热损失

The following points are emphasized:The operation models of adiabatic and diabatic distillation have been set up and the operation block, thermodynamics model and mathematical model in the simulation have been determined as well;(2)Based on the simulation and exergy analysis with Aspen Plus program, shortcut distillation design—DSTWU model and rigorous distillation design—RADFRAC model, the author has determined the heat duty, exergy losses and the distribution of exergy losses along the adiabatic column, which will help the simulation and optimization of the diabatic distillation;(3)Diabatic distillation under various operation conditions has been simulated by using energy balance method and exergy analysis;(4)How the different mixture and the various degree of separation, number of trays and feed location influence exergy saving in diabatic distillation have also been discussed;(5)On the basis of the total exergy losses along the column, different schema of the heat transfer distribution along the column have been compared and analyzed;they can be classified in three categories: heat duty equipartition approach, empirical approach, separation degree matching approach. In conclusion, different heat transfer distribution along the column will have effect on total exergy losses. In particular, most satisfactory results have been obtained by using separation degree matching approach. In order to diminish the exergy losses, heat transfer distribution should meet the needs of the request of separation degree.And on this premise, the author makes his suggestion in increasing the proportion of heat supplied to the tray with minimum exergy losses and decreasing the proportion of heat supplied to the tray with the maximum exergy losses.

本文对透热精馏过程进行了模拟并对其节能效果的影响因素做了较为全面的分析和深入的研究，主要研究内容如下：(1)建立了常规精馏和透热精馏过程的模拟操作模块、热力学模型以及数学模型；(2)利用化工模拟软件Aspen Plus并分别采用DSTWU简捷模型和RADFRAC严格计算模型对常规精馏进行模拟计算和有效能分析，确定常规精馏塔的公用工程热负荷、有效能损失及有效能损失在塔内的分布，为透热精馏的模拟和优化提供数据参考；(3)对不同物系在不同分离度条件下进行透热精馏的模拟，分别采用能量衡算法和有效能分析法进行计算和分析；(4)探讨了各种因素如物系的选择、不同分离度、塔板数、进料位置对透热精馏节能效果的影响；(5)以全塔总有效能损失为比较基准，对热量在塔内的三种分布方案即热负荷平均分配法、经验法和分离度匹配法进行了对比分析并得出结论：塔内热量的不同分布方案对于全塔总有效能损失会产生影响，其中以分离度匹配法的节能效果最为理想，为减少有效能的损失，应使塔内的热量分布满足各塔板的分离度要求，并在此前提下，尽量减小有效能损失大的塔板的热负荷和增加有效能损失小的塔板的热负荷。

Numerical Simulation and Experimental Investigation on A Thermoacoustic Engine with Tapered Resonance Tube A symmetrical standing-wave thermoacoustic engine with tapered resonance tube has been numerically simulated with liner thermoacoustics. The simulation shows that using tapered resonance tube in thermoacoustic engine could decrease the velocity amplitude and lower the total acoustic power loss in the resonance tube. The experimental results indicate that the harmonic was suppressed effectively by using the tapered resonance tube, and the pressure ratio was improved.

采用锥形谐振管的热声发动机的数值模拟和实验研究利用线性热声理论，对一台采用锥形谐振管的驻波型热声发动机进行了数值模拟，发现采用锥形谐振管可有效降低工质气体的速度振幅，进而减小在谐振管中声功率的损失；与一台在相同频率下工作的采用等直径圆柱谐振管的驻波型热声发动机进行了实验对比，结果表明，在使用锥形管作为谐振管的热声发动机系统中，谐振管中的非线性效应得到了明显的抑制，热声发动机在基频模式下稳定运行，压比增大而加热温度降低。

In this paper, thermal images of components are obtained directly using the infrared thermograph device, and the multi-scale wavelet analysis technique is taken to filter them, and then entropies of them are calculated.

在液压系统中，液压元件的故障大都伴随着能量损失，如堵塞和泄漏伴随着流体介质压力能的损失，异常磨损伴随着运动部件机械能的损失，而这些损失的能量大都以热形式释放出来。

By comparison between SMM HXRBS observation and ground observation of Hα and CaIIK lines, especially through the combined study between SMM HXRBS observation and chromospheric flare models, the results show that: in the initial stage of impulsive phase, there is a correlative relation betweem Hα line intensity and hard X-ray emission; different spike in hard X-ray flux curve represents the burst at different location; the energy taken by non-thermal electron beam is larger than the radiative loss in chromosphere; for the flare studied here, the chromospheric evapporation is explosive; if the chromosphere is in balance between electron beam bombardment and radiative loss, the column mass density at the top of chromospheric flare model can not be taken as measure from the source of electrons and then the total material between the source of electrons and the top of chromosphere can be estimated.

