熔融

By means of distribution in figure of-La for the REE data, the original rocks of the garnet-pyroxene granulites would be derived from a mantle partial melting.

将REE数据投影到-La关系图中，投影点沿部分熔融斜线分布，提示原岩岩浆是地幔岩部分熔融产物。

The forming process for the high-strength, steel-base modified polyformaldehyde composite material in five-laver structure is to melt modified polyformaldehyde by heating and roll to make the melt polyformaldehyde permeate into the gaps gaps between the large-grained spherical copper powder and screw copper nails.

四层结构的钢基铜塑复合材料的成型过程，是将改性聚甲醛加热熔化，经轧制，使熔融的聚甲醛渗透到大颗粒球形铜粉的间隙中，解决了三层材料复合过程中，熔融的聚甲醛水平流动性强过垂直方向的渗透性，造成了结合强度低的缺陷，使聚甲醛层与铜粉及基体结合更牢固，提高了其承载和抗剪切的能力。

The forming process for the high-strength, steel-base modified polyformaldehyde composite material in five-layer structure is to melt modified polyformaldehyde by heating and roll to make the melt polyformaldehyde permeate into the gaps between the large-grained spherical copper powder and screw copper nails.

五层结构的高强度钢基改性聚甲醛复合材料的成型过程，是将改性聚甲醛加热熔化，经轧制，使熔融的聚甲醛渗透到大颗粒球形铜粉的间隙中，解决了三层材料复合过程中，熔融的聚甲醛水平流动性远强过垂直方向的渗透性，造成了结合强度低的缺陷，使聚甲醛层与铜粉、螺旋铜钉及基体结合更牢固，提高了其承载和抗剪切的能力。

The forming process for the high-strength, steel-base modified polyformaldehyde composite material in five-layer structure is to melt modified polyformaldehyde by heating and roll to make the melt polyformaldehyde permeate into the gaps between the large-grained spherical copper powder and screw copper nails.

五层结构的高强度钢基改性聚甲醛复合材料的成型过程，是将改性聚甲醛加热熔化，经轧制，使熔融的聚甲醛渗透到大颗粒球形铜粉与螺旋铜钉的间隙中，解决了三层材料复合过程中，熔融的聚甲醛水平流动性远强过垂直方向的渗透性，造成了结合强度低的缺陷，使聚甲醛层与铜粉、螺旋铜钉及基体结合更牢固，提高了其承载和抗剪切的能力。

The alkaline lavas were generated by lower degrees (0%) of partial melting and the tholeiitic lavas were generated by higher degrees (10%~30%) of partial melting.

碱性熔岩是产生于部分熔融程度较低(0%)的条件下，拉斑玄武质熔岩是产生于部分熔融程度较高(10%~30%)的条件下。

The picrites have low Re and high Os concentrations, which are probably controlled by the degree of partial melting and crystallization fractionation. The low Re ,Yb and Re/Os ratios of the picritic lavas support models of high degree partial melting with residual garnet in their mantle source during the early stages of partial melting, and without residual sulphide.

木里地区苦橄岩具有低的Re含量和高的Os含量，Re和Os的含量受到熔融程度和结晶分异的控制，低的Re和Os的含量和Re／Os，以及高的Os含量支持高程度的地幔熔融导致熔体中的硫不饱和，同时源区可能有石榴子石残留。

According to EPA regulations, bottom ash and fly ash produced from MSW incinerators should be properly treated before disposal. Reclamation of incinerated ash by plasma high temperature molten technology is available method to recycle the MSW ashes. Water-quenched slag from plasma vitrification of ash residues was used as eco-cement in this study.

都市垃圾焚化炉之灰渣电浆熔融资源化处理技术可为有效解决与资源化再利用焚化灰的方法，本研究针对灰渣电浆熔融处理产生之水淬熔岩拥有玻璃化的特性，探讨其成为生态环保水泥之可行性。

EDAX and talysurf. There were four wear regimes for KRF/GCI, during the starting friction period abrasion was dominant, when the process of the formation and break of transfer layers was balanced the main wear mechanisms were adhesion and fatigue, mild melt wear was found at higher temperature. For KRF/MMC, the dominant wear mechanisms were ploughing and microcuting during the running-in, when transfer layer formed, the film-film adhesion at the interface became dominant and mild melt wear occurred also at high temperature.

对于KRF/GCI，在摩擦的起始阶段主要是二体磨粒磨损，当表面转移膜的形成与破坏形成动态平衡时，粘着磨损和疲劳磨损是主要磨损机理，摩擦表面温度较高时，产生严重的粘着磨损和轻微的熔融磨损；而KRF/MMC在跑合过程中，SiCp对较软材料的犁削、微切削是主要摩擦磨损机理，转移膜形成后，表面的膜—膜粘着则为主要摩擦磨损机理，高温下也会发生轻微的熔融。

The thesis are divided into two parts. In the first part, we used 2,4,6-trichloro-1,3,5-triazine as the precursor to react with sodium which have been achieved by decomposing sodium hydrate at 623 K. At a low reaction temperature of 623 K, carbon nitride nanosphere、porous carbon nitride material and byproduct sodium chloride, would be produced.

本研究将分成两部份，第一部分是在低温下(623 K)将氢化钠粉末热裂解，生成表面积较大的熔融态金属钠，使气态的氰尿醯氯通入与熔融态金属钠在623 K反应，生成奈米氮化碳球、奈米孔洞性氮化碳材料及副产物氯化钠。

Compared with the bulk Ba8Ga12Zn2Ge32 material prepared by melting method combined with SPS (MM+SPS sample), the bulk Ba8Ga12Zn2Ge32 material obtained by melting method combined with MS and SPS (MM+MS+SPS sample) has higher carrier concentration and lower carrier mobility at room temperature.

与熔融+SPS工艺制备的试样相比，熔融+MS+SPS制备的Ba8Ga12Zn2Ge32笼合物室温载流子浓度增加而迁移率降低，在测试温度范围内，试样的电导率略有下降，Seebeck系数增加，热导率和晶格热导率显著降低，900K时其晶格热导率从1.06W/mK降低至0.42 W/mK。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。