热性的

When the used level of aluminum hydroxide in the resin was 20%-30%,the scale of burning of the resin solution w.

分析了氢氧化铝的热分解温度和对氮-磷环氧树脂阻燃性的影响，讨论了氢氧化铝的用量对树脂胶液的燃烧等级、覆铜板抑烟效果的影响。

Explanation was given on improvement effect of heating rate to caking property from essence of chemical reaction using pyrolysis kinetics.

并用热解动力学从化学反应的本质解释了升温速率对煤的粘结性的改善作用。

Scanning Electronic Microscope Photographs showed that nano-particles conglomerated with 200~400nm in diameter in PVC continuous phase.Better mechanical properties can be achieved by using nano-CaCO3 combined with ACR. Nano-CaCO3 also did well in improving the properties of toughened PVC.

将nano-CaCO_3与ACR抗冲改性剂配合使用能使PVC具有较高的力学性能。nano-CaCO_3含量为15份、ACR含量为6份时，材料的冲击强度达到 74.5KJm~2，同时，nano-CaCO_3还弥补了 ACR对PVC刚性和热变形性的不良影响。

During the course of experimentation the order of charging、the superheating temperature of aluminum melt、the temperature of holding、stirring and etc will be researched, who will affect the absorptivity of the elements in the master alloy Al-Ti-B-Re, and who will affect the shape、size and the distribution of the second phase; It will also be researched that the effect of the rear-earth to the declining of refiner、to the remelting property and to the refining property.

在实验中主要探讨了加料次序、熔体过热温度、静置温度、搅拌等工艺参数对Al-Ti-B-Re中间合金中各种元素吸收率的影响，对Al-Ti-B-Re中间合金组织中第二相形态、尺寸、分布及细化效果的影响；稀土元素对细化剂抗衰减性的影响，对细化剂重熔性能和重熔后细化性能的影响。

The comparison between thermal and fast ADS demonstrate that the fast ADS has large power output, less minor actinide production and small fission products poisoning effect compared with thermal system.

从快堆和热堆的比较可知，ADS的快堆具有输出功率大、长寿命超铀放射性废物的累积水平低、裂变产物对反应堆反应性和能量增益影响小等优点。

Mathematics model of hysteresis loops and calculation formula of hysteresis energy for Masing and non-Masing material were established.

本文针对我国广泛使用的16MnR压力容器用钢焊接接头，从焊接接头材质和力学不均匀性的实际出发，首次分别系统地对焊缝、热影响区和母材进行了低周疲劳实验研究，求得各分区的循环滞回环及其特征参数，建立了Masing材料和非Masing材料的滞回环数学模型和滞回能计算公式。

Theoretical analysis reveals that the formation of flower-like splats results from the interaction of surface tension, inhomogeneity of thermal contact resistance between flattening drop and substrate and substrate crater. The formation of the craters on the substrate is mainly controlled by substrate melting.

理论分析表明，&花瓣状&层片的形成是熔体表面张力、熔体与基底接触热阻的不均匀性和基底凹坑相互作用的结果；基底凹坑的形成主要由基底熔化所控制。

With the same of characteristics between solid and porous microchannel evaporator, that pressure drop rises with the increase of volume flow rate and heat flux, the latter's pressure drop will rise up around 30% to 260% as porosity increases.

在压降方面，相较於传统微流道蒸发器压降除了随著流量以及热通量的增加而上升外，多孔性结构微流道蒸发器的压降也会随孔隙度的增加而上升。

The shell- and- tube heat exchanger of the tube plate and tube connecting the close of the quality is an important point.

管壳式换热器的管板和管子连接处的紧密性是一重要的质量点。

Method］ Observe its influence on the pain tolerance of mouse hot plate method, on mouse ear swelling caused by xylene, on the cut-tail blood time of mouse, and on rats' hemoglutination platelet collection.

方法］观察对小鼠热板法痛阈值的影响；对二甲苯所致小鼠耳廓肿胀的影响；对小鼠断尾出血时间的影响；对大鼠凝血机能及血小板凝集性的影响。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。