热离子

In the source, lithium ions are extracted from a heated emitter (β- Eucryptite), focused by a electrostatic lens, and neutralized in a charge -exchange cell by sodium atoms.

它是从锂霞石热发射体上引出离子，经静电透镜聚焦，在中和室与钠原子进行电荷交换，通过离子偏转最后获得中性束。

On the contrary, the anionswith greater deformability would promote a rise intemperature by induced dipole relaxation, In thepresence of microwave field, the conductivity of thedilute solution were higher than one in lack of theexternal field.

上述两种相反的作用可以通过离子的极化参数来定性衡量；此外稀溶液在微波场中的电导率均高于常规条件下的值，这是由于在微波场的作用下，离子氛的松驰力降低，从而使得溶液的电导增加，这可以看成是微波非热效果的具体现。3。

Two coordination polymers composed of in situ synthesized ligand deriving from isophthalic acid through the hydroxylation on the 2-position have been synthesized under hydrothermal conditions.

利用铜离子的氧化还原性质，以铜离子和间苯二甲酸在水热条件下反应使配体发生羟基化衍生成2，6-二羧基苯酚，并组装出2个含衍生配体的配位聚合物。

In complexes 8～16 synthesized by hydrothermal method, most of the ligands adopt multidentate coordination modes joining several lanthanide ions into high-dimensional coordination polymers. And changing of 5-substituting group on isophthalic acid has a little effect on the coordinated abilities of the meta-carboxyl groups.

水热法制备的配合物8～16中，配体多采取多齿配位模式桥连多个稀土离子，形成高维配位聚合物，同时由于羧基氧原子和稀土离子的强的键合力，间苯二甲酸的5位取代基的变化对间位羧基的配位能力的影响不大。

Then the relations of structures and properties of microporous membranes used in lithium-ion batteries were discussed.

介绍了锂离子电池隔膜用微孔膜的制备原理与结构，重点叙述了熔融拉伸法和热致相分离法制备微孔膜的基本原理和膜结构影响因素，并在此基础上讨论了锂离子电池隔膜用微孔膜结构与性能之间的关系。

Pillared clay is a kind of the mineral materials, which is synthesized by pillaring inorganic polycations or organic ionic groups into clay minerals. Modified clay is a two-dimensional mineral material with large surface area, high thermal stability, strong surface acidity and variable pore size, therefore it is widely used in such fields as catalyst, sewerage treatment, antibacterial material, photic functional material, ionic conductor, pharmacy, nano-complex preparation and nuclear scrap treatment.

柱撑粘土是矿物材料的一种，它是一种由聚合无机阳离子或有机离子插入粘土矿物中而形成的一种具有二维孔洞的矿物材料，具有比表面积大、热稳定性好、表面酸性强以及孔径可变等特性，因此在催化、污水处理、抗菌材料、光功能材料、离子导体、制药、纳米级复合材料制备、核废料处置等领域有着广阔的应用前景。

And the PLA/Chitosan/ACP barriers with additional 2 wt% chitosan still maintain 56.58 % antibacterial ability after eightieth day. The different composition of PLA/Chitosan/ACP composites was prepared by water washing solidification from NMP/water/lactic acid consolvent. After storing at room temperature for 48 hours and taking it out to obtain a shapable composites. To investigate the influence of ratio of composition with the shapable property of composites, it was analyzed by Rheometer, TGA, AFM, XRD. The result of the different APC content had different effect both water content and yield stress of composite materials. The yield stress decreased with ACP content while increases. It was derived that ions, released from ACP interact with amide groups of chitosan to form water-absorbing ionic clusters through chelating or electrostatic attraction.

另外，以聚乳酸/几丁聚醣作为基材并添加不同比例的非晶型磷酸钙，经过水洗固化后可得白色片状沉淀物，於室温下静置48小时后，复合材之体积呈现膨胀且具有可塑形之特性，以热重分析仪与流变仪分析样品之含水率与屈伏应力，结果显示不同ACP含量对复合材含水率与屈伏应力具有消长变化，而PLA/Chitosan/ACP之可塑程度与其所吸收之水份多寡有关，推测可能机制为ACP磷酸钙盐解离后之金属离子与几丁聚醣之胺基透过螯合作用或静电吸引之交互作用，形成具吸水性之离子团簇分散於疏水性之聚乳酸基材中。

Meanwhile the defects are also studied by means of the methods of EPR, PSL, thermostimulated luminescence and absorption spectroscopy. These results indicate that the principal defects are F centers and O〓 in PSL. O〓 centers are formed by O〓 ions substituting for F ions with a trapped hole The trap depth of two kinds of F centers is obtained by using thermoluminescent spectra.

同时还利用电子顺磁共振谱，光激励发光，热释发光和吸收光谱的方法，研究了其材料中缺陷的性质，实验结果表明在光激励发光过程中主要的缺陷是F心和O〓心，其中，O〓心是O〓离子替代F〓离子并束缚一个空穴而形成的局域中心。

A review of our research work is given in this paper. It is about strengthening mechanism; surface trobology; resistance in wear, oxidation and corrosion; thermal atom chemistry in steel during ion implantation; silicides synthesis.

综合评述了本课题组在金属离子注入钢强化机理、表面摩擦学、抗磨损特性、离子注入表面热化学效应、硅化物合成、表面抗氧化和抗腐蚀研究中所取得的新的实验结果。

The structure of the thin film capacitor 1 of this invention is: form sequentially at least the bottom electrode layer 102, the high dielectrics constant oxide film 103 and the upper electrode layer 105 on the semiconductor substrate 101; said upper electrode layer 105 which is a film layer 104 formed by the electrical conductive material which is processable by reactive ion etching, or a multilayered film composed of two kinds of film layers 107 and 108, which are each formed of a conductive material which is processable by at least two kinds of reactive ion etching.

要约 薄膜电容器1是至少在半导体基片101上按顺序形成下部电极层102、高介电常数氧化物膜层103、上部电极层105而构成的薄膜电容器，该上部电极层105由一种仅由可用反应性离子刻蚀加工的导电性材料形成的膜层104，或至少两种由可用反应性离子刻蚀加工的导电性材料分别形成层状的多层膜层107和108构成；经历350℃的热试验之后，对该薄膜电容器1施加OV到2V的驱动电压的薄膜电容器漏电电流密度为1×10 －8 A/cm 2 以下。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。