通过一个具体耀斑的SMM HXRBS观测结果与同时基于地面得到的Hα和CaⅡK可见光谱观测结果对比，特别是将硬x谱观测结果与色球半经验模型联立研究，结果显示出：在脉冲相上升段，硬x发射与Hα辐射之间存在对应关系；硬x线光变曲线中不同脉冲爆发分量不太可能起源于同一位置；硬x辐射所反映的高能非热电子总携带能量大于色球总辐射损失；对所研究的耀斑而言，其色球蒸发过程是爆发性的；在详细比较了非热电子色球总沉积和色球辐射损失的基础上，指出半经验模型中色球顶部柱数密度不能看成是从非热电子源度量的，从而估计了色球顶部到非热电子源之间的总物质。

The hydrolytic degradation research results showed that the PDLLA molecular weight was first degraded, then the weight loss happened in normal saline, and the water soluble crystallizable oligomers were formed during the process of degradation. The thermal degradation research results showed that the thermal degradation of PDLLA is a random breaking process, the molecular weight was degraded at range of 100癈~250癈, only above 250癈, the weight loss was found.

通过研究PDLLA的生理盐水降解性能和热降解性能，发现PDLLA在生理盐水中首先发生分子量降解，然后产生重量损失，且降解过程中生成具有晶体结构特征降解产物；PDLLA的热降解是一个无规的断裂过程，在100℃～250℃范围内，PDLLA的分子量迅速发生降解，在250℃以上，低聚物相继发生裂解，产生重量损失。

The tripolar structure SST anomalies over the North Atlantic, which also appears at the interannual scale with a spectral peak at 3—4 years, are mainly resulted from the barotropic driving of the NAO like atmospheric forcing, and thermal process plays a dominantrole in this process. When the NAO is strong, the westerly weakens over the midlat itudes; both the sensible and the latent heat flux release from the ocean tend to decrease, which warms the ocean and leads to positive SST anomalies. Over the sub polar region including the Labrador Sea, a stronger NAO is associated with a deeper Icelandic Low; the high latitudes originated colder air then blows over the ocean surface, the air-sea temperature difference become larger, and the se n sible heat flux loss from the ocean increases, which subsequently leads to colder SST anomalies.

分析表明，模式中三核型SST异常的产生，主要来自大气的强迫，NAO增强，中纬度大洋上的西风减弱，海洋感热和潜热通量损失减少，中纬度大洋得到的净热通量增加，导致SST出现正距平；在包括Labrador 海在内的副极地大洋，NAO增强、冰岛低压加深，气旋性环流增强，来自高纬度的冷空气吹过洋面，海气温差加大，大洋的感热通量损失增加，SST降低。

Based on a computing model of floor heating residences, indoor thermal environment and heat distribution under the effect of heat charge/discharge, operation control and solar radiation has been concluded. Concept and formula of equivalent heat supply has been put forward which indicate that actual heat supply will be equal to the sum of design heat supply and equivalent heat supply. Recommend coefficient has been given taken Dalian as an example. Computed according to the new method, design heat supply can be reduced to 37% in cloudy day and 43.3% in sunny day, energy saving effect is very obvious. In Tromb wall solar house, effect of concrete wall on indoor temperature swing and attenuation of temperature wave is very obvious. While the outdoor air-temperature swing exceeds 10℃, indoor air-temperature swing belows 3℃. In the experiment, maximal difference in temperature between inner surface and outer surface of the 300mm wall exceeded 10℃. Heat storage and collector efficiency varies adversely according to solar radiation. Factors such as thickness, material, absorptance of the wall and permeation of the glass cover all have big influence on heat storage and collector efficiency. There exsisted an optimal thickness of the wall, which can make the best of heat storage and collector efficiency. Most of the heat stored in conventional Trombe wall during the daytime has been lost to the outside at night without heat preservation. Heat preservation on the outside surface of the wall has effectively improved heat release performance of the wall at night, heat supply to the room has increased too.

通过建立的地板采暖系统动态热性能分析模型，得出了在蓄放热特性、运行方式和太阳辐射等因素耦合作用下的室内热环境及热量分配比例，提出了等效供热量的概念及计算公式，指出实际所需供热量应等于设计供热量加上等效供热量，并以大连为例，给出了等效供热量的修正系数，以新方法计算，阴天可减少设计供热量37％，晴天最大可以减少设计供热量43.3％，节能效果显著；集热蓄热墙式太阳房中，混凝土蓄热墙的室温均一化效果和对温度波的削减作用非常明显，当室外温度波动最大幅度超过10℃时，室温波幅不超过3℃，实验中300mm厚墙体内外表面温差超过10℃；墙体蓄热效率与集热效率随太阳辐射照度的变化呈相反的变化趋势；墙体厚度、材料、表面吸收率以及盖板透过率等因素对集热和蓄热效率均有较大的影响，存在一个最佳的墙体厚度值，使得墙体集热和蓄热综合性能最优；传统的蓄热墙夜间没有外保温，辐射散热损失很大，研究表明墙体外保温方式明显改善了蓄热墙夜间的散热性能，增加了向室内的供热量。

The internal structure has been optimized to reduce the heat loss and increase the specific impulse.

本文通过优化发动机其内部结构，减小了热损失，提高了比冲。

Combustion efficiency and heat losses through the chamber wall both tend to produce a lower chamber pressure than predicted by theory.

燃烧效率和热损失，通过会议厅墙上都倾向于产生下议院的压力比预料的理论。

The two technologies being used can improve the lifetime of a B.F.,decrease the loss of heat a...

采用此二项技术可使高炉长寿、热损失减少故亦有利节能。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。