率

RESULTS AND CONCLUSION: The average diameter of chitosan microsphere was 105 μm, with uniformed particle diameter.

结果与结论：壳聚糖微球平均粒径约为105 μm，粒径大小较一致，包封率约为80%，载药率约为11%，2周的累积缓释率为84%。

Grown alone, Rhizome of Oldworld Arrowhead , water lettuce, and Brazilian milfoil, have a DO increase rates of 62.5%, 50% and 50% in water respectively; Besides the total removal efficiency of BOD are 93.26%, 90.27% and 92.38%; What's more ,the total COD removal efficiency are 76.02%,, 71.58% and 79.76%. respectively.

单独种植的慈姑、大薸、穗状狐尾藻供试水体中DO的升高率分别为62.5%、50%和50%；对BOD的总去除率分别为93.26%、90.27%和92.38%；对COD的总去除率分别为76.02%、71.58%和79.76%。

At first step, the processor before the deformable body contact the end face of cone die cavity regarded as an extrusion process. The minification of core boss's cross-section regarded as compressibility of direct extrusion, which acted as definition factor when construct the Direct Extrusion Model element. Another step, the model element of flat punch extrusion on wedge piece process was constructed when propose the process of deformable body overflow die corner. In this way the spherical end face of blank looked as cone end face one, t he approximate treatment is one of originality innovation in this paper. At last, the two elements have been connected and constructed the model element of cone boss part's deformation in the open die forging.

对于锥形凸台成形的第一个特征时段，即坯料和锥形凸台型腔的端面接触之前的变形过程，本文将凸台的截面缩小率转换成挤压成形的压缩率并以此为界定，建立了不同截面缩小率时的锥形模正挤压的模型单元；对于锥形凸台成形的第二特征时段即锥形模的角部充满过程，在详细考察锥形型腔端面对变形过程影响的基础上，将变形体的球形端面近似成锥面建立了平冲头挤压楔形体的模型单元；最后将前述两种模型单元有机连结，构建了开式模锻中整个锥形凸台成形过程的定量描述。

The results showed that increasing zero-valent iron dose and temperature can enhance the removal rate of molybdate; the maximum removal rate was 96% at pH = 2.0, which decreased with the increase of pH value.

结果表明，随着零价铁投加量的增大和温度的升高，钼的去除率有所提高；在pH=2.0时零价铁对钼的去除率最高(96％)，随着pH值的升高，钼的去除率降低。

Results coculture with endometrial epithelial cells could promote the formation of mouse morula (71.3% and 61.2%,p.05) and blastocyst (50.0% and 39.7%,p.05), and increase the blastocyst hatched rate (34.8% and 24.3%,p.05) and total cell number of blastocyst (44.1 and 35.6, p.05).conclusion coculture with endometrial epithelial cells can facilitate the development of early mouse embryo in vitro, which can optimize the condition of embryonic development in vitro.

结果：与无上皮细胞相比，共培养明显促进了小鼠桑椹胚率（71.3%和61.2%，p.05），囊胚率（50.0%和39.7%，p.05），囊胚孵化率（34.8%和24.3%，p.05）和胚胎总细胞数（44.1和35.6，p.05）。结论：子宫内膜上皮细胞能够促进小鼠胚胎的体外发育，对早期胚胎的体外发育环境具有优化作用。

The study methods: Based on digital printing and offset printing technology principle, the basic parameters having effect on the ink-jet printing output quality were analyzed. And the mathematics models between the ink quantity and the solid density, and the relation between the gamma and printing contrast were established. The relation among the output dot area coverage, the original dot area coverage and the dot-gain percent was analyzed. And the mathematics models of printing characteristics curves and dot-gain curves were established. The factors influencing the dot-gain were analyzed, and then the dot-gain compensation function was acquired. All the models were verified by the method of regression analysis. And the precisions of the models were obtained by the correlation coefficient and multiple correlation coefficients.

研究方法：根据数码印刷以及胶版印刷的工艺原理，分析了影响喷墨印刷输出质量的基本参数，建立墨量与样张实地密度、γ与相对反差的数学模型；分析输出网点面积率、标定网点面积率以及网点扩大率三者之间的关系，建立网点扩大曲线和印刷阶调复制曲线的数学模型，并对网点扩大的影响因素进行了分析，导出了网点扩大补偿函数；运用回归分析方法分析模型，并用相关系数和复相关系数检验回归模型的显著性；使用灰平衡方程，结合回归法得出灰平衡控制曲线。

The tensile strength of CPE vulcanizates modified by in situ formed NaAA and LiAA is more than 30MPa and 28MPa, respectively.

原位合成丙烯酸盐改性CPE硫化胶在电解质水溶液中的吸水膨胀率比在去离子水中低得多，浓度越高这种效应就越强烈；温度提高可使硫化胶的吸水膨胀速度提高，在常温到60℃之间，吸水膨胀率随着温度的提高而增大，但超过60℃平衡吸水膨胀率则随着温度的提高而降低；硫化胶的吸水膨胀过程并不是单一的菲克扩散，其中还包括聚丙烯酸盐和橡胶分子链的松弛。

Divergence variation of snow storm indicated that the formation of negative divergent variation in lower-layer predicted the shear convergence and the snow storm generation. Nongeostrophic vorticity and divergence of wind advection contributed to the divergence variation largely.

暴雪切变线的散度变率诊断表明，低层散度负变率带及中心的生成和发展预示着未来时期内切变线辐合区的形成和发展及暴雪天气的发生，其中非地转涡度和风速平流的散度项对散度变率的贡献较大。

Result: The percentage of hyperdiploid cells, DNA Index and proliferative index were statistically higher in the vascular and the syncytial subtypes of meningioma than those in the fibrous and mixed subtypes, Also those in the severe edema group were higher than those in the moderate, mild and without peritumoral edema groups. The DNA hyperdiploidy were mostly found in the group of giant size tumor, DI and PI in the recurrent menigioma group were significantly higher than those in the nonrecurrent group.

结果：血管型、合体型脑膜瘤超二倍体率、DI和PI显著高于纤维型及混合型；重度水肿组DI、超二倍体率和PI显著高于中、轻及无水肿组；大肿瘤超二倍体率和DI均显著高于中、小肿瘤；复发性脑膜瘤的DI、PI均显著高于非复发组。

A DPLS discriminant analysis model was developed based on spectra region from 400 nm to 2 498 nm with mathematic pretreatment 2-8-6-1 and scatter correction treatment the standard normal variate. The accurate discriminant rate of calibration and external validation was 95.7% and 95.6% respectively. For the adulterated samples (MBM mass percentage≥5%), the accurate discriminant rate was 100%.

建立的判别分析模型：数学预处理方法为2-8-6-1，散射校正方法为变量标准化处理，光谱范围为全谱（408～ 2 492 nm），定标模型的正确判断率为95.7%，外部验证正确判断率为95.6%，对于掺入量≥5%MBM时，正确判断率为100%。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。