特性态

Photoresponse characteristics of Pr0.7Ca0.3MnO3 thin films were investigated under different applied voltages and excitation light energy densities at room temperature.

在室温下利用波长532nm，脉冲宽度7ns的纳秒脉冲激光研究了不同电压和激光能量密度作用下Pr0.7Ca0.3MnO3薄膜的瞬态光响应特性。

In order to improve the reliability of the nuclear Generating Sets and the stabilization of the power system, prevent the long time low frequency oscillation caused by the disturbed of the outside electrical net, assured improving the stabilization margin of the nuclear generating sets in the precondition of enough transient stability, validate the sensitivity of the parameter to the damping of Generating Sets of the MEC5220 digital excitation adjustor produce in Japan that used in the Second Project of Qinshan Nuclear Power Plant, confirm the parameter rationality of the digital excitation adjustor, optimize the parameter of PSS, in this paper, we put up a in-depth study to the principle of MEC5220 digital adjustor produce in Japan by the PSS/E software that develop by the PTI Company in the USA, completed the modeling of the excitation adjustor, PSS, generator, excitor, described the performance of this excitation adjustor, analyzed the essential reason that caused the low frequency oscillation, illuminated the factor that influence the damping characteristic of the MEC5220 digital excitation adjustor. Based on model and emulate, this paper optimized the primary parameter of the excitation adjustor, make a reasonable regulation to the PSS parameter.

为提高核电机组的运行可靠性和接入系统的安全稳定性，防止在外电网的干扰下核电机组发生长时间的低频振荡，保证机组在暂态稳定的前提下提高其稳定裕度，验证秦山核电二期核电机组所配日产MEC5220型数字式励磁调节器参数对机组阻尼的灵敏性，确定数字式励磁调节器的参数的合理性，优化PSS整定参数，本文利用美国PTI公司研发的PSS／E软件对日产MEC5220型数字调节器的原理进行进行了深入细化的研究，完成了励磁调节器、PSS、发电机、励磁机的建模，描述了该型励磁调节器的性能，分析了产生低频振荡的根本原因，阐明了影响阻尼特性的因素。

Based on this concept, the method of dynamic multi-dimension order control in Taylor series expansion technique for transient stability analysis is presented.

在计算暂态稳定轨迹的过程中，根据各个状态变量的不同动态特性和计算精度约束，对时间常数不同的环节采用不同的阶数。

The effects of the atomic initial state, mean photon numbers of field, the degree of the entanglement for the entangled coherent field, and the coupling strength between the Kerr medium and field on the atom's population are discussed via numerical calculations.

讨论了双原子体系的初态、初始光场的平均光子数、双模纠缠相干光场的纠缠程度及Kerr介质与双模光场的耦合强度对原子布居时间演化特性的影响。

That is vary important for finite element analysis of temperature field on the gear tooth surface.

完成了弧齿锥齿轮三维准稳态温度场有限元分析。为弧齿锥齿轮的摩擦学特性分析和胶合承载能力计算提供了必要的基础。

In addition, skewness coefficient and flatness coefficient were also measured.

为了探讨射流的统计特性，对偏态系数和平坦系数也进行了测量。

Fluidization engineering is concerned with efforts to take advantage of this behavior and put it to good use.

流态化工程所要研究的就是，如何利用这类特性并使之得到很好的工业应用。

The experimental research on fluidization characteristic of waste tyre was done in a cold fluidized bed.

在流化床冷态实验台上，对废轮胎的流化特性进行了实验研究。

The growth of thin fluorescein films on Ag(110) has been studied by ultraviolet photoelectron spectroscopy.

首先用UPS测量了Fluorescein在衬底Ag(110)表面上不同覆盖度时的电子态特性。

In this article two functional modes of the Fly-back Converter (Continuous Conduct Mode and Discontinuous Conduct Mode) are particularly analyzed, which include their characteristics, applications, the critical pattern of two functional modes is argued, both the exact boundary from the angle of circuit parameters is crystallized, at the same time, basic principle of PFC under the DCM mode is introduced, which settle theoretical basis for the subsequent design; by establishing the mathematic model of the converter, a further investigation of the configuration is made, qualitatively and quantitatively, analyzed to settle exactly theoretical basis for the subsequent emulation and the experimental parameter; from the angle of steady-state analysis, the transfer function of the system is deduced to establish dynamic small-signal state equation, emulating the system with the help of matlab, then according to the simulation result and the theory of PFC revise the system, lastly, we adopt the project which add a zero-pole compensator to the voltage loop, by this way, a satisfied system performance is gained and the PFC scheme is ensured successfully; finally, based on the previously-done work, we combining with the situation of specific design requirement, acquired the numerical value of each unit devices in this converter

详细分析了反激式变换器的两种工作状态，连续模式(Continuous Conduct Mode ，简称CCM)和断续模式(Discontinuous Conduct Mode，简称DCM)以及各自的特点、应用场合，论证了两种工作状态的临界模式，从电路参数的角度明确了二者的界限，同时还介绍了DCM模式下PFC的基本原理，为后面的设计奠定理论基础；通过对整个变换器系统建立准确的数学模型，对此变换器的电路结构做了进一步的研究，定性、定量地分析了变换器各部分的工作状态，为仿真和实验参数的确定以及电路参数的优化提供理论依据；从稳态分析的角度，为系统建立了动态小信号状态方程并推导出系统的传递函数，利用matlab对系统进行仿真，进而根据仿真结果以及PFC的相关理论对系统进行校正，采用在电压环加入零点—极点补偿器的设计方案，得到了满意的系统特性并且保证了PFC的顺利实现；最后，在前面所做工作的基础上，结合设计要求计算出此变换器系统中每个元器件的数值，利用Pspice对其进行了仿真、优化，然后根据仿真结果搭建了硬件电路。

She gently rebuff ed him, but agreed that they could be friends

她婉言拒绝了，但同意作为朋友相处。

If in the penal farm, you were sure to be criticized.

要是在劳改农场，你等着挨绳子吧！