度Tg为100℃或更高；且上述固化物在80℃时具有透湿率为200g/m224小时或更小，这能够满足通过单层热压粘结体系生产的液晶显示元件，并具有高的粘结可靠性，使得有可能生产出具有高质量的均匀液晶显示元件。

On the other hand, attempts have been made to homogeneously dissolve the linear thermoplastic polymers in the epoxy resins.

以改性的环氧树脂做基体，制备了拉挤复合材料，并对其力学性能进行测试分析。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。