熔度

Plastic should lower 3 steps, because plastic is a step to add melt resin material to cyclinder ,Higher stick of resin material ,higher screw back pressure. Screw speed differs depending

再复杂的熔胶旋转过程最多不会超过三段，因为熔胶本身就是存在于把胶熔进料筒的过程，如果原料粘度大，熔胶压力则大

The results of experiments indicated that the TLCP phase dispersed well in the PET matrix.

共混物熔体的表观粘度远低于纯PET的粘度，共混物熔体属切力变稀流体，其流动呈假塑性流动。

Positive correlation between Mg~# and P_2O_5 and negative correlation between P_2O_5 and FeO suggest that addition of P is not the key role for the separation of immiscible oxide melts. In contrast, negative correlation between Mg~# and Fe_2O_3/FeO ratios implies that the increasing of oxygen fugacity is very likely the main factor to induce immiscibility of oxide melt.

Mg#与P2O5的正相关以及P2O5与FeO含量的负相关，表明P不是导致氧化物熔体不混熔的主要原因；而Mg#与Fe2O3/FeO的负相关则说明，岩浆演化过程中氧逸度的升高可能是导致氧化物熔体不混熔的主要原因。

Coke properties has been studied by high temperature SiC oven、infrared gas analyzer and X-ray diffraction. First set forward the relationship between UPC and coke reactivity, strength, fine coke and coke graphitization, and creatively find the graphitization degree of coke tends to 100% when temp. reaches to 1350℃ UPC is profitableness to coke properties;②The effect of UPC on liquid slag distribution and flow functions in experiment oven has been studied by mathematics simulation The effect of UPC on taking shape and dropping of high titanium-bearing B. F. slag has been studied by using high temp. oven simulation cohesive zone and dropping zone of blast furnace.

为了弄清楚这部分UPC对高炉冶炼钒钛磁铁矿过程的影响，①在实验室利用高温SiC炉、红外线气体分析仪、X—射线衍射仪等进行了一系列UPC对焦炭性能及石墨化度的影响研究，提出了UPC与焦炭反应性、抗压强度、粉化性能及焦炭石墨化度之间的关系，创造性的发现高炉内1350℃以上，焦炭的石墨化度已达100％，UPC对焦炭性能的影响有益而无一害；②采用数学模拟方式研究了UPC对实验炉内液态渣分布及流函数的影响，并利用高温熔滴炉模拟高炉软熔带、滴落带研究UPC对高钛渣滴落性能的影响，采用旋转式粘度计测定滴落渣性能并通过高倍矿相显微镜观察了滴落渣的矿物结构。

The dynamics and heat transfer on the spinning line during the air drawing process are discussed in detail, mainly relating the forces acting upon the polymer along the spinning line and the expressions of the air drawing coefficient C〓 and heat transfer coefficient h. By introducing the power-law model as the constitutive equation to describe the theological properties of polymer melt and considering the changing of the density and specific heat capacity of polymer melt at constant pressure with the polymer temperature, the former model of polymer air drawing is improved and a complete polymer air drawing model is established, which is integrated with the model of air jet flow field of dual slot die.

在此基础上，对前人的聚合物拉伸理论模型进行了改进，以幂律模型作为描述聚合物熔体流变行为的本构方程，并考虑了聚合物熔体密度和定压比热随聚合物熔体温度变化而变化这个因素，从而建立了完整的熔喷聚合物拉伸理论模型。

An investigation to the microstructure of worn sample of dry vibratable materials for tundish working lining after using 40 hours shows that the materials changes the properties of slag by the chemical filter, increases the viscosity of slag, forms a dense layer at slag/refactories interface, then blocks the more slag penetrate in it. The complex phase formed at the interface, such as magnesiowusite and complex spinel et al, would absorb in more low-melting point minerals, then degrade its melting point and dissolve into slag, which forms low-melting point silicate phase, penetrates into dry vibratable materials along with Monticellite and Merwinite bonding phase by diffusion.

根据使用40小时后的中间包工作层残衬结构分析，其侵蚀机理为：干式料对渗入熔渣产生化学过滤作用，增大熔渣粘度，在干式料/熔渣界面形成致密结构，阻碍熔渣的进一步渗透；随着反应的进行复合矿物中熔剂含量的增多，熔点降低，溶于熔渣形成低熔点的硅酸盐相，并沿着干式料中的钙镁橄榄石和镁蔷薇辉石等结合相向干式料基质中扩散渗透。

It also relates to viscosity as the melt comes out of the die; hotter melt is less viscous, thinner, soupier melt.

熔体从口模出来时其熔体温度与黏度有关；较热的熔体是更稀的熔体。

The structure of an improved pin gate ,called twin-gate,was described,and the rheological behavior of polymer melt passing through the gate was studied.

介绍了一种改进的点浇口———孪浇口的结构，讨论了聚合物熔体流经该浇口时的流变性能，在浇口的长度、总截面积以及流量一致的条件下，与常用点浇口相比，孪浇口使熔体温度升高和使熔体粘度降低的程度要大，但压力降增加的幅度也大。

The electrochemical behavior on tetramethylquinone in n-butylpyridini-um chloride-aluminum chloride, a room temperature molten salt , is dependent on theacidity of this melt.

四甲基苯醌在氯化正丁基吡啶－AlCl＿3室温熔盐中的电化学行为，和室温熔盐的酸碱度有关，在碱性熔盐中，四甲基苯醌以不络合的形式存在，电极上的还原过程是一个ECE过程；在酸性熔盐中，形成络合物TQ（AlCl＿3）＿m，络合数m为1，2，3，随熔盐酸度变化，此外，醌类物质芳香环上的取代基，也影响其电化学性质。

Based on the Miedema model and Tanaka equation, a new method for calculating the parameters in the molecular interaction volume model has been developed to predict the activity coefficient s of multicomponent liquid alloys, in which not experimental data but only some physical properties of elements are required.

基于Miedema模型和Tanaka关系，提出了计算分子相互作用体积模型参数的新方法。该方法仅需知道元素的某些物理性质而无须熔体的实验数据，简化了计算多元合金熔体活度系数的步骤。分别计算了Ti-6Al-4V和Ti-5Al-2.5Sn在不同温度下组元活度系数的变化，计算了多种铜基合金以及Zn-Sn-Pb-Cd-Bi合金的活度或活度系数与组元配比的关系；并与Wilson模型进行了比较，计算值与实验值较好吻合

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。