环境温度
- 与 环境温度 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
When a water circulate floor heating system is not able to heat up the room to a curtain level within a curtain time as usual, it must be large amount of biological mud depositing inside the pipes .Statistics shows every 1mm biological mud will cause 6°C reducing of room temperature, this does not only effect the room temperature but also cause energy waste.
用户家里在采暖室内明显比以前的室内温度有所降低;这是因为地热管内壁产生了大量的生物粘泥,据有关资料统计,在采暖过程中,地热管内壁每增加1MM水垢,就会使环境温度降低6°C,这不仅影响了正常的所需温度,而且也造成了大量能源的浪费。
-
Testing experiments on the illminating lines at channel foreside of furnace in electric power factory are made by AGEMA570 and cooling infrared imager with focus plane array detectors.
利用AGEMA5 70非制冷、焦平面红外热像仪对供电厂炉前隧道的照明线路等进行了实测,获得一定工作温度、环境温度下的线路接头温度及其温升。
-
DS18B20 use of the design of digital temperature sensors measure ambient temperature, can provide temperature signals in the four-way acquisition.
本设计中利用 DS18B20 数字化温度传感器测量环境温度,可提供4路温度信号的采集。
-
The new product for gives off heat the pad from the fluctuation power,causes to give off heat the pad changes along with the ambienttemperature and the human body temperature, automatic elevation oftemperature automatic accent warm, does not need the hand regulation,cannot have the hyperpyrexia and excessively is low, achieves thegenuine comfortable boundary.
新产品为自动变功率发热垫,使发热垫随环境温度和人体温度而变化,自动升温自动调温,无需人工调整,不会产生温度过高和过低,达到真正舒适的境界。
-
Results indicate that the fatigue life of CA mortar is logarithmically linear with stress levels and the viscoelasticity of CA mortar guarantees a good fatigue performance at -20℃.
结果表明,研制的CA砂浆疲劳寿命对数值与应力水平呈现良好的线性相关性;CA砂浆的抗压强度受环境温度影响较大,相同应力水平条件下,CA砂浆在负温环境中的疲劳寿命低于在常温环境中的,CA砂浆的粘弹性特点保证了CA砂浆在-20℃环境仍具有良好的耐疲劳性能。
-
Business card printing and membership card making Ink viscosity in business card printing and membership card making faster, rollers and plates after the ink friction heats gets smaller, on the rising of the ambient temperature, the viscosity of ink will drift away, this time using the innovativeink, with the temperature increase, decrease viscosity is referred to as a viscosity index of added value, that is, the viscosity index is a viscosity index of temperature-dependent, for example, at a low temperature solvent oil sludge formation, if you join methylmetacrylate and transfromer monosomic of multi-fault copolymer exclude this.
制卡和会员卡制作油墨的粘度在随制卡和会员卡制作速度的加快时,因墨辊与印版摩擦后油墨温度升高而变小外,当环境温度的上升后,油墨的粘度也会逐渐变小,这种在使用油墨时,随着温度的上升,其粘度下降的行为被称为粘度指数增加值,即粘度指数是表示粘度随温度变化的指标,例如,溶剂油在低温下形成淤浆时,如果加入甲基丙烯酸酯和极性单体的共聚物排除此类故障的发生。
-
The calling and copulation behaviour of Ancylis sativa Liu had a dielperiodicity.The female moths began to calling at the first day and increasedto 100% at the second day,then the percentage of calling decreasedgradually from the third day to the fifth day,only 16.7% of females showingcalling behaviour at the sixth day.The effect of environmentaltemperature on calling behaviour of Ancylis sativa Liu was studied duringadult life at 16℃,21℃,26℃ and 31℃.The result showed differenttemperature during adult life affected significantly the calling behaviour ofvirgin females.There was considerable variability in the calling patternsamong the different temperature groups,the higher the temperature was,thelater females called,the shorter the calling behaviour lasted.The copulationbehaviour of Ancylis sativa Liu can be divided into following squence:female calling,male responsing,male approaching female,hairpencil displayingand copulating.
枣粘虫求偶和交配行为研究结果表明,在光周期为14L:10D、温度为21℃下,越冬代枣粘虫雌蛾的求偶高峰期为黑暗期6.0-8.0小时,求偶活动以羽化后1-3天表现强烈,第二天求偶百分率高达100%,第4天开始,求偶百分率下降,到第6天仅为16.7%;环境温度对枣粘虫雌蛾的求偶活动有明显的影响,随着温度的下降,求偶高峰期明显提前,求偶高峰期的持续时间变长,在21、26、31℃下,求偶百分率接近或达到100%,在16℃下,仅为43%;枣粘虫的交配行为可分为雌蛾求偶、雄蛾反应、雄蛾接近雌蛾、打开味刷及交配成功等阶段;交配活动也以羽化后前3天表现强烈;第1、2代在黑暗周期中的交配高峰期比越冬代推后1-2.5小时;越冬代枣粘虫的交尾持续时间多为3-4小时,第1、2代比越冬代短;越冬代交尾前期多为2-3天,第1、2代多为1-2天,少数羽化当天便可交尾;雌雄成虫均有多次交尾习性,雄蛾最高交尾6次,平均3.3次,雌蛾最多交尾3次,平均1.5次,在田间自然条件下,大多数越冬代雌雄成虫只交尾1次,第1、2代交尾次数有所增高,第1、2代成虫交配率明显高于越冬代。
-
This article discusses the influence of urea prilling tower exit temperature on the water percentage of urea,analyses the factors influencing urea prilling tower exit temperature,and puts forowrd suggestions to control the tower exit temperature through replacing the prilling sprayer and adjusting the shutter opening of prilling tower according to atmosphere temperature and humidity.
讨论尿素造粒出塔温度对尿素含水率的影响,对影响尿素造粒出塔温度的因素进行分析,提出通过更换喷头及根据环境温度和空气相对湿度调节百叶窗开度来控制尿素造粒出塔温
-
A mathematic model, which deals with the relationship between maximum temperature of thick plate butt multipass welding and weld heat input, interpass temperature, ambient temperature and the distance of measuring points to heat source center, was founded using multivariant nonlinear regression analysis.
采用多元非线性回归的方法,建立了厚板对接多道焊的最高温度与焊接线能量、层间温度、环境温度以及测点到热源中心的距离之间的数学模型。
-
A mathematic model,which deals with the relationship between maximum temperature of thick plate butt multipass welding and weld heat input,interpass temperature,ambient temperature and the distance of measuring points to heat source center,was founded using multivariant nonlinear regression analysis.
采用多元非线性回归的方法,建立了厚板对接多道焊的最高温度与焊接线能量、层间温度、环境温度以及测点到热源中心的距离之间的数学模型。通过相关性检验、线性回归的显著性检验以及回归系数的显著性检验,证明了模型可行;同时分析了回归系数与测点到焊缝中心距离之间的关系。结果表明,它们之间的关系是一种非线性关系,而且呈现出了一定的变化趋势
- 推荐网络例句
-
Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).
呼气,收缩臀部肌肉;拱起身体,尽量抬起头来,右腿伸直朝向天花板(膝微屈,以避免肌肉紧张)。
-
The cost of moving grain food products was unchanged from May, but year over year are up 8%.
粮食产品的运输费用与5月份相比没有变化,但却比去年同期高8%。
-
However, to get a true quote, you will need to provide detailed personal and financial information.
然而,要让一个真正的引用,你需要提供详细的个人和财务信息。