热的产生

Highly ordered mesoporous Zr-Ce-SBA-15 silica with hexagonal-platelet morphology was synthesized through a hydrothermal route by using pluronic P123 as a template, tetraethyl orthosilicate as a silica source, zirconyl chloride and cerous nitrate as a precursor. The main strategy of this method was to utilize the acidity self-generated from the hydrolysis of inorganic salts in the aqueous solutions, where no addition of mineral acids was necessary.

以P123为模板剂，正硅酸乙酯为硅源，氯化氧锆和硝酸亚铈为无机前驱盐，在不外加无机酸的条件下，利用无机前驱盐自身水解产生的弱酸性环境，通过水热合成路线一步合成了具有大的径轴比、短孔道、六方板状形貌的Zr-Ce-SBA-15介孔材料。

Research shows : laser treatment, the hardening layer from the melting zone, transformation hardening and the heat-affected zone, organizations to small uniform martensite, have a high density of dislocations, which are high hardness and wear resistance of the main reasons.

研究表明：激光处理后的硬化层由熔凝区、相变硬化区和热影响区，组织为细小均匀的马氏体，产生了高的位错密度，这些是硬度和耐磨性高的主要原因。

The results show that the TiO2 porous films can be obtained by anode oxidation using 10% H2SO4, voltage of 120V on the surface of Ti-6Al-4V alloy, and the aperture size is about 100-200nm. The acerate CaHPO4 with size of 200-400nm can be gained by the electrochemical deposition. Ultimately, the acerate CaHPO4 changed to the sheet Ca10(PO4)62 after being treated with 0.1mol/L NaOH in autoclave at 200℃ for 10 hours .

结果表明：钛合金（Ti-6Al-4V）板经以10％的硫酸为电解液和电压为120V时阳极氧化，产生孔径大约为100-200nm的多孔氧化膜，再经电化学沉积，得到尺寸大小约200-400nm针状的CaHP04，最后经盛有浓度为0.1mol/LNaOH 水溶液、温度为200℃的高压釜中水热合成10h，针状的CaHP04 转变为片状的Ca10(PO4)62。

The temperature of cold injury was abo ut 0 ℃ to 15℃,While hot injury would appear when temperature got to 36℃.These ind icat ors were varied in different species,and the greatest difference was the temper ature of cold injury.Growth would be poor in summer under full illumination,whi le part shading was beneficial.The best condition was 70 percentage of sh ading for Araceae and 50 percentage of shading for Agavaceae.The need for soil moistu re was strict.Most of species would grow normally in 65 to 85 percentage of soil m o isture.The characters responsed to illumination,temperature and soil moisture w e re consistent with their original ecologic environment.

其最 适生长温度在16-35℃，除酒瓶兰外，低于10℃时均表现生长停滞状态；寒害温度差异很大，天南星科为0-15℃，龙舌兰科为0-10℃，大多数植物在36℃会产生热害；光照对其影响较大，夏季这两科植物在全光照下长势差而在一定荫蔽的条件下有利生长，最佳荫蔽度天南星科为75％，龙舌兰科为50％；这两科植物对土壤中的水分含量要求较高，大多在土壤含水量70％以上才能正常生长，这些光、温、湿的反应特性与其起源地湿热和荫蔽的生态环境相吻合。

According to Wurtz reaction, if we can control solvothermal reactive condition to make the four C-Cl bonds in the carbon tetrachloride broken incompletely, according to the mechanism of Wurtz reaction, some kinds of free radicals or carbonium ions will be produced in solvothermal condition.

那么，如果控制反应条件，使四氯化碳等小分子碳氯化合物中的氯原子不完全脱掉，根据Wurtz反应机理，反应体系中将产生大量的碳氯自由基或碳正离子，它们在溶剂热条件下按照一定的生长规律进行组合，必将生成大量的多氯代多环芳香化合物。

The principle is as follows: after incubating the standard sample of bacterial endotoxins, glycogen anti coagulation whole blood extracting from the healthy domestic rabbit, extralin anti congealable whole blood from healthy volunteers, THP 1 cells together, measure the releasing amount of TNF and IL 6 from cell gene by the method of ELISA as a endogenesis index judging the pro heat role of endotoxin.

其原理是：分别将细菌内毒素标准品与从健康家兔取出的肝素抗凝全血、健康自愿者提供的人肝素抗凝全血以及THP 1细胞共同孵育后，用ELISA双抗夹心法测定其产生的细胞因子TNF α和IL 6的释放量，作为内源性检测指标来判定内毒素的致热作用。

Molybdenum disilicide has gained industrial importance due to its high melting point, high emissivity, stable resistance over long periods of time and the ability to form a self-healing protective layer, which possesses an interesting combination of thermophysical and mechanical properties and has potential for structural use and heating in oxidizing environments at high temperature.

MoSi〓具有高熔点、高发射率电阻老化特性好等特点，并通过产生保护膜而具有较好的高温稳定性，因此该材料在工业领域受到重视。其实现了材料的热物理特性和机械特性的有机结合，并使材料在高温氧化环境下作为结构材料和电热材料的使用提供了可能。

Among whole technique exploitation process, this paper will emphasize in UV-LIGA process discussion , thick film photoresist SU-8 reflows generable fluid situation for dot shape influence and fixed Ni stamper manner whether it suits below thickness 0.5mm insert influence of electroforming Ni stamper.

在整个技术开发过程中，本文将著重在UV-LIGA制程上的探讨、厚膜光阻SU-8热回流时，所产生的流动情形对Dot形状的影响以及固定镍模仁之方式是否适用於厚度0.5mm以下电铸镍模仁的嵌入情形。

Due to the cathode oxidizability and electrolyte instability, some primary reactions, such as electrolyte decomposition, cathode materials dissolution and self-heating redox reaction, arised at the cathode/electrolytes interface in Li-ion batteries, which deteriorated the electrochemical properties and safety of the batteries.

锂离子电池中的正极/电解液界面反应：电解液的氧化分解、正极材料腐蚀溶解及正极材料的自热氧化还原反应等，均能对电池的电化学性能和安全特性产生不良影响。

For example, such heat transfer could create hotter or coolerblobs of material from the inner and outer boundaries of the fluid core, thereby perturbing the main heat-circulation pattern.

这样的加热转换器的能够产生更热或更冷的B，这个B是一种材料的，这个材料来自于内部和外部的边界，这个边界是FC的，因此就怎么着

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。