物相变化

The results showed that glass transition temperature and crystallization peak temperature of the ceramics changed little with the increasing value of the ratio, but its phase composition changed greatly, i.e., from augite to diopside with grain size gradually decreased and crystals uniformly distributed.

结果表明：随着w/w(SiO2)比值的增加，玻璃的转变温度和析晶峰温度变化较小，但微晶玻璃的物相组成发生较大变化，由普通辉石转变为透辉石，微晶玻璃内部的晶体尺寸逐渐减小，晶体分布相对均匀；微晶玻璃的弯曲强度逐渐增加。

The influence of the ore fineness and the reductant content on the deoxidization process was studied.

摘 要：以生物制剂KZSH01作为还原剂与铁锰多金属矿发生氧化还原反应，研究了铁锰矿的细度和还原剂的含量对还原效果的影响，考察了还原过程中温度和物相的变化，探讨了H2SO4用量对Mn和Zn浸出效果的影响。

Phase transformation and morphological change of blended powder of Fe and Si (The Proportionment of atom: Fe:Si=3:1) were studied during high-energy ball milling.

研究了Fe和Si（原子比为：Fe：Si=3：1）混和粉末在高能球磨过程中的物相转变和形貌变化。

By prereducing ore in static bed and final reducing in ore furnace stimulating the process of smelting reduetion with iron bath, the feature and mechanism for the corrosion of Al2O3-C-TiO2 and Al2O3-C-TiC refractories are studied,the influence of composition and characteristics of the melt on the corrosion of refractories and the changes of microstructure and phase composition of refractories are also analyzed.

模拟铁浴式熔融还原工艺，采用固定床预还原法对铁矿石进行预还原、在矿热电炉上进行终还原熔炼试验，研究和测试了Al2O3-C-TiC质耐火材料的侵蚀特征和侵蚀机理，分析了熔体组成与性质对耐火材料侵蚀过程的影响及熔体侵蚀过程中耐火材料的物相组成和结构变化规律。

It uses FactSage software to simulate thermodynamics state of the mass change of calcium oxide and sodium oxide in shen mu coal and calculates reactive degree. It can instruct the study of slagging of boiler .

利用FactSage软件对神木煤模拟灰中钙含量变化和硅含量变化进行了热力学平衡状态模拟，计算其反应的程度及其各个温度点的反应物相。

CuSO4 and thiourea were used as the starting materials without assistance of any surfactant or template.

考查了溶剂组成、反应时间、实验温度的变化对所制备样品的形貌和物相结构的影响。

The phases of ferrum are sensitive indicators of the geochemical environment changes.

铁元素的物相特征是其所处地球化学环境变化的敏感标志。

Chemically pure elemental Al and CuO powder with an Al mass percentage of 20, 35, 57, 70 and 85 were milled respectively. The ball milled powders were analyzed by X-ray diffractometry and differential scanning calorimetry. When the amount of Al was under 20%, the reduction occurred only. When the amount of Al exceeded 20%, besides reduction, the synthesis reaction occurred simultaneously.

对Al含量在20%～85%范围内的Al/CuO进行高能球磨，采用X射线衍射进行物相分析，并对Al含量分别为20%和75%的试验分析了物相随研磨时间的变化，做了差示扫描量热分析，对比研究了固态还原反应与固态复合反应过程的异同。

The preparative technique of solid lubricant is cold-press sintering method.The micro-structure , friction surface, lubricant transfer film surface of base material was characterized by SEM; XRD was used to do phase analysis. The degrees of crystallinity of pure PTFE under the different conditions of water cooling, air cooling and furnace-varying cooling were made comparison by XRD. The thermal stability of pure PTFE and solid lubricant was analyzed by DSC-TG; The composition and valence state of elements in the surface of carbon fiber ,solid lubricant before and after friction test and lubricant transfer film were characterized by XPS; The frictional property of solid lubricant was tested by pin and disk test rig .

用SEM表征原料微观结构、摩擦表面及润滑转移膜表面形貌：用XRD进行原料物相分析，及比较水冷却、空气冷却、随炉冷却三种工艺条件下的纯聚四氟乙烯树脂的结晶度；用DSC-TG分析纯聚四氟乙烯树脂及固体润滑剂的热稳定性；用XPS表征碳纤维表面、固体润滑剂摩擦前后表面、润滑转移膜表面的元素组成、价态变化；用销盘式摩擦磨损试验机对固体润滑剂进行摩擦性能测试；采用专用的台架模拟试验机对固体润滑剂镶嵌轴承套与钢轴摩擦副间的摩擦磨损性能进行测定；用莱次偏光显微镜测试固体润滑剂的硬度；用材料试验机测试固体润滑剂的抗压强度等。

Investigation on the effect of Sn/Pb - dopped Bi - 2212 superconductors has been canied out by the X - raydiffraction, together with simultaneous measurements of the spectra Of POsitron annihilation lifetime and positronDoppler broadening.

以X射线物相分析为主要实验手段，并结合正电子寿命谱和多普勒展宽谱和电阻测量，系统地研究了在不同的锡掺杂量下，Bi－2212超导相结构细节及电子态的变化。

The labia have now been sutured together almost completely.The drains and the Foley catheter come out at the top.

此刻阴唇已经几乎完全的缝在一起了，排除多余淤血体液的管子和Foley导管从顶端冒出来。

To get the business done, I suggest we split the difference in price.

为了做成这笔生意，我建议我们在价格上大家各让一半。