焊的

Relationship between butt joint gap and cold crack rate of 16 Mn steel underwater wet welding is studied.

研究了水下湿法焊对接接头间隙与裂纹率的关系。随着接头间隙的增大，裂纹率逐渐减少。

Butt weld and flanged valves have the same end-to-end dimensions for Class 300 and up.

300磅级以上的对焊和法兰阀门具有相同的面到面尺寸。

The welding process of the butt welding machine used to weld bicycle joints employs a cam transmission mechanism. Its procedure is decided by the contour of the cam.

自行车接头对焊机焊接过程的进行采用凸轮机构控制，焊接过程由凸轮的外廓形状所决定。

And the welding connecting of them are advised to use slope butt weld that are fully welded, but when the double-sided fillet weld is used, they should be design on equal strength.

节点中的焊接宜采用完全焊透的坡口对接焊缝连接，当采用双面角焊缝连接时，可按等强设计。

In this article,the computer control system of the large scale flashing butt welding was introduced in the aspects of the makeup and its realization.

介绍了大型预热闪光焊机微机控制系统的组成及控制过程的实现。

Provide welding neck flange butt welding required for the purpose of the right pad with neighboring component.

提供焊接法兰的脖子上对接焊目的所需要的正确垫与邻近组成部分。

This research is directed against the control of Large-size flash butt welding machine s.

本研究针对大容量闪光对焊机的控制，通过采用STD总线工业化微机控制而实现了焊接的多参量预置、存贮、过程控制、显示等功能。

The flash butt welding parameters, such as stretch length, flash model and flash velocity were analyzed quantitatively.

根据模拟计算的结果，分析了闪光对焊过程参数选择的依据。

This paper,based on analyzing the process of Cu-Al pipe butt welding, discussed the design of the executive system and control system for PLC controlled Cu-Al pipe butt welder .

在分析了铜铝管焊接工艺过程的基础上，重点论述了铜铝管对焊机执行系统和控制系统的设计。

The space between the two ends butted together shall not exceed 0.25mm at any point in the joint.

用对焊而连接在一起的两管端之间的距离在任何情况下都不得大于0.25 毫米。

Lugalbanda was a god and shepherd king of Uruk where he was worshipped for over a thousand years.

Lugalbanda 是神和被崇拜了一千年多 Uruk古埃及喜克索王朝国王。

I am coming just now,' and went on perfuming himself with Hunut, then he came and sat.

我来只是现在，'歼灭战perfuming自己与胡努特，那麼，他来到和SAT 。