热的产生

It uses two normal-pressure fluidized beds and makes the material circulate between the two beds, the fluidized bed boiler produces steam and the fluidized bed coal cracking furnace is used for pyrolyzing coal powder to produce meidum caloricity coal gas; the heat quantity needed for coal pyrolysis is provided by hot ash acted as heat carrier.

流化床煤气－蒸汽联产工艺及装置，它采用两个常压流化床，使物料在两床之间循环，流化床锅炉产生蒸汽，流化床煤裂解炉用来热解粉煤，产生中热值煤气；热灰作为热载体提供煤热解所需的热量。

Smartness in a material is generally determined by one of two primary mechanisms.

在吸收周围环境的外部刺激所产生的能量的过程中，材料会发生化学的、机械的、电的、磁性的或热的特性当中的某一方面的变化。

The practices produce the actual physical sensation of heat, called tapas, or the inner fire of purification.

的做法产生了实际的物理热的感觉，所谓的餐前小吃，或净化心灵之火。

Hello, hair removal is recommended that you go to a regular hospital for plastic shed, for hair removal methods currently being used for hair removal using photons, the photons unhairing this unique light and heat treatment technology, full use of the combined effect of light and heat, through the launch special spectrum of pulsed light, penetrate the skin to reach the depth of different organizations, was the corresponding depth of the hair follicle, hair dry, and melanoma cells, such as target tissue absorption of heat generated by the formation of an instant local high temperature, dry and damage hair follicles, and obstructed and the termination of hair growth, to achieve permanent hair removal results.

您好，脱毛建议您去正规的整形医院进行脱毛，对于脱毛目前采用的方法是采用光子进行脱毛的，光子脱毛这种独特的光热治疗技术，充分利用了光和热的综合效应，通过发射特殊谱段的脉冲光，穿透皮肤到达不同的组织深度，被相应深度的毛囊、毛干、黑色素细胞等靶组织吸收，产生的热量形成瞬间局部高温，破坏毛干及毛囊，阻碍和终止毛发的生长，达到永久性脱毛的效果。

Through experimental study of typical crown fire using pine tree, we first measuredits heat release rate and the inter-space thermal radiation variation of crown fire ofsingle pine tree and compared the experimental data with the model prediction,validating the rationality of the thermal radiation model of single tree.

通过对典型树冠火热辐射的实验研究，以雪松为实验树，测量了实验树的热释放速率、由单颗雪松产生的树冠火的空间热辐射随时间的变化，并将测量值与利用单树热辐射模型计算出的理论值进行了对比分析，验证了单树热辐射模型的合理性；然后测量了由多个雪松同时燃烧产生的空间热辐射随时间的变化，并将测量值与利用多树热辐射模型计算出的理论值进行了对比分析，验证了多树热辐射模型的合理性。

Because of the off-phase motor running to recognize the harm caused by different fault in the implementation phase of the motor protection have had two different views: that the broken phase to the electrical damage caused by overheating point of view to the implementation of the motor overheating protection or inverse-time characteristics of overcurrent protection, thermal relays the resulting program, thermal resistance package with over-current fault protection program delay, and other programs; that the break caused by phase to the motor windings high-voltage breakdown back-EMF's view of Open-phase protection program to take instantaneous action, and some electronic-type protectors available.

由于对断相运行给电机造成的危害认识不同，因此在对电机实行断相保护时产生了两种不同的意见：认为断相给电机造成过热损坏的观点要对电机实行过热保护或过流反时限特性保护，由此产生了热继电器方案、热敏电阻方案、断相过流延时保护方案以及其他一些方案；认为断相给电机绕组造成高压反电势击穿的观点，对断相采取瞬时动作保护方案，于是一些电子式保护器问世。

It 's mainly used in steel tubes of high 's mainly used in steel tubes of high temperature superheaters with surface temperature temperature superheaters with surface temperature ≤625℃ and high ≤625℃ and high temperature reheaters with surface temperature temperature reheaters with surface temperature ≤650℃, and high ≤650℃, and high temperature headers and steam pipes with surface temperature temperature headers and steam pipes with surface temperature ≤600℃.

主要主要用于壁温≤625℃的高温过热器、壁温≤650℃的高温再热器钢管，以及壁温≤600℃的高温集箱温≤625℃的高温过热器、壁温≤650℃的高温再热器钢管，以及壁温≤600℃的高温集箱和蒸汽管道，国内外已逐步用该钢代替和蒸汽管道，国内外已逐步用该钢代替T22、F12、TP304L、TP347H等，但该钢焊接性能T22、F12、TP304L、TP347H等，但该钢焊接性能也比较差，容易产生焊接冷裂纹，所以同样要求有合适的预热温度和及时进行焊后回火处也比较差，容易产生焊接冷裂纹，所以同样要求有合适的预热温度和及时进行焊后回火处理。

The WEDM process makes use of electrical energy generating a channel of plasma between the cathode and anode [5], and turns it into thermal energy [6] at a temperature in the range of 8000–12,000 vC [7] or as high as 20,000 vC [8] initialising a substantial amount of heating and melting of material on the surface of each pole.

WEDM 程序利用电的能源产生一个血浆的频道在阴极和阳极之间 [5]，而且将它变成热的能源 [6] 在 8000 – 12，000 vC 的范围温度 [7] 或高达 20，000 vC[8] initialising 实质上量的暖气和熔化的在每个杆的表面上的材料。

Tall annual marsh elder common in moist rich soil is central North America that can cause contact dermatitis; produces much pollen that is a major cause of hay fever .

一种一年生的、高大的沼生接骨木，它常见于北美中部的潮湿沃土上，造成接触性皮炎；产生许多花粉，是引起花粉热的主要原因。

A homogeneous dielectric structures due to internal heating is different from the thermal deformation can not be freedom it will produce heat stress; a heated uniformly inhomogeneous media due to the different coefficient of thermal expansion will produce thermal stress; and thermal structure is more subject to external constraints is to generate thermal stress causes.

一个均匀介质结构由于内部受热不同，其热变形不能自由进行时，将会产生热应力；一个受热均匀的非均匀介质结构，由于热膨胀系数不同，也会产生热应力；而热结构受到外部约束更是产生热应力的原因。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。