热损失

For the first six or seven races I was happy with the brakes, but the rear callipers were so hot I was losing time, plus I couldn't run the aerodynamic devices on the car because it was a hot rear end.

开头6、7站我对刹车很满意，但后轮毂罩太热了使我损失时间，另外我还用不了车上的空气动力装置，因为赛车后部太热了。

Built Material : furnace side wall using light-weight high aluminum bricks, and pyroceram-fibre cotton which provide better heat insulation, good diathermancy and longer life-span.

砌筑材料：炉壁采用轻型高铝质断热砖及陶瓷纤维棉板隔热效果好，热传递损失小，使用寿命长。

To examinate the thermal properties by TGA、DSC and figure out the maximum decompose temperature which survey the range of liquid crystal temperature. We synthesize conjugated polymer successfully and these emitted blue fluorescence. Hope this experiments will supply well-contribution in field of organic light-emitting diodes.

以TGA、DSC测定其热性质，并了解到由TGA的5%热重损失温度再进行测出液晶温度范围，我们成功的合成出具有良好的加工性的共轭性分子，发光性质都出现在蓝光领域，愿在有机发光二极体的领域上有重大的贡献。

The thermal properties, mechanical properties of PI-MWNTs nanocomposite were analyzed by Thermogravimetric analysis, Universal Test Machine and Hardness Pencil Test. The morphology of PI-MWNTs was observed by scanning electron microscopy. The dispersion of MWNTs in matrix were observed by transmission electron microscopy. The electrical property of composite were obtained by Super Megohmmeter.

研究中使用傅立叶转换红外光谱仪来鉴定其化学结构，热重损失分析仪探讨材料的热稳定性质，万能试验机及铅笔硬度计观察其机械性质，扫描式电子显微镜与穿透式电子显微镜来观察材料的表面型态及奈米碳管於基材中的分散性，超绝缘仪量测材料的电性。

The thermal properties and mechanical properties were analyzed by Thermogravimetric analysis and Hardness Pencil Test and Universal Test Machine, respectively. The structure of prepared PI-MWNTs was characterized by Fourier transform infrared spectrometry. The morphology of PI-MWNTs were observed by scanning electron microscopy and transmission electron microscopy. The electrical conductivity was analyzed by Super Megohmmeter.

本研究中使用能量分散光谱仪来鉴定多壁奈米碳管纯化效果，热重损失分析仪、铅笔硬度计、万能试验机分别测定材料的热稳定性质和机械性质，傅立叶转换红外光谱仪来鉴定其化学结构，扫描式电子显微镜与穿透式电子显微镜来观察材料的剖面型态与奈米碳管和基材之间的分散性，超绝缘量测仪量测材料的电性。

Modified/Improved Rift heat flow modeling to account for radiogenic heat component loss during rifting. The traditional models over-predict heat flow and maturity in such basins.

改进的裂谷盆地热模式，可考虑裂谷过程中岩石圈厚度减薄引起的放射性生热的的损失，传统的模式中预测的热流和有机成熟度过高。

The heat transfer and pressure drop of the entire flow channel of primary surface recuperator were studied using 3-D numerical simulation .

对波纹状微型燃机一次表面回热器全程通道的换热特性和压力损失进行了三维数值模拟分析，并与采用经验公式的计算结果进行了比较。

The direct and indirect property loss of pool fire is analyzed.

结合热辐射伤害的破坏准则，对死亡、重伤、轻伤的范围进行了量化研究，进一步分析了池火灾所造成的直接财产损失和间接的财产损失，并给出了相应的计算模型。

The wetness measurement equipment is designed and manufactured. In this equipment, the wet steam sample is heated from wet steam state to superheated state, The wall temperature of both tubes becomes equal by regulating their heating power respectively. Therefore, no any of heat loss, including no thermal radiation heat loss, exists.

设计研制了一套具有实用价值的加热法湿度测量装置，实现了既对所抽取的流动湿蒸汽试样进行加热和通过调节加热段部分的内管与外管各自的加热功率使两者温度相等，消除了内管与外管之间的各种散热损失，尤其是避免了以往的加热法测量装置中无法避免的高温元件向外的热辐射损失，从而提高了湿度测量的精确度。

Firstly, according to the relationship between classic Carnot cycle and Lorenz cycle, the paper evaluates the cycle characteristics and thermodynamic properties of NARMS (Non-azeotropic mixtures), and compares the energy-saving difference between pure and mixed refrigerants. The main of factors that affect heat pump operating efficiency are analyzed in theory and using the Second Law of Thermodynamics the exergy are evaluated in components of heat pump system, in the end a conclusion is drew that all of the exergy have bearing on working fluids' properties.

本文首先从经典的Carnot逆循环与Lorenz逆循环相对关系出发，评估了非共沸混合工质循环的特点以及热力学性质；在不同环境条件下，比较了单工质与混合工质的循环特性差异；针对非共沸混合工质热泵循环效率的主要影响因素（即工质本身的热物性和系统部件特性）进行了理论分析，并利用热力学第二定律对热泵系统的各个主要部件进行了可用能分析，最终发现每一处可用能损失均与工质物性有关；在此基础上提出了减少可用能损失的方法—寻找适宜的非共沸混合工质。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。