热损失

Inactivation of hot die steel can do a lot of damage to commercial run.

热作模具的失效给工业生产造成了巨大损失。

The heating of the core may damage the interlamination insulation, increasing iron loss if the burn- out temperature is too high.

核心的热化也许损坏隔层敷施性的绝缘材料，增长的铁损失，如果烧坏温度太高。

Parasitical thermal radiation loss is the main factor which greatly influences the thermal-to-electric converting efficiency of AMTEC.

引 言寄生热辐射损失是影响碱金属热电直接发电装置热电转换效率的主要因素之一。

Meanwhile we also discussed the pleateau structure in transition region and strong heating in deep photosphere from theoretical view.

从理论角度上看，过渡区平台结构不可能在非热电子加热和辐射损失作用下存在；在现行的耀斑起源于日冕的图象下，光球深层受到强加热也是难以解释的。

The results show that after modification of pore characteristic desulfurization performance sorbent are improved much more.

结果表明，温度越高、时间越长，热解反应越快，但是烧结的影响也越大，比表面积的损失越大。

The changes of morphology and mass in the process of pretreatment,the morphology and the phase constitution of chemical conversion film formed by stannate were studied using scanning electron microscope,X-ray diffraction and the mass loss method.

利用扫描电镜、X射线衍射和质量损失等手段，研究预处理前后的表面形貌及质量变化和锡酸盐化学转化膜层表面形貌及其相组成，采用盐雾和湿热实验箱检验膜层的抗腐蚀性能。

The changes of morphology and mass in the process of pretreatment, the morphology and the phase constitution of chemical conversion film formed by stannate were studied using scanning electron microscope, X-ray diffraction and the mass loss method. The corrosion resistance of film were studied by salt spay test and damp test.

利用扫描电镜、X射线衍射和质量损失等手段，研究预处理前后的表面形貌及质量变化和锡酸盐化学转化膜层表面形貌及其相组成，采用盐雾和湿热实验箱检验膜层的抗腐蚀性能。

Ephedrine in combination with caffeine has been shown to promote thermogenesis, fat loss, and muscle gain in several controlled trials.

麻黄碱结合咖啡因已经证明，以促进产热，脂肪损失，而且由于肌肉增益在几个对照试验。

Thermophile xylanase activity was not reduced seriously within 100℃in the lab and had higher activity between 40℃and 60℃.

结果表明：嗜热毛壳菌木聚糖酶在40～60℃表现较高的水平，实验室条件下100℃以内的加热不会导致酶活性的严重损失。

For common decoration material s,such as window s curtain,three-ply,five-ply and wood block,their combustion characteristics,including heat release rate, mass loss rate,and igniting time,are effected by their shape and dimension,as well as heating source intensity.

对实际火灾过程中可燃性装饰材料(窗帘布、三合板、五合板和木板块)燃烧时的热释放速率、质量损失速率和着火时间与材料的几何尺度、外界加热辐射热流强度之间的关系进行了研究。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